Don't bet ur life on that dual bios thingy, for me its all for show, my cousin kaput his MA770T-UD3P recently due to problem in flashing his bios..
In the manual it says that it will automatically uses the 2nd bios if problem with the 1st but it never did..  

previously acc done via hw (sb710/750) support + inclusion of older microcode in bios. newer core unlockin done either via hw switch or bios. imo newer method save u some headaches coz u dun need to deal w/ acc (for diff cores). from d results, i can say d newer way give slightly better mileage. 

distro always by your side no worries

I cant boot with my new setup. it says that "BOOT MANAGER IS MISSING". I guess have to install fresh copy of window. I'll do it tomoro.

ASUS Develops Own Technology to Rival AMD Turbo Core and Intel Turbo Boost
ASUS designed its own technology comparable to AMD's Turbo Core, the ASUS Turbo Unlocker. The technology is claimed to be more advantageous than Turbo Core, since it sends every core into Boost state, rather than a limited number of cores designated as turbo cores. What's more, it supports several other Phenom II Black Edition series processors other than those based on the six-core Thuban or the quad-core Zosma. With single-threaded loads, the active core is given the maximum boost in clock speeds, while as multi-threaded load increases, even more number of cores enter a boost state. Boost state speeds decrease with increase in number of active cores. The technology is available on ASUS' entire range of motherboards based on the AMD 8-series chipsets. Details follow in a presentation by ASUS. It would be interesting to see if ASUS goes a step further and works out Turbo Unlocker for Intel Corei3 processors.

Donno u guys read about this or not 




Sauce Tiram Kicap Kipas Udang

Good move for ahsus trying to make something different from the rest, but it does make u wonder if it would make OC'ing a nightmare later on 
Notice that even the normal deneb black editions also supported..   

just come back fr lowyat n some shop selling x6 thuban d... x6 1055T rm655, 1090T BE have to ask. so i didn't ask 

woa..quite reasonable  y u dont ask bro? maybe only diff around rm100+- for BE 

manage to repair my window. hehe. cant oc rite now, using cap ayam psu only. have to wait for my psu to come back from rma 1st.

currently, i'm using psu that didnt have 8 pin power (so i put the 4 pin into the 8 pin socket). i'm running basic thing only. hope everything goes fine. 

I heard the 1090T is selling for RM999 at cycom

---

Added on April 20, 2010, 8:39 pm

How come ur corsair psu need to be RMA? Got struck by lightning ka?   

  OFFTOPIC

the 8 pin socket got prob. dont know how it happen. 
later want to try that modded bios given by xixo. but have to wait till my psu comeback. huhu

woa corsair spoiled?  what just happen? whats wrong with ur 8 pin connector?

before this i was using pII 940 with dfi dk790. then i sold it. the psu was ok. after i bought i3, the system wont boot. it run for a few second, then shutdown. after testing 9-10 times, i conclude that it was the psu. same prob happen when i plug in & didnt plug in the 8 pin connector. huhu. now have to wait for it. till then, cant oc.

which corsair PSU u use? is it becoz of ur house voltage / ur extension wire not good? 

my 1st oc after changing to new psu
prime for 1/3 hours stable with 46c idle & 62c load, is my temp is normal or a bit hot?

just come back fr lowyat n some shop selling x6 thuban d... x6 1055T rm655, 1090T BE have to ask. so i didn't ask 

I heard the 1090T is selling for RM999 at cycom

@azilazwa
hye bro.. where did u see the crosshair 4 for rm895 ?

temp under 66c is optimal for phenom    btw last time with that volt i can prime stable on 3.6ghz.. maybe u can try tweak ur NB speed and volt to make ur proc stable on low voltage