~LY.Net Honda City Enthusiast Club~ V5
~LY.Net Honda City Enthusiast Club~ V5
|
|
Jan 20 2012, 04:12 AM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,664 posts Joined: Jan 2003 From: Ipoh |
lol.. a little too tech for me to answer, wait for other sifu's
|
|
|
|
|
|
Jan 20 2012, 09:06 AM
|
![]() ![]() ![]() ![]()
Senior Member
644 posts Joined: Aug 2005 |
QUOTE(neato4u @ Nov 26 2011, 10:48 PM) I believe if you installed an aftermarket car alarm that 'failed' to work properly, you should go back to the shop which you bought and get them to check. About the CVT gear oil, mine approx. 140 + 20 labour cost ==> 160 only... RM285 really kena chopped d.Afterall, these devices have warranty. So maybe it's spoiled or not properly configured. Added on November 26, 2011, 10:53 pm You mean the CVTF gear oil? RM285 including labour?? TOTAL RIP OFF.. Shop near my place (PJ) selling for RM160 - RM190 including labour (can't remember the exact price.. ) heck, even that I feel expensive .. bcoz I've bought one before and I remember it being cheaper.. but can't remember from where bought already.. Unless.. you know.. they wanted to 'flush' it out with 2 bottles of CVTF, then you're actually paying for 2 bottles not 1 |
|
|
Jan 27 2012, 01:55 AM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,664 posts Joined: Jan 2003 From: Ipoh |
|
|
|
Jan 27 2012, 08:29 AM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
2,511 posts Joined: Jan 2003 From: Earth |
Hi guys, i want to buy modulo bodykit for my city..went to a shop in setapak, abs material rm1150 painting n installation included..the shop says it uses silicon sealant/injection to install..the shop is Steady car cushion & auto accessories..
Any comments or other recommendations? Thanks |
|
|
Jan 28 2012, 05:30 PM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
4,717 posts Joined: Jan 2003 |
i have the same problem...
when SC check... it was a simple problem...the connection went loose...so they just reconnect back and the beep comes back...haha... QUOTE(Trony @ Jan 17 2012, 11:03 AM) Hi, Any sifu here please help, my Honda City I-DSI Y2003 gave me the 1st hiccup after all these years The reverse sensor's buzzer stop making beep suddenly, totally dead & not intermittent, my questions are: 1. Is it sensor or buzzer kaput? 2. Where is the buzzer located? inside the dashboard? how to disassemble it for replacement? 3. If sensor kaput, how to remove it for replacement. Thanks. |
|
|
Jan 28 2012, 08:36 PM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,583 posts Joined: Mar 2007 From: KEPONG |
Oldies here
|
|
|
|
|
|
Jan 30 2012, 12:46 AM
|
![]() ![]()
Junior Member
104 posts Joined: Oct 2007 |
hi anyone knows what happened to the service center in jalan 222? where did they move to?
|
|
|
Jan 30 2012, 05:14 PM
|
![]() ![]()
Junior Member
274 posts Joined: Jun 2008 |
So when is the new Honda City Facelift 2012 launching in Malaysia?
|
|
|
Feb 4 2012, 10:08 AM
|
![]() ![]()
Junior Member
96 posts Joined: Dec 2010 From: The Grid |
QUOTE(kevyeoh @ Jan 28 2012, 05:30 PM) i have the same problem... Thanks, but my buzzer just came back working last week by it's own, totally alive & not intermittent, weird huh! when SC check... it was a simple problem...the connection went loose...so they just reconnect back and the beep comes back...haha... QUOTE(Trony @ Jan 17 2012, 11:03 AM) Hi, Any sifu here please help, my Honda City I-DSI Y2003 gave me the 1st hiccup after all these years The reverse sensor's buzzer stop making beep suddenly, totally dead & not intermittent, my questions are: 1. Is it sensor or buzzer kaput? 2. Where is the buzzer located? inside the dashboard? how to disassemble it for replacement? 3. If sensor kaput, how to remove it for replacement. Thanks. Just found out the buzzer is located inside the small square grill below the left side of dashboard & steering, question is how to access it, looks like big job to open the grill panel. This post has been edited by Trony: Feb 4 2012, 10:13 AM |
|
|
Feb 4 2012, 11:48 PM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,664 posts Joined: Jan 2003 From: Ipoh |
QUOTE(Trony @ Feb 4 2012, 10:08 AM) Thanks, but my buzzer just came back working last week by it's own, totally alive & not intermittent, weird huh! Similar thing happened to me..Just found out the buzzer is located inside the small square grill below the left side of dashboard & steering, question is how to access it, looks like big job to open the grill panel. Sometimes my AC light will not turn on, and there's one occasion where I thought my gearbox is gone for sure but after several days (lucky I was busy) before sending it over to workshop, everything works OK again. Some told me to check my ECU, but I'll just leave em alone.. as long as it's working back again, there's no reason for me to bother it so much. Just make sure you service the car well and you will be fine. This post has been edited by neato4u: Feb 4 2012, 11:49 PM |
|
|
Feb 6 2012, 06:44 AM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,680 posts Joined: Jan 2003 From: Cyberjaya |
QUOTE(neato4u @ Feb 4 2012, 11:48 PM) Similar thing happened to me.. tats jz the LED gone....smtm is gone for good...smtm its jz not "connected"Sometimes my AC light will not turn on, and there's one occasion where I thought my gearbox is gone for sure but after several days (lucky I was busy) before sending it over to workshop, everything works OK again. jz let it be.....most of the old owner has it.... |
|
|
Feb 6 2012, 10:29 PM
|
![]()
Newbie
3 posts Joined: Sep 2011 |
this morning, i checked my mom's city vtec 2007, (the previous version before the current one, one of the last facelifts), i saw the engine bay was so dirty, i however noticed that the bottom of the engine bay are empty as i can see the floor below.
aren't city equipped with the plastic bottom engine cover? i suspect the SC didnt put it back and so the engine bay got so dirty.. can anyone verify me wether the honda city of this type are equipped with the said cover. thanks |
|
|
Feb 7 2012, 04:17 PM
|
![]() ![]()
Junior Member
76 posts Joined: Jan 2011 |
I have 2 issue with my City 2011 - lower spec.
1) Spring is very hard, keep bouncing/jumping on the road. 2) When speeding on highway or making turn on high speed, the car felt like want to fly away, too light / feel like floating. Do you have this issue? How to solve? |
|
|
|
|
|
Feb 7 2012, 06:00 PM
|
![]()
Junior Member
5 posts Joined: Dec 2011 |
Anyone knows when the next new model of Honda City will be launch?
|
|
|
Feb 8 2012, 11:49 AM
|
![]()
Junior Member
15 posts Joined: Oct 2007 From: KK |
|
|
|
Feb 8 2012, 07:32 PM
|
![]() ![]() ![]() ![]() ![]()
Senior Member
772 posts Joined: Jan 2003 From: Bkt Jalil |
Hey guys... need some advice from you.
I sent my City iDSI 2007 for 160K service today and they found out that my aircon compressor pump is "dying". In the mornings when I cold start my car, there'll be squeaky sound and initially I suspected it could be some belt problem. However to my surprise it has something to do with compressor. Does anyone has any experience on this before? I think I'm gonna get a second opinion on this. I do not want to fork out RM4000+ (the price Honda SC quoted me) and in the end the problem ain't fixed.. Any recommended aircon shops with good experience on Honda cars? |
|
|
Feb 9 2012, 10:34 AM
|
![]() ![]() ![]()
Junior Member
317 posts Joined: Dec 2009 |
|
|
|
Feb 29 2012, 11:43 PM
|
![]()
Junior Member
20 posts Joined: Oct 2008 |
Just wanna check with your guys, i have Honda City 2008 Vtec. Now I facing the problem is when i brake to slow down, my car will jerk and my RPM will go below 500 and the engine like want to die off and keep jerking even my car was stop. What is the problem and how to fix??
|
|
|
Mar 2 2012, 11:38 AM
|
![]() ![]()
Junior Member
96 posts Joined: Dec 2010 From: The Grid |
QUOTE(Pinkyhouse @ Feb 29 2012, 11:43 PM) Just wanna check with your guys, i have Honda City 2008 Vtec. Now I facing the problem is when i brake to slow down, my car will jerk and my RPM will go below 500 and the engine like want to die off and keep jerking even my car was stop. What is the problem and how to fix?? Most likely is CVT problem, better go for service check for quick fix before it's conk out because new CVT unit is damn expensive if need replacement. |
|
|
Mar 2 2012, 09:17 PM
|
![]()
Junior Member
16 posts Joined: Mar 2010 From: Puchong |
QUOTE(bookstore @ Feb 7 2012, 04:17 PM) I have 2 issue with my City 2011 - lower spec. Honda city is indeed very dissapointedly, floaty at highway.1) Spring is very hard, keep bouncing/jumping on the road. 2) When speeding on highway or making turn on high speed, the car felt like want to fly away, too light / feel like floating. Do you have this issue? How to solve? What spec is your car? 1. Modulo bodykit + 205 wide tyres is already enough to reduce or minimize the "float" feel at big highway. 2. Install Ultra racing anti roll bar to reduce the bodyroll when turning. 3. If you still want better handling, lower your car using Eibach pro-kit |
|
Topic ClosedOptions
|
| Change to: | 0.0355sec
0.63
6 queries
GZIP Disabled
Time is now: 8th December 2025 - 08:26 AM |