Outline ·
[ Standard ] ·
Linear+
>~.:PROTON Problems Official Thread:.~<, NOTIFY YOU PROBLEMS HERE ONLY!
|
nujikabane
|
 Apr 23 2013, 10:50 PM
|
|
QUOTE(nujikabane @ Apr 22 2013, 11:38 PM) I won a Saga BLM 2010 variant. the thing is, my left fog light has gone kaput recently. Right fog light is working fine, though. Question is; what could go wrong? Is it the fuse, or the mentol itself? UPDATE : Is definitely the mentol, as I have checked the fuse, and it is fine. And it is quite bizarre if the fuse blows, and yet the left fog light is still okay, right? |
|
|
|
|
|
mf_yamato
|
Apr 24 2013, 10:11 AM
|
|
|
hi guys,
i'm using FLX SE, yesterday suddenly my CVT warning lights up, then when i press the brake pedal the warning turns of, after i lift the brake it turns onn again, then i stop at the sideways, and turn off the engine for few minutes and start it back, the light is off already....
it also happens when i go work today.... the same thing i done, press brake, warning lights off, lift, it's onn back, refuel and start engine back totally off... and i notice my brake lamp (the one installed at rear windshield is not functioning)... could that is the culprit, if that so, that would be ridiculous, and my mileage is 32k, i think i should change the cvt oil first, (planning to do so by this week actually)
so any pointers for me???
|
|
|
|
|
|
cipsmor
|
Apr 24 2013, 11:08 PM
|
Getting Started
|
Hi All Sifus...
Need your help.
I'm driving Gen 2 CPS. Just realized that my car auto lock doesn't work when I pressed the brake.
Need help!!!
|
|
|
|
|
|
Dbassnut
|
May 3 2013, 10:01 AM
|
Getting Started
|
Hi Guys,
I need your advice. My car is a Wira 1.5 Auto & I've been having the following problems.
1. After starting the engine when its cold & driving, the auto transmission doesn't allow the car to go faster than 30~40Km/h, after driving for about 5~10 minutes after the car engine is warmed up, then only, the car can go faster.
According to my usual foreman, the auto gearbox needs to be serviced/replaced & this would cost between RM1400~RM1800.
Any comments you have would be appreciated.
I'm looking for a solution based in Penang as I am based here.
|
|
|
|
|
|
naruto_kun
|
May 5 2013, 09:17 PM
|
|
|
QUOTE(mf_yamato @ Apr 24 2013, 10:11 AM) hi guys, i'm using FLX SE, yesterday suddenly my CVT warning lights up, then when i press the brake pedal the warning turns of, after i lift the brake it turns onn again, then i stop at the sideways, and turn off the engine for few minutes and start it back, the light is off already.... it also happens when i go work today.... the same thing i done, press brake, warning lights off, lift, it's onn back, refuel and start engine back totally off... and i notice my brake lamp (the one installed at rear windshield is not functioning)... could that is the culprit, if that so, that would be ridiculous, and my mileage is 32k, i think i should change the cvt oil first, (planning to do so by this week actually) so any pointers for me??? I think the brake lamp is the culprit. Apparently, the cvt does takes input from the brake switch.  |
|
|
|
|
|
mf_yamato
|
May 5 2013, 11:09 PM
|
|
|
QUOTE(naruto_kun @ May 5 2013, 09:17 PM) I think the brake lamp is the culprit. Apparently, the cvt does takes input from the brake switch. yup, the brake lamp is the culprit, replaced it and the warning sign gone totally. |
|
|
|
|
|
abijiu
|
May 17 2013, 09:36 AM
|
New Member
|
my flx cvt engine died on me during reverse from out from my house gate ... happened twice already.  . I quick quick press the brake pedal and shut down the aircond n radio. Then restart. Lucky everything returns back to normal. got a few times my tachometer revved up to 4000rpm++ when start engine .... anyone got experience such situation? FYI my gaga is just less than one year old |
|
|
|
|
|
arsynyc
|
May 17 2013, 03:08 PM
|
New Member
|
Hi guys, I bought a 4g93 auto that i converted to manual last December. Now when changing gear, the car jerks quite strongly whenever I let go of the clutch. At first i thought that it must be my lousy manual driving skills but after so many times of releasing the clutch extremely slow I can still feel the jerk. It gets kinda annoying especially on long journeys.
Can anyone help me?
|
|
|
|
|
|
arsengal
|
May 19 2013, 02:37 PM
|
Getting Started
|
QUOTE(sranua @ Apr 22 2013, 08:20 AM) I bought a second hand Wira SE year 2004 in 2012. Part that change:- 1. Water Pump Hose 2. Water pump itself 3. Clutch set 4. All four absorber-use Sachs Abs...pretty good. 5. Rear Disc Brake Yesterday, aircond bearing kong....replace at RM59.00...aiseh...its second hand..what to do. Already heard some tak..tak sound at front tyre...I guess my money will be gone sooner or later. Bro whats the total cost for the whole change that you've done? I've a WiSE as well, planning to convert the gearbox to manual. Darn so much problems with my car right now. Just now the front lip tow cover went flying while I was driving, sigh |
|
|
|
|
|
V-Zero
|
May 20 2013, 03:39 PM
|
|
|
Anyone can share roughly how much it costs to replace burnt gasket for a wira? :S
|
|
|
|
|
|
hydeist6055
|
May 25 2013, 02:30 AM
|
Getting Started
|
Hi guys I'm driving a satria neo 2013 r3 bodykit ver.
Does anybody got the problem with the viper lever .
Viper on at medium swipe got click click sound inside the steering lever...
Proton change the whole lever stick but still when medium power motion still click click... But slow and fast is ok.. This sucks...
|
|
|
|
|
|
diadokmai
|
May 26 2013, 09:13 AM
|
|
|
i think this is the factory problems.. they didnt do final checking on what their staff done to my car..aiya QUOTE no screw on 4 cover hole...2 at front and 2 at rear..only got srew at the middle both right and left. now the cover loose.. i can simply call it QUOTE daily loosing  This post has been edited by diadokmai: May 26 2013, 09:14 AM |
|
|
|
|
|
MasBoleh!
|
May 26 2013, 09:51 AM
|
|
|
QUOTE(diadokmai @ May 26 2013, 09:13 AM) i think this is the factory problems.. they didnt do final checking on what their staff done to my car..aiya no screw on 4 cover hole...2 at front and 2 at rear..only got srew at the middle both right and left. now the cover loose.. i can simply call it What car is that? Send to SC to rectify? |
|
|
|
|
|
diadokmai
|
May 26 2013, 10:14 AM
|
|
|
QUOTE(MasBoleh! @ May 26 2013, 09:51 AM) What car is that? Send to SC to rectify? my preve cfe.. yesterday i sent to SC for rectify and get repair. plus im doing my 20k service. they said problem solve...but when i pick up my car...still the issue is not solve..but at that time i really urgent so just leave there for that time, i plan to go again this monday. that picture i snap yesterday evening..after i settle my works.. i already suspecting no screww that is why the cover loose..i tell them many time already to check either the screww got there or not...they just said ok ok..will be check will be check.. haiya. |
|
|
|
|
|
MasBoleh!
|
May 26 2013, 10:59 AM
|
|
|
QUOTE(diadokmai @ May 26 2013, 10:14 AM) my preve cfe.. yesterday i sent to SC for rectify and get repair. plus im doing my 20k service. they said problem solve...but when i pick up my car...still the issue is not solve..but at that time i really urgent so just leave there for that time, i plan to go again this monday. that picture i snap yesterday evening..after i settle my works.. i already suspecting no screww that is why the cover loose..i tell them many time already to check either the screww got there or not...they just said ok ok..will be check will be check.. haiya. They check already still didn't put screws? Sound like they didn't check at all. Ini mesti curi tulang  Maybe is time to change another SC. Which SC you went? All the best to your preve man ! This post has been edited by MasBoleh!: May 26 2013, 11:00 AM |
|
|
|
|
|
diadokmai
|
May 26 2013, 11:15 AM
|
|
|
QUOTE(MasBoleh! @ May 26 2013, 10:59 AM) They check already still didn't put screws? Sound like they didn't check at all. Ini mesti curi tulang Maybe is time to change another SC. Which SC you went? All the best to your preve man ! the Biggest SC in Alor Setar Kedah. Alor Setar Service Centre Jalan Gangsa Eon Service Center Alor Setar. last time i sent to small SC, they refer to this Eon..that is why i directly go there for service and complain. even the biggest Kangar Proton SC sent to that Eon SC if the problem is major.... 
This post has been edited by diadokmai: May 26 2013, 11:19 AM |
|
|
|
|
|
diadokmai
|
May 26 2013, 11:21 AM
|
|
|
QUOTE(MasBoleh! @ May 26 2013, 10:59 AM) They check already still didn't put screws? Sound like they didn't check at all. Ini mesti curi tulang Maybe is time to change another SC. Which SC you went? All the best to your preve man ! this monday i will directly go and make them do it in front of me. |
|
|
|
|
|
MasBoleh!
|
May 26 2013, 02:53 PM
|
|
|
QUOTE(diadokmai @ May 26 2013, 11:21 AM) this monday i will directly go and make them do it in front of me. Wow, cant believe major SC in Alor Setar still got such issues yeah, if still not do it right, then I think you need to head down to Penang's SC Once again , good luck bro ! |
|
|
|
|
|
diadokmai
|
May 26 2013, 05:50 PM
|
|
|
QUOTE(MasBoleh! @ May 26 2013, 02:53 PM) Wow, cant believe major SC in Alor Setar still got such issues yeah, if still not do it right, then I think you need to head down to Penang's SC Once again , good luck bro ! Ok thanks bro |
|
|
|
|
|
Gen2badak
|
May 27 2013, 12:16 PM
|
New Member
|
i drove gen 1.6hline manual..
the problem is...when i want to make a u turn my stereng will pusing abis...
then..suddenly my engine stop during u turn..?
why is it?
any one know?
|
|
|
|
|
Quote
0.0553sec
0.66
6 queries
GZIP Disabled