Outline ·
[ Standard ] ·
Linear+
★★★ PROTON WAJA Club - LYN V7 ★★★
|
WhitE LighteR
|
Mar 3 2010, 03:14 AM
|
|
I just finish DIY the rubber strip around my door n boot area.. sound wind reduce but still there coming from the A pillar.. totally damn annoying. Im goin to take a look at it again. Coz i think its not sufficient to stick it around the rubber seal. I need to stop the wind before it gets into the gab of the door.... the battles continue tomoro....
|
|
|
|
|
|
swk_sam
|
Mar 3 2010, 08:48 AM
|
New Member
|
QUOTE(liette` @ Mar 3 2010, 12:03 AM) eh i dont think u got wat i meant lol. i mean standard stock car have: extractor --> cat con--> mid box-->pipe--->muffler so lets say i remove cat con n replace wit another mid box den my setup would be: extractor--->midbox-->midbox--->pipe--->muffler is that right? anyone can confirm this? Change to 4-2-1 extractor & replace cat-con with twist bullet... not midbox.. other keep stock  The setup for Waja AT is more than enough  QUOTE(PowerSlide @ Mar 3 2010, 12:31 AM) learn a new thing today from you..thanks..will check mine out  Just sharing  I also learn from my mech This post has been edited by swk_sam: Mar 3 2010, 08:49 AM
|
|
|
|
|
|
jags
|
Mar 3 2010, 09:07 AM
|
Getting Started

|
hi guys, My steering wheel always vibrate when i leave the gear at D and step on the brakes (i know its a bad habit  ). When I change to N, then it doesn't vibrate. I already change the engine mounting, and there is some improvement. However it still vibrates when the fan kicks in. Would appreciate any help.
|
|
|
|
|
|
tjroy
|
Mar 3 2010, 10:50 AM
|
New Member
|
QUOTE(jags @ Mar 3 2010, 09:07 AM) hi guys, My steering wheel always vibrate when i leave the gear at D and step on the brakes (i know its a bad habit  ). When I change to N, then it doesn't vibrate. I already change the engine mounting, and there is some improvement. However it still vibrates when the fan kicks in. Would appreciate any help. i dont think is when the fan kicks in, is the compressor, how many mountings u changed?
|
|
|
|
|
|
swk_sam
|
Mar 3 2010, 10:52 AM
|
New Member
|
QUOTE(jags @ Mar 3 2010, 09:07 AM) hi guys, My steering wheel always vibrate when i leave the gear at D and step on the brakes (i know its a bad habit  ). When I change to N, then it doesn't vibrate. I already change the engine mounting, and there is some improvement. However it still vibrates when the fan kicks in. Would appreciate any help. Its normal for steering slightly vibrate if u leave your gear at D while the air con kicks when not moving.
|
|
|
|
|
|
b48753
|
Mar 3 2010, 10:54 AM
|
|
swk_sam, where did you brought Sachs absorber? Recommend me the shop you brought it.
|
|
|
|
|
|
jags
|
Mar 3 2010, 11:14 AM
|
Getting Started

|
I already change all the mountings. Yeah, I think its the compressor QUOTE(tjroy @ Mar 3 2010, 10:50 AM) i dont think is when the fan kicks in, is the compressor, how many mountings u changed? Added on March 3, 2010, 11:16 amI don't expect it to be silent, but I think its a bit excessive. Will compare it with my friends waja when i meet him. QUOTE(swk_sam @ Mar 3 2010, 10:52 AM) Its normal for steering slightly vibrate if u leave your gear at D while the air con kicks when not moving. This post has been edited by jags: Mar 3 2010, 11:16 AM
|
|
|
|
|
|
liette`
|
Mar 3 2010, 11:32 AM
|
|
QUOTE(swk_sam @ Mar 3 2010, 08:48 AM) Change to 4-2-1 extractor & replace cat-con with twist bullet... not midbox.. other keep stock  The setup for Waja AT is more than enough  thanks for the reply! will do just that!
|
|
|
|
|
|
swk_sam
|
Mar 3 2010, 11:43 AM
|
New Member
|
QUOTE(b48753 @ Mar 3 2010, 10:54 AM) swk_sam, where did you brought Sachs absorber? Recommend me the shop you brought it. The shop is beside Petronas Damai Perdana with yellow shop name board "CONTINENTAL". Actual shop name is Maystorm tyre service center. Its come with half year 1 to 1 exchange warranty.  Here is the MAP. This post has been edited by swk_sam: Mar 3 2010, 11:54 AM
|
|
|
|
|
|
liette`
|
Mar 3 2010, 11:54 AM
|
|
oh yeah btw, my waja 1.6A 4g18 only gives me 200km for about RM50 of petrol. is this normal or.. ? =/ sometimes i like to step on accelerator alot.
|
|
|
|
|
|
swk_sam
|
Mar 3 2010, 12:01 PM
|
New Member
|
QUOTE(liette` @ Mar 3 2010, 11:54 AM) oh yeah btw, my waja 1.6A 4g18 only gives me 200km for about RM50 of petrol. is this normal or.. ? =/ sometimes i like to step on accelerator alot. Its normal for heavy foot driver  RM90+ can go 400+km for heavy footer... If idle with engine start, fc will become worst... I tried before with idle a lot end up RM90+ get 300+km only ..
|
|
|
|
|
|
liette`
|
Mar 3 2010, 12:02 PM
|
|
QUOTE(swk_sam @ Mar 3 2010, 12:01 PM) Its normal for heavy foot driver  RM90+ can go 400+km for heavy footer... If idle with engine start, fc will become worst... I tried before with idle a lot end up RM90+ get 300+km only ..  haha actually if always around 2.8k-3.3k rpm, is it considered heavy foot ah? This post has been edited by liette`: Mar 3 2010, 12:03 PM
|
|
|
|
|
|
swk_sam
|
Mar 3 2010, 12:11 PM
|
New Member
|
Rev a lot also count as heavy footer... Just smooth driving style only light foot
|
|
|
|
|
|
liette`
|
Mar 3 2010, 12:14 PM
|
|
QUOTE(swk_sam @ Mar 3 2010, 12:11 PM) Rev a lot also count as heavy footer... Just smooth driving style only light foot  yeah, everytime red light change to green, rev alot. o_o should change abit.
|
|
|
|
|
|
WhitE LighteR
|
Mar 3 2010, 12:15 PM
|
|
 wth is this wind noise coming from la  anyone has any idea? side mirror maybe?
|
|
|
|
|
|
swk_sam
|
Mar 3 2010, 12:28 PM
|
New Member
|
QUOTE(WhitE LighteR @ Mar 3 2010, 12:15 PM)  wth is this wind noise coming from la  anyone has any idea? side mirror maybe? U shud ask your friend to drive at highway & u try to find out where the wind coming from..
|
|
|
|
|
|
PowerSlide
|
Mar 3 2010, 01:01 PM
|
|
swk_sam, sharing is caring  but its good to share some knowledge mine RM60 can go 300KM++ only..but town driving are really thirsty..tried all brand ron95 only caltex give good mileage
|
|
|
|
|
|
InfinityX
|
Mar 3 2010, 01:20 PM
|
New Member
|
QUOTE(b48753 @ Mar 3 2010, 10:54 AM) swk_sam, where did you brought Sachs absorber? Recommend me the shop you brought it. I brought mine wif a bro from LYN, his nick is Kobe10. I brought it at RM440 for front and rear, but u nid to find a workshop to install for with additional charges la..
|
|
|
|
|
|
WhitE LighteR
|
Mar 3 2010, 03:07 PM
|
|
FML, 130 gone fix power window motor... then i ask for quote for wiper linkage kena 185
|
|
|
|
|
|
b48753
|
Mar 3 2010, 03:12 PM
|
|
QUOTE(swk_sam @ Mar 3 2010, 11:43 AM) The shop is beside Petronas Damai Perdana with yellow shop name board "CONTINENTAL". Actual shop name is Maystorm tyre service center. Its come with half year 1 to 1 exchange warranty.  Here is the MAP.  Does the shop near to MRR2?Coz looking at the map further nothern is Taman Len Sen.
|
|
|
|
|