any brake pad recommend?? bendix metal king makan or not?? last time use trestor green brake cannt use, handbrake on slope road cannot brake

hey guys, what halogen bulb you guys recommend? I used OSRAM Night Breaker on my Persona 2016 and it lasted just one year only...

Bendix quite nice for me. But handbrake should related to your rear wheel brake. I suppose you need to get it serviced and adjust hand brake cable?


Just use any normal Osram or Phillips bulb. Cheap to replace. I tried LED and doesn't do good for opposite car. Change back to normal Halogen bulb. When need extra illumination I just put high beam.

is your bulb white or yellow?

because am looking white halogen, but not sure which to choose

My LED bulb was white. It blinds opposite lane and gave poor visibility in rain. So i swap back to warm halogen.

recommand NARVA range 150
i now using this lamp



This post has been edited by delaciox: Oct 15 2021, 07:39 PM

Fan belt 6PK1669 or 6PK1677 ??

My tensioner bearing now vibrating when the A/C compressor is engaged. Last year changed new tensioner bearing, fan belt 6PK1677 but it still vibrating - then I changed alternator pulley: vibration gone.

Now the vibration is back but not as bad when the alternator pulley was faulty.

Last time using 6PK1677, but check that 6PK1669 also compatible to use.

wow, this thread is still alive!
I am still using my persona as it still good to be use.
Hey I am going to replace my rear tulang anjing, short and long. Is there any particular good brand/manufacturer to choose at. One of the rod has giving me squeaking sound. Thanks

Muteki is expensive, but it lasted me longer than original. Having it for about 200,000km.

Is there a reason why my car drives better after send for AC major service? Before this my car have slight jerk when coming to a stop. Going downhill also dont feel the usual gear down shift jerk.

And anyone have problem with their brakes make knocking sounds? I suspect it might be a seized caliper pin.

Done replacing all the necessary parts, mostly rear suspensions and all the connected parts, except lower arm bar. Feel good when take corners, no more feel swinging and those squeaking sound. 2 Goodyear Triplemax assurance, 2 kayaba absorbers, tulang anjing left and right. Now I am going bto replace my engine mount next, any good reliable brand should I go to apart from the original proton. Seems that the original is quite expensive compare to any after market brand.

Changed rear lower arm, tulang anjing today. Total cost around RM4++ including labor. There's a few squeaking sound probably from rear stabilizer bush.

Quite a lot of upgrade.
How much damage?

Engine mounts not expensive but labor is.

This post has been edited by wklow28: Dec 9 2021, 11:51 AM

damaged about rm1.1k, but I am satisfied with the outcome. My 2011 persona is getting younger again at least for coming years of 2 or 3.

OIC...good to hear that.
Mine is 2009, so urs is elegant version, newer than mine.

My PE original Blaupunkt CD stuck inside , every time on the key the radio auto turn on and buzzing sound at speaker , display cannot play CD anymore pull fuse reset also same, what to. do ?

Bring to accessory shop?

where is the best part to install rfid sticker for persona? at headlamp or upper left windscreen?

I stick it to a piece of card and use it as if i would use my smart tag.