Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed
125 Pages « < 55 56 57 58 59 > » Bottom

Outline · [ Standard ] · Linear+

 LYN Proton Saga/Iswara Drivers' Forum! V22, For all those SagaIswara Enthusiast

views
     
sinister_sid
post Oct 13 2010, 11:08 PM

New Member
*
Junior Member
12 posts

Joined: Sep 2010
From: Subang Jaya


QUOTE(rozz_1291 @ Oct 13 2010, 10:54 PM)
Pls avoid using those so-called swirling bullets. To me its bullsheet. The whole point of putting a center bullet/box/resonator is to resonate the sound and vibration cause from the cylinder detonation. It acts more like a sponge or dampener around the piping.

Those swirling dimples inside the bullet will cause more restriction to ur exhaust gases flow compare to stock setup.

I would recommend u to use back ur stock size piping+mandrel bend tuned length extractor+bullet/resonator (if u 1 it to be more silence) and a suitable rear muffler (inlet<2", outlet<3") maybe??? Following ur liking.

using back stock piping is to keep the heat inside the piping for a better and smoother flow (unless ur running on Fi) sleep.gif
*
sifu !!!! notworthy.gif ,notworthy.gif ,notworthy.gif



xian_kgx
post Oct 13 2010, 11:38 PM

Getting Started
**
Junior Member
189 posts

Joined: Aug 2005
From: Cheras, KL <-> Skudai, JB


Hey all Saga/Saga Iswara users.

I might want to get a Saga VR4. Is maintaining the Saga difficult? Is spare parts especially the interior easy? Things like front lamp, rear lamp, doors, bumper, bonet, is it easy to get replacement?

How about wear and tear parts like drive shaft, gear box, clutch, clutch pump and others, can I get spare parts easily from spare part shops?
GMS FearLess
post Oct 13 2010, 11:49 PM

Getting Started
**
Junior Member
178 posts

Joined: May 2009
From: in thes lulz



QUOTE(xian_kgx @ Oct 13 2010, 11:38 PM)
Hey all Saga/Saga Iswara users.

I might want to get a Saga VR4. Is maintaining the Saga difficult? Is spare parts especially the interior easy? Things like front lamp, rear lamp, doors, bumper, bonet, is it easy to get replacement?

How about wear and tear parts like drive shaft, gear box, clutch, clutch pump and others, can I get spare parts easily from spare part shops?
*
maintaining.....no...easy as ABC if you have basic....
sparepart...interior & xterior....easy to find
engine part.....easy to find if you know lubang2nya
xian_kgx
post Oct 14 2010, 12:19 AM

Getting Started
**
Junior Member
189 posts

Joined: Aug 2005
From: Cheras, KL <-> Skudai, JB


QUOTE(GMS FearLess @ Oct 13 2010, 11:49 PM)
maintaining.....no...easy as ABC if you have basic....
sparepart...interior & xterior....easy to find
engine part.....easy to find if you know lubang2nya
*
Parts of the dashboard, dashboard meter, air cond panel, door trims, power window motor, all can get easily?
GMS FearLess
post Oct 14 2010, 12:24 AM

Getting Started
**
Junior Member
178 posts

Joined: May 2009
From: in thes lulz



QUOTE(xian_kgx @ Oct 14 2010, 12:19 AM)
Parts of the dashboard, dashboard meter, air cond panel, door trims, power window motor, all can get easily?
*
just hard to find is dashboard meter and door trim...if you lucky and smart..can find in lowyat garage sale.mudah.my and sagaiswaraclub.com under garage sale.....
motor power window easy to find....


you stay at skudai.JB??

This post has been edited by GMS FearLess: Oct 14 2010, 12:32 AM
the_catacombs
post Oct 14 2010, 12:47 AM

8 stars wooo....
********
Senior Member
10,975 posts

Joined: Jan 2003
From: disini disana


QUOTE(rozz_1291 @ Oct 13 2010, 10:54 PM)
Pls avoid using those so-called swirling bullets. To me its bullsheet. The whole point of putting a center bullet/box/resonator is to resonate the sound and vibration cause from the cylinder detonation. It acts more like a sponge or dampener around the piping.

Those swirling dimples inside the bullet will cause more restriction to ur exhaust gases flow compare to stock setup.

I would recommend u to use back ur stock size piping+mandrel bend tuned length extractor+bullet/resonator (if u 1 it to be more silence) and a suitable rear muffler (inlet<2", outlet<3") maybe??? Following ur liking.

using back stock piping is to keep the heat inside the piping for a better and smoother flow (unless ur running on Fi) sleep.gif
*
sifu notworthy.gif

QUOTE(xian_kgx @ Oct 13 2010, 11:38 PM)
Hey all Saga/Saga Iswara users.

I might want to get a Saga VR4. Is maintaining the Saga difficult? Is spare parts especially the interior easy? Things like front lamp, rear lamp, doors, bumper, bonet, is it easy to get replacement?

How about wear and tear parts like drive shaft, gear box, clutch, clutch pump and others, can I get spare parts easily from spare part shops?
*
yes difficult... especially maintain fake alien power engine... dun believe ask zaini... engine jatuh also dunno what happen... laugh.gif
TSrozz_1291
post Oct 14 2010, 03:43 AM

Semi N/A
*****
Senior Member
861 posts

Joined: Dec 2007
From: Bangsar


QUOTE(the_catacombs @ Oct 14 2010, 12:47 AM)
sifu  notworthy.gif
yes difficult... especially maintain fake alien power engine... dun believe ask zaini... engine jatuh also dunno what happen...  laugh.gif
*
Apa sifu2???

At least can tapau ur car maa... tongue.gif Engine drop or wat so ever 1.5bar tahan lg wei... still can bring me back home in 1 piece sleep.gif
xian_kgx
post Oct 14 2010, 06:00 AM

Getting Started
**
Junior Member
189 posts

Joined: Aug 2005
From: Cheras, KL <-> Skudai, JB


QUOTE(the_catacombs @ Oct 14 2010, 12:47 AM)
sifu   notworthy.gif
yes difficult... especially maintain fake alien power engine... dun believe ask zaini... engine jatuh also dunno what happen...  laugh.gif
*
I'm more interested in maintaining the car body exterior and interior. Engine can run then ok la, later swap engine to my Satria. brows.gif


Added on October 14, 2010, 6:02 amBut Saga body, is it strong? Compared to Wira, which is better? The thing I don't like is the body parts can rust easily and cannot change it, especially the roof, since it is one piece with the body?

This post has been edited by xian_kgx: Oct 14 2010, 06:02 AM
sinister_sid
post Oct 14 2010, 07:56 AM

New Member
*
Junior Member
12 posts

Joined: Sep 2010
From: Subang Jaya


QUOTE(xian_kgx @ Oct 14 2010, 06:00 AM)
I'm more interested in maintaining the car body exterior and interior. Engine can run then ok la, later swap engine to my Satria.  brows.gif


Added on October 14, 2010, 6:02 amBut Saga body, is it strong? Compared to Wira, which is better? The thing I don't like is the body parts can rust easily and cannot change it, especially the roof, since it is one piece with the body?
*
No, Maintaining A Stock Saga Wont Cost A Bomb
If U Modified It Heavily Then What Car Olso Maintainence Expensive Lo doh.gif

Who Say Saga Body Not Strong
I Ketuk Ur Head
Ask Taxi Driver See They Prefer Saga Or Wira thumbup.gif
How To Compare As Saga Is More Old Than Wira
As Saga Chasis Was Design In Late 70's And Wira Was Late 80's
Contary Of Believe That Our Car Was Made Out 1 KETUL
Our Car Is Manufacture With Pieces Of Stamped Metal And Were Welded Together
So If The Roof Is Rust
The Paint Shop Just Remove The Roof By Removing The Welding And The Roof Came Out 1 Pieces
Abit Like LEGO lo
Door And Hood Can Change Easily Ma
Smart Abit Lo When Buying 1
Dun Buy 1 That Is A Rust Bucket Like Mine doh.gif

Vr4 In Saga ????
Its Cool If The Former Owner's Forman And Your Forman Is Award Winning
If Not Habis Lo doh.gif

Interior And Exterior Parts Of Stock Saga Are Not Hard To Find
If U Wan To Convert Fiore Onli Then The Parts Hard To Find

This post has been edited by sinister_sid: Oct 14 2010, 08:03 AM
blinkk
post Oct 14 2010, 09:08 AM

New Member
*
Newbie
0 posts

Joined: May 2009
hai all..im using 4g13carb,juz wondering,rm30 (ron97) can go to 170km,is it ok ar?
yewwing
post Oct 14 2010, 09:52 AM

Casual
***
Junior Member
392 posts

Joined: Sep 2007
From: Some where in Malaysia



QUOTE(blinkk @ Oct 14 2010, 09:08 AM)
hai all..im using 4g13carb,juz wondering,rm30 (ron97) can go to 170km,is it ok ar?
*
nod.gif nod.gif very good fuel efficient already

This post has been edited by yewwing: Oct 14 2010, 09:52 AM
blinkk
post Oct 14 2010, 11:08 AM

New Member
*
Newbie
0 posts

Joined: May 2009
QUOTE(yewwing @ Oct 14 2010, 09:52 AM)
nod.gif  nod.gif very good fuel efficient already
*
really?hehe i juz wanna compare wif other 4g13carb coz i feel like mine is bad fuel eco..
yewwing
post Oct 14 2010, 01:20 PM

Casual
***
Junior Member
392 posts

Joined: Sep 2007
From: Some where in Malaysia



QUOTE(blinkk @ Oct 14 2010, 11:08 AM)
really?hehe i juz wanna compare wif other 4g13carb coz i feel like mine is bad fuel eco..
*
if u compare with me, your car is better coz i only get 20 cents per km sad.gif
Chan320
post Oct 14 2010, 05:27 PM

Getting Started
**
Junior Member
113 posts

Joined: Nov 2008


Depend on how you drive only,my 4G13 crab can reach 530km on full tank but sometimes 480 nia haha....


Added on October 14, 2010, 5:27 pmWanna ask how much does an Iswara body weight?including all acc and engine?

This post has been edited by Chan320: Oct 14 2010, 05:27 PM
blinkk
post Oct 14 2010, 06:02 PM

New Member
*
Newbie
0 posts

Joined: May 2009
QUOTE(yewwing @ Oct 14 2010, 01:20 PM)
if u compare with me, your car is better coz i only get 20 cents per km  sad.gif
*
really?how to kira? math aku slow sket biggrin.gif


Added on October 14, 2010, 6:03 pm
QUOTE(Chan320 @ Oct 14 2010, 05:27 PM)
Depend on how you drive only,my 4G13 crab can reach 530km on  full tank but sometimes 480 nia haha....


Added on October 14, 2010, 5:27 pmWanna ask how much does an Iswara body weight?including all acc and engine?
*
im juz normal driving bro wif aircon biggrin.gif


This post has been edited by blinkk: Oct 14 2010, 06:03 PM
pitywoman
post Oct 14 2010, 07:23 PM

Casual
***
Junior Member
484 posts

Joined: Dec 2009
stock engine after service now getting better fc, previously i think around rm35 for 300km, but now maybe around 25-30 for 300km. not really counted it but based on my obersvation on rm20 i can travel b from home to company for 4 days which previously i cant.
Chan320
post Oct 14 2010, 08:56 PM

Getting Started
**
Junior Member
113 posts

Joined: Nov 2008



im juz normal driving bro wif aircon biggrin.gif
*

[/quote]

same here bro,only at night open window nia biggrin.gif
idunnolol
post Oct 14 2010, 10:13 PM

Regular
******
Senior Member
1,044 posts

Joined: Jun 2008
QUOTE(pitywoman @ Oct 14 2010, 07:23 PM)
stock engine after service now getting better fc, previously i think around rm35 for 300km, but now maybe around 25-30 for 300km. not really counted it but based on my obersvation on rm20 i can travel b from home to company for 4 days which previously i cant.
*
Urs is carb or injection? My injection only can go 120 KM for RM 30. Is there something wrong?
yewwing
post Oct 14 2010, 10:37 PM

Casual
***
Junior Member
392 posts

Joined: Sep 2007
From: Some where in Malaysia



QUOTE(idunnolol @ Oct 14 2010, 10:13 PM)
Urs is carb or injection? My injection only can go 120 KM for RM 30. Is there something wrong?
*
shocking.gif shocking.gif ur car turbo ar...??
sinister_sid
post Oct 14 2010, 11:08 PM

New Member
*
Junior Member
12 posts

Joined: Sep 2010
From: Subang Jaya


QUOTE(yewwing @ Oct 14 2010, 10:37 PM)
shocking.gif  shocking.gif ur car turbo ar...??
*
thumbup.gif


125 Pages « < 55 56 57 58 59 > » Top
Topic ClosedOptions
 

Change to:
| Lo-Fi Version
0.0248sec    0.64    6 queries    GZIP Disabled
Time is now: 10th December 2025 - 08:03 PM