ya force it for testing purposes.

Haha, sometimes it just too far from the site causing the speed slower...
I guess not many sites will have congestion...

This aeonbig subang site but I connect it at ss15...
Speed really good...

One thing I found, a prepaid account in the house wasn't allowed to latch on to the B8 frequency. Only my Postpaid 110 was allowed access. Looks like they're not ready to roll it out to everybody yet.

I din test with prepaid but....
Telco cannot differentiate user by frequency spectrum..
If u say only postpaid can enter 4g then possible ....
Will try prepaid if free...

This was my experience this past weekend:.

Postoaid 110 {on OnePlus 3T}: suddenly Band 8 on ground floor of house. If go upstairs or outside, then switch to B3 or B7. However, since Monday, B3 and B7 back to normal strength, and B8 only appears in a few blind spots which previously would drop down to H+.

Prepaid Best v4 (on Samsung Galaxy S4}: B3 only downstairs, B3 or B7 upstairs. When try to force to B8, get the No Service symbol.

It could be that Digi LTE B8 is still in testing phase at my area.

Have you tried putting prepaid sim card into OnePlus 3T?

Based on ur explanation...
The cell is reserved... Mean u can from b3 or b7 to b8
But cannot go b8 directly...
Try not to force b8 n slowly walk to ground floor n try?

Else switch ur sim, see the result is same or no...

All my phone auto lock to band 3 at my house but only 2 signal bar.. does that mean band 7 is not available at my area? Because i believe they will auto lock to band that provide the best signal right?

root phone can check which band available using network signal app

Any other way for iphone?

SS15 L9 OA...
I fully grabbed the capacity....
Tested by facing my phone to the tower which is 50m nearby.

ohh.. iphone.. not sure then.. didnt own any iphone

may i know what is the app u use to check the rsfq? lower means fewer users connected to the tower right

This post has been edited by kernel123: Jul 26 2017, 08:08 PM

iinm, thats android engineering mode.

The above was shared in Digi Infinite Thread.

may i know what is the app u use to check the rsfq?
samsung internal code.... *#0011#


lower means fewer users connected to the tower right
yes

same as SNR (higher better)
and
RSRP ( lower = nearer to the tower)

That only show im using band 3. Is it only band 3 i can use in my area? Cause they say phone will auto lock to the band which provide best signal.. but im getting only 2 bar with band 2.

It could be your area has no other band? Some places are like that. I don't use iPhone so yeah..

Some sharing....

Nice info! 700MHz not gonna happen till 2018