Do they offer e-sim for Edisi Kuning prepaid?

you need to go back to centre after line is active to change to esim

This post has been edited by mercindustries: Mar 31 2024, 02:07 AM

Just noticed there is no more senior citizen rebate for new signups



Saw on shopee agents selling new plan Digi coverage, too bad no more rebate or not quite a good deal

CelcomDigi Prepaid 5G Edisi Kuning

I just got celcomdigi postpaid 40 from 2 days ago, but when activated bar lines very weak at home (consistently at 2 lines, sometimes go down to 1 line), mobile data also get E sometimes, very frustrating. Checked before getting the plan, their website said got coverage, then complain to CS revert back say area no coverage, alamak why so inconsistent.



Haiya, feel regret and wasted money, wonder if can port out to hotlink since far better line coverage and reliable...

Nani i thought capped at 100Mbps?

they’re conservative when announcing to public

Which area is this?
So high speed you gotten huh 🔥👍

yea same here bro, line is ok but seems the connection is not consistent and stuttering...

the prepaid version is ok but this...

jb area

Ahhh no wonder...

Need to be on par with the tiny island across...

That's why quality tip top one 👍

even 4G having good speed in most area, hope they'll keep up

You sign up with DiGi or Celcom? I don’t think the cell sites in Klang valley have been combined?

I singed up with DiGi last week and I do notice a difference in coverage between DiGi Celcomdigi and celcom Celcom

Mine CelcomDigi Postpaid 80 5G
Looks like 100 speed cap might applicable for high file downloads


Attached thumbnail(s)

Anyone have list or areas already combined and modernised into one?

most of the time on 4G and it's sufficient to do anything on a phone, i used to get 10 - 50mbps before merger 😂

Bought a Digi SIM to test out the recently upgraded sites, let's say to 4T6S or AAU. Most sites are having problem from running on 4CA, resulting into slower 4G+ speed after the upgrade.

The worst scenario is most of the upgraded sites started to broadcast 2G on 900MHz as well, due to Digi limited 900MHz spectrum, the precious LTE Band 8 was squeezed from 5MHz to 3MHz. Due to 3GPP standard, 3MHz bandwidth LTE is not allow for carrier aggregation resulting into awful single digit slow speed if your phone accidentally dropped to Band 8....

Besides that, compared to Celcom and Maxis, Digi has a way higher tendency on connecting Band 8 as the primary LTE carrier. Honestly, this is a terrible decision. Customers could not enjoy the best available network.

Last but not least, most of the uncombined upgraded sites stays on 2CA even on high band, it either do B1+B3, B3+B7 or B1+B7, but could not do B1+B3+B7. Terrible experience if u are an existing Digi customer experienced the network before upgrade and after upgrade

Android users on Digi, force yr phone on 4G not 5G, install CellMapper. If your phone shows MY CELCOM instead of Digi on the top. It means the network is integrated.
For Celcom users, force yr phone to 4G as well, install CellMapper or any cell tracking tools. If the TAC number shows 5 digits, very likely the network has been merged.

NetMonster for Android will give u a hint as well, Celcom's EARFCN are 1650, 3150, 375, and 3600. Digi's EARFCN 1850, 3350, 524, and 3524. If you are from telco A but see telco B's EARFCN as one of the carrier for 4G+ CA in NetMonster, means the network had been merged.

Alternative way for iPhone and non CelcomDigi customers are going through CellMapper map and depending on crowd source data.
Pick Celcom, if u see 5 digits eNodeB number instead of 6 digits in north and central Malaysia, means the network had been merged. South and east coast is harder to identify, same just pick Celcom in CellMapper map, and see if most recently mapped cells have a 5 digits Region code, if so that means merged already

Hi, any idea on why CelcomDigi Integrated network in the MRT Putrajaya Line tunnel section have poor RSRP and SINR? -7dbm for SINR and BLER reached 50%, speed is ranging from 1-2Mbps (SINR < 5dbm) to 300/400Mbps (if SINR > 20dbm). Been contacting Digi so many time since this issue happened but they keep give me robot reply.

(SINR -7dbm)


(SINR 25dbm)

First condition might be due to handover failure, the phone is connecting to a further cell. A flight mode or restart the phone might solve the problem?

Since it is extremely unlikely for an MRT DAS to have such poor RSRP. Might just be handover failure

This post has been edited by jasontanky: Apr 3 2024, 11:45 AM