just plug the power cable into 3pin fan connector will do.

3 pin?i think i plug d fan jus as ori intel hsf.
but when open everest it read d fan speed 1188~1205 only.
from d box state max 1500.it's normal or can increase till full?

yup the max is 1500 plus and mine is running full blast no prob....

teach me..i check d bios no option to control d cpu fan..use any software?

funny though if u have plug it in ur mobo section of CPU FAN u should be able to control it......the fan does a have a 4 pin plug rite

yup.it does.argh...tensen2
i connected to cpu fan.why cannot control though..1205.dat max read from everest.

plugging into PWN connector will let mobo automatic adjusting ur fan speed acording to temperature.. depends on BIOS setting also.... and u can use specific software by ur mobo manufacturer to control the fan speed too if u want... the fan is ranging from ~750-1500rpm.... yes 1.1-1.2k is normal....ur fan speed will increase when ur processor getting hotter..... u can on full for full time if u want.. at 1.5k is not noisy at all....

thanks vincentlaw .i check and try it back tonight.
install dis cooler quite hard bcoz chipset mobo really close wif d heatsink.
but it's really good..idle cpu 9 core 48~49..oc 3.2Ghz

This post has been edited by magna_voxx: Mar 31 2008, 11:06 AM

magna_voxx ,what mobo u use anyway?

Abit Fatal1ty F-190HD..

try find smart fan control in ur bios,then disable it

abit provide fanEQ control.but if disable it,then no option will be open in bios to control fan speed.
even after install fanEQ,i cannot adjust d fan speed..only can set d warning temp n so on...no control for fan speed.
nevermind..will do dat.

well hope u can find the solution soon dude.....

you cant find any 3pin fan adapter near to the processor?

48~49 is kinda high for idle even at oced speed 3.2ghz.
my previous q6600 idle 40C at 3.6ghz 1.52v.

okay...will adjust it back.and try to change fan speed oso.thanks 4 d advice guys..

wat proc are u using... why at 3.2ghz is 48-49'c.. its quite high... my E6750 OCed to 3.6ghz at 1.406v idle at 42-43'c only at noon time..... max load 60-61'c using orthos and prime95

This post has been edited by vincentlaw: Mar 31 2008, 05:42 PM

did u apply the thermal solution properly and are u using push pin or ss kit??... the temp should be around 38-45... even with close casing also around that range... my 6550 oc until 3.5 also around 44c (idle) and on load at 60c... all using 1.337 vcore...

My rig shows unstable and hang at 3.6Ghz.......maybe bcoz I use the stock paste....

increase ur core voltage a lil bit more.... wats ur stock voltage for ur E6750?? 1.325 too?...... increase ur FSB/MCH voltage +0.1... decrease ur ram multiplier to 2.0x and loosen ur ram timing

This post has been edited by vincentlaw: Mar 31 2008, 06:11 PM

shud be no problem from using stock paste gua.... whats the load temp u got?