90CFM at 19dBA? Sounds too good to be true

not exactly a case fan, but its a good shot
Xigmatek Red Scorpion/Achilles fan



best shot i could take by far xD

This post has been edited by DaRkSyThE: Apr 23 2008, 06:09 PM

Well...anyone have ne idea abt this?

Very nice picture ( = If the logo was horizontally aligned, then it would be perfect. ( =


And No RageWeaver, I have no idea.

This post has been edited by RahXeph0n: Apr 23 2008, 08:22 PM

u can always go HERE to check out specs for the delta fans...most commonly used 120mm would be the FFB1212EHE - 190cfm @ 59dba @ 3.0A

other delta series u could look at would be the TFB or the monstrous GFB series.

if u power any fan from ur mobo..make sure the ampere rating is 0.8A or BELOW. any higher and u risk burning ur mobo. some places sell the deltas with molex (for power) + 3pin connector (for rpm monitoring). basically if u wanna use the deltas u dont have NO choice but connecting it directly to ur psu for power. dont even think of trying it... i did and almost regretted. my PC was still on and i plugged in my FFB into the mobo and the PC went dead. try to turn on cannot...unplugged the fan from the mobo and ok already...but when i plug direct into PSU everything was ok.

otherwise...mebbe u could check THIS out.

anyway...pic and specs of the FFBs in the spoiler



This post has been edited by mADmAN: Apr 23 2008, 09:44 PM

http://www.leapfroglobal.net/p-pl.php?id=a...l&series=azzura

guyz..this casing d...the hole at teh lower side d..120mm d...put intake or exhaust?

Guys, I wanna ask, are ZALMAN casing fans good?

This post has been edited by impostius: Apr 24 2008, 11:44 AM

i looking for this fan also..

Asking a question, recently i just bought some bling bling 12cm acryan's black fire fan from Uglyvamp, after replace it with my 12cm SS case fan.... wow... IS VERY VERY NOISY compare to my previous SS case fan.

So my question is, any way to reduce to noise? Tq guys

de volt ? control the rpm ?

It means reduced the voltage supply to the fan ..

usually case fan volt vary from 5v, 7v, and 12v ...

so depend how u mod it which would effect its round per minute (RPM)..

i think lowering the voltage have no effect since the noise is comes from the RPM..
correct me if i'm wrong..

after lowering the voltage, the fan speed will reduce, there goes the noise will reduce too

anyone knows where to get thermaltake smart fan in lyp??

coz most of the forummers dun not have any stock for the smart fan

@duckevo
There's really limited supply of TT fan ..

you could try to go to Robyncom at Imbi plaza ..

Not sure they still carry TT fan or not ..

Basically I've had bad experience with TT smart case fan.

Fragile RPM sensor header and LED longevity..

thanx mate...

i take good notice of the sensor & the led..

planned to put it on manual control

guys, which fans are quieter and pushes more air?

-smaller blades but many of them (example 11 blades) or
-bigger but fewer blades (the standard 5 0r 6 blades)

Also, it is my understanding that bigger fans are able to run at lower speeds but pushes a higher volume of air and creates less noise as apposed to their smaller counter parts. Is this correct?

If this is true, i currently have 2x120mm fans that are installed at slots that are also able to support 140mm fans. Should i make the upgrade?

hmm 14cm fans does enhanced the airflow by certain margin ..

but it's hard to get quality 14 cm fan ... and the price isn't cheap as well ...

anybody got any experience using these san ace 109P121F4D04 120X25 fan sold by uglyvamp?

how its the noise level running it full speed? some feedback would be good for me

Guys got any good recommendation for a 120mm and a 80mm fan?
Currently using stock CoolerMaster fans, I think the cfm abit low.