these is also depend on your budget lah....
for me i would go for mitsubishielectric - > http://www.mitsubishielectricmalaysia.com/...nd/non-inverter

even non inverter but still got built in i-see sensor for power saving.
MS-FG10VC
Cooling Capacity:
2.6kW/1HP

MS-FG13VC
Cooling Capacity:
3.2kW/1.5HP

Main Features:
• Easy Clean
• Triple Plasma+
• i-see Sensor
• Nano-Platinum Filter
• 7&2 Years Warranty

MS-GH10VC
Cooling Capacity:
2.6kW/1HP

MS-GH13VC
Cooling Capacity:
3.2kW/1.5HP

Main Features:
• Easy Clean
• Nano-Platinum Filter
• 7&2 Years Warranty
if compare to others for mitsubishielectric use less power consumption

This post has been edited by kimsim: Oct 28 2013, 11:05 PM

Not worried, bro..
Cheap = better..
Life spend can last up 10 years = worth it

So u realise about the power of Starmex.

maybe mine is direct imported from singapore one.. got starmex inverter

your is after malaysia model from thailand market to be made for all..

This is very common air salesman would tells u this.

Inb4 yes, nowadays don't have it issue.. Even inverter can perform much better and energy saving.

Inverter vs non-inverter

Inverter have part load.. From starting boot up from minimum power, after certain take mid or full load.
Non-inverter don't have minimum and most of time would full load until on & off times.

For inverter no matter how big of your living hall these only fully utilize on that particular place.
Once temperature reaching and reduce the energy on part load until you change new setting.

Actually these is very common sense.

Non-inverter design for once temp. Setting degree are reaching will sending signal to compressor stop work, until the weather change warm then start with full load maximum power on 2.2kw for while and keep remain on 1.6-1.8kw only.

Inverter will start from minimum power when starting running compressor on 0.4kw - mid 0.6kw - until maximum run on 1.9-2.2kw once temp. Reaching and reduce to part load of 0.6kw only.
Even bigger hp you only pay for 1hp non-inverter bill only.

normal room size 3m x 3m x 3m high for 1hp
bigger room size 3m x 5m x 3m high for 1.5hp
bigger a big like living hall size 4m x 6-7m x 3m high for 2hp
large size 5-6m x 8m x 3m high for 2.5hp

high ceiling 5-6m high x 3m x 3m can use 1hp
high ceiling 6m high x 3m x 4.5m can use 1.5hp

all quote from inverter unit only.

U need 2 x 2hp inverter units
Either 2.5hp + 1hp install at dinner area

Yes it is very commons issue.

Later ur plaster ceiling got water yellow marks

Used bettery plaster coating paint loh

Definitely is better... more cooling and more reliable for comfort air.

only inverter 1hp can sufficient, if non-inverter just good luck and go for 1.5hp.

The only salesman will told you this stupid issue on inverter aircond.

Maybe for Mitsubishi electric inverter commission not that good than non inverter aircond only.

Sometime selling others brand would earn more commission than inverter unit..

Lol.. If really easy to spoil. I think Mitsubishi electric won't warranty offer on 2/7 outdoor unit.

This post has been edited by kimsim: Nov 16 2013, 10:53 PM

Carrier brand under toshiba..

Daisekai maybe more best in the class

This post has been edited by kimsim: Nov 18 2013, 07:54 AM

1st they never sealed it properly on the hose into drain connect.
Or something blocking or falling side higher than non outlet point

Media inverter > all

Electrolux model really rare.. I meant Media brand from china more realible and everywhere

At that open area for 2 unit 2hp inverter
More saving and more faster cooler.

Normal use 1 unit enought and more ppls just switch on 2 units only

Hi bro & sis here.

I'm not selling any Aircon or shop.
But I only advise you & solution only

BTW I'm the user only
Lol

This post has been edited by kimsim: Nov 20 2013, 07:23 AM

That's is maybe, cause mine starmex got singapore energy saving as 5 ticks marks logo.

In jb shop, 2 mths ago asking price for 1hp inverter w/o install for Rm1450 w install = Rm1750-1800