yup..it use 4 pin molex...

how many?

just one...it doesnt consume too much power though..

ohya how much is PSU sleeving service?

Cable management on anything above a typical RM 1xx CM casing is not going to be an issue. However, that's not real cable management on the Sniper. That's black stationary board covering the cables

What material is that board ? Normally I see people use acrylic for theose purposes...

Thats a black manilla card with cutouts.

Sound proof foam.

That does not look like a card. I still remember yuktsi talk bout that foam years ago.

Oh yeah.. can I see the other side of the casing? how you place the cables behind.. tx

Oh and this mod..
http://forum.coolermaster.com/viewtopic.php?f=49&t=15008

What do people use to paint case/GPU like in that mod?

Which to go CM storm enforcer or Corsair 600t white? building new rig. I7-3770K, 3 old harddisk swap over from 1st generation CM 690. TQ

I would choose the corsair 600T over the storm enforcer simply because i like the exterior look of it. Read up some review about both case to make up your decision.

Corsair 600T white is an awesome looking case

Yup, quite a good looking mid tower.

sweet mother of awesomeness

---

Added on July 13, 2012, 8:44 pmWhat paint can I use to paint my interior? I feel like giving my Hard drive cage a white colour.. But paint as I know can cause heat ._. And what 140mm fan is recommended? I wanna use one as intake. quiet and preferably has blue LED

This post has been edited by BenSow: Jul 13 2012, 08:44 PM

Powder coat. Or any paint that can give matte finish. Paint can cause heat? Not sure about it.

Powder coat HDD cage only how much

Not sure. There are a few people here that provide this service. Do PM them for quotation.
http://forum.lowyat.net/index.php?showtopi...&hl=powder+coat
http://forum.lowyat.net/index.php?showtopi...&hl=powder+coat
There is another one, i think he provide the most cheaper rate. Couldn't find his thread.

Any other way like DIY? Will normal white spray paint do the job?

BTW I'm arranging my cables right now any precaution needed to take when tucking cable behind mobo tray? Touch the pins on mobo ok one right

You can DIY, but the result depends whether you will done it right. Use those normal spray can, need to apply a few layers tho.
Don't bend the cables too hard. Use zip tie if possible. Just to be safe don't let any exposed pins touch any parts.

exposed pins of the motherboard? that's pretty hard when you tuck the cables behind it ><

---

Added on July 14, 2012, 2:28 pmJust now lunch suddenly thought "what if i paint it white?"
Got into photoshop and edited it's promo photo and this came out.. lol


This post has been edited by BenSow: Jul 14 2012, 02:28 PM