if painting all interior with flat black paint, much more nicer...

All that i can c is..if the PSU position is at the bottom..look like cable management can be arrange clean & tidy but if it's opposite than that..will be messy & difficult to arrange it..but surelly all it depend on RIG owner lar..

I think it's the same ,bottom psu and top, depends on the casing design, nice

casing u can just simply hide the cables behind mobo.

some how i kinda prefer the glossy look

anyway i'm trying to get mirror finish on my side panel... any personal guides?

What is that thingy u put at the bottom fan, kinda like a stand for the fan. I think this can lower fan noise in my casing.

I don't think additional stand can lower fan noise because you just added extra pieces of item to 'shake' around. Unless you also add some covering metarial like foam. I think foam will be the best material around, which I plan to cover it around my HDD, since my HDD make pretty much of 'deep' sounds...

yup,i agree with u.
me too dont think that additional stand can lower the noise.
unless,its up to ur creativity to add some sort of foam,to absorb the sound.
i believe foam is the material available to absorb sound.
correct me if im wrong.

yup, But careful not to place foam anywhere, it may obstruct with your cooling! For example if we want to cover our HDD, only cover the side that it contact with the rack, don't cover the top and buttom... Cuz if you cover them, the air won't able to flow through them...

there also people leave the foam at the back of the mobo (which come in the box probably) attached while they screw the mobo on the back tray. This is real danger cuz the heat won't able to dispatch from the back. Also, due to the heat, probably the foam will even melt or burn!

This post has been edited by M1X: Oct 13 2008, 01:37 PM

I mean, I'm using delta fan at the lower part. I tried lifting a few cm from the bottom, the sound noise greatly decrease since rite now the fan is sitting down (no screws) making a whooshing sound. Tho I'm thinking of cutting away the mesh at the bottom

Gotta do lotsa wet gosoking. And hope it's not ur lastest update.

that is actually just normal long screw which i use to level up my sanyo denki fan... if i put my fan at the bottom (without the screw) there will be minimum airflow so i decided to kinda put it up higher to get maximum airflow...

btw, the noise is madness but the airflow is around 110cfm

actually found a link at mnpctech... http://www.mnpctech.com/case-mod-paint-com...mod-how-to.html

but the amount of time and effort needed is but the result is

This post has been edited by ham_revilo: Oct 13 2008, 09:47 PM

Thw works and efforts is killing !!!

hi.. actually where can buy the flat black paint ya?

huhu at bus station jk jk go hardware shop la bro..if not find place selling paint

erm...... if i go place selling paint mayb got.. but hw to make sure that is flat black,, or flat colour paint?
any tips ya?

dude....go to any hardware shop....and look for spray paint...

on the can it will say "Flat Black"... thats how u know

oh..icic..haha, thx thn will be ez

hi guys

i'm a noob ...below is my casing



1st of all....how do guys tie all those cable ? really mess la inside my casingg

House of cacing's and snake's.

Alot thing need to do bro very messy = =