wow nice OC thr, using the 95watter thuban eh?

He's not using 95watter thuban only 125watter

it's really need 1.5v..

Can't say much i think, limitation of the 45nm process i think

Hi..I just bought a Phenom II X4 955 BE with 3.2GHz for starters..my mobo is the Gigabyte GA-MA770T-UD3P..I have downloaded the AMD Overdrive, what else do I need? Newbie here (:

What do u want to do with it? If u wanna try oc get urself a good cooler then read the guides at the 1st page of this thread
If u have any difficulties or anything that isn't clear after reading the guide, post it here and the sifoo's would gladly help

I've read a few..but didn't found one about using AMD Overdrive but I've downloaded it already. Don't really know how to use. I want to push it a little further till maybe 3.8GHz. Using a Hyper 212 Plus now

tweaking from the bios is the best way

not me leh bro, it's my fren who is currently playin w/ d chip...

yup bro, unfortunately it needs 1.5xv for > 4.1GHz prime stable, but this is definitely better than d predecessor where they need alot more volt for same clock while havin 2 less cores. not a drastical improvement but a welcome one for sure.

i always use AOD for voltage tuning only, most of d time it's done at last stage where i wanna reduce d volt of finalized oc'ed setup. for start u can just play w/ cpu & cpu-nb multi (a 'lil) while leavin d rest (ram & ht link freq) untouched.

it's not a must to use AOD coz how well it works really differ from board to board. iirc, cpu multi adjsut worked pretty well for my ex 790fxt, but make sure u increase d volt 1st b4 messin w/ cpu clock. bro cloudwan used to own this board, he mite be d perfect yoda to guide u.

This post has been edited by ah_khoo: Jul 4 2010, 10:30 PM

Mind telling it in more english..? lol

---

Added on July 4, 2010, 10:39 pmI played the multiplayer to 16.5x by using Performance Control> Novice Mode to level 1.

This post has been edited by clon12: Jul 4 2010, 10:39 PM

Ur playing in the bios or using AOD meh? Most of us would say play2 oc'ing in the bios 1st, use AOD only to fine tune a bit..
As ah_khoo said play with the cpu multi & the cpu volt 1st b4 learn to play2 with everything else

Alright. I will test it right after I came back from my school. If I OVER-did the oc, would the system bootup? And what are the limit voltage I have to keep an eye on? 1.5V?

Also, did you mean I just play with the multiplier instead of the bus speed?

No meletup system..highly just will not b able to boot..

Try to limit volts <1.5

So the system wont go blow off..if it wont boot I just go back to BIOS and lower the multiplier down? (:

Either the System will reset for you OR you have to clear the CMOS by yourself

No boom or whatsoever..

Try using these settings, oc milage may vary but u can use it as a guideline ah:
Disregard the ram's settings tho, just leave ur ram at stock setting..

For Prime95, if using CPU Tweaker, set the tFAW to 30