well.. i shall bring this in earlier... wanna start a bulk? i will organize it with xigmatek

Sadly, xigmatek doesnot product any chipset cooler.
Would love if one company were to make one chipset cooler that uses the HDT technology with two heatpipes.

There's already one chipset cooler that utilize the HDT technology, but it only uses 1 heatpipe.
It's PCCooler HB-771s Northbridge Cooler.

It would be better though if xigmatek produces on CPU heatsink that uses the HDT technology that utilize 6 heatpipes.
Wondering how good will it performs with 6 heatpipes & HDT technology.

Wat more can i add bro shawty oredi stated the obvious here...6 pipes with thick base not so good less pipe direct contact superb cooling...i wonder what result if xigmatek uses 6 heatpipes? it really x1000 fascinates me ere...

MY VOTE XIGMATEK!!!!!

owh bro dont temp me?if u do hurry la and need to ask sammore ka?paisehhh...

good heatsink...going to get it from TS today!!!!

what is this??

yes, xigmatek does has a better efficiency in heat transfer

and unless it is alot more cheaper than the Ultra-120 xtreme
or the pricing is the same

then xigmatek is still the outright loser is this comparision

it no like you can buy the xigmatek and add 3 mor heat pipes

this is not like buying a car
-get a car with good engine, and mod it till it's better than the touted better car

when you get a HSF you're stuck with it
when it is 1 degree less, it is still 1 degree less'


Thaty, again, if the pricing is the same ...

not like that la

who is stupid enough to buy a heatsink that is bigger, heavier, got extra 3 or 10 or 100 heatpipe & more expensive but the results in temp only 1 degree cooler

just like buying those TT BigWater watercooler --> why pay more when High-end Air Cooling can do the job? why go such hassle installing it when High-end Air Cooling is damn easy in installing it

even Xigmatek is the same price with Ultra-120 Extreme, I still go for xigmatek

reason --> smaller in size, easy installation of other hardware such as 4-Pin Power Cable, i'm willingly to sacrifice my hardware 1 degree hotter just for the easy installation --> utterly stupid for me to go for the 1 degree difference when my hardware can sustain till 80 degrees (still lots more temp left)

Ultra-120 eXtreme
外觀精緻,焊工用心的藝術品,憑藉著6支大型熱導管和高效能的散熱機制,坐擁空冷之王的寶座Ultra-120 eXtreme當之無愧!
優點:
此顆散熱器效能寬廣,適合全域的使用,尤其重度超頻效果越佳!
缺點:
價格高,扣具壓力磅數極高,不易安裝...必須小心鎖合切勿用蠻力喔!

HDT-S1283
價格便宜,C/P值佳...創新的HDT技術,可畏帶來散熱界的突破!
優點:
長期使用於直立機殼,不易造成變形與脫落!橡膠固定柱有助減少風扇共振產生的噪音!
缺點:
內附的intel式按鍵扣具,易使主板LGA775 socket座因PCB變形而導致錫裂接觸不良,建議加購強化背版與扣具

noctua NH-U12F
歐洲時尚造型,精緻安全的設計,不會割手!
優點:
靜音取向,美觀討喜,好安裝...重度超頻搭配雙暴力扇亦能坐擁空冷之寶座!
缺點:
價格稍高,單風扇極限表現普通....

Tower
這老牌的過氣王者...特色就是衝極限啦!
優點:
裸測時快速徒手架平台,不需起子!
缺點:
重量之王,不適合直立小機殼,風扇內置不能加裝,體積過大易干涉主板熱導管(GA P35-DQ6)


最後祝大家用的愉快

u are sooooo right!!!!

well,i get the xigmatek HDT-S963 from ckhoong today!!!

man...this is really small heatsink as compared to my current Thermalright HR01(mine saw off 1/4 in height)!!


will test it once i get back as compared to my currently setting!!

how much for one of these bad boyz?

i only concern bout how user going to clean up the TIM after removing the HSF from proc. those small gap are hard to clean. even dip in alcohol wont help much.

another vote for DHT:thumb:

how much does this one cost? i'm still deciding on Ultra120Extreme, IFX14, Tuniq and now, HDT-S1283. Does this one pWn IFX14?

This post has been edited by toughnut: Jul 5 2007, 06:28 PM

it all compare using same fan and cfm too~

original page have all it infomation~

@akachester
of course 120ext use fan. if not impossible to run fanless with OCed proc. price for this xigmatek cooler already revealed. anyone interested?

This post has been edited by toughnut: Jul 6 2007, 12:10 PM

ok, i have merged the thread so that u guys can discuss here

Cool, cause I've just order one from bulk!

However, the title is not good. Not many people would know what a DTH is.

@TS, can change the title to something that is easier to understand?

pm lolhalol to do so.. im not the TS anymore

I know la....was referring to lolhalol!

damn,
i found out that the Xigmatek perform much much betther if i open my side casing!!!!

Idle at 3040Ghz(E6400) at 36 to 39C
Orthos Load show at 50 to 55C......quite good as compared to my "modification HR-01" which show 60 to 65C..


all using thermal paste AS5.

Wah! 10'c lower than the HR-01!!!

Where did you get your xigmatek? For how much? Is it the S1283 or the S983?

Errr..... any heatsink would perform better without the side casing la....