If need to reset

Cum and refresh your memory and passion for it.



This post has been edited by Fubar20: Sep 13 2018, 12:46 PM

Reset for what?
There is a Console for putting the settings in the webpage for the Sonoff device.
Worse come to worse also can reflash OTA the firmware.

Give the link where to buy

Wohooo you go to far, in just started, only know to use app at moment and not console

Can elaborate furter on console

Use ewelink app or tasmota Sonoffs no need to touch the switch anymore after setup.

Is it, ok will try . Already order sonoff basic bit not arics yet

Last night i changed the down led in the barhroom. Just want to ask, the blue wire is the neutral right?

Mine is black.
Refer here https://forum.lowyat.net/topic/1913563

Nope, not offically sold here nor comes with msia zwave frequency. If you wanna get one, make sure your hub z-wave frequency is compatible with your z wave devices.
For example, I got a us smartthings hub to pair with my Yale smart lock.

Oh forget to the test the live via test pen

If i am looking to use only the zigbee portion , shouldn’t be an issue right?

This post has been edited by Drian: Sep 13 2018, 03:19 PM

Smarthings supports many devices. Here are good resource on how Smarthings can be used on Xiaomi.

http://www.mysmartcave.net/category/home-automation/

AFAIK zigbee frequency is standard worldwide, just z-wave is different based on region. You can pair with xiaomi sensors to the hub.

Aliexpress lor.

Really no time liau.

Probably slow slow learn. If not botak like him.

Less than half an hour can settle since you have the materials already.
Now flashing very easy and fast. No need use Arduino IDE.
My experience is that the FTDI USB might be fake and frustrate the process.

This post has been edited by Fubar20: Sep 13 2018, 04:40 PM

That FTDI USB brought from local. I choose the seller that sell the most.

If fake, I complain kau kau in there.

Local seller but Made in China.
So confident then 5 minutes can finish flashing already.

Coming from a first time flasher (sounds corny), I use FTDI and ArduinoIDE, maybe it's a bit too much but I'm on an iMac.

1) FTDI chip, I use the CP2102, make sure you get the IC? chip in a diamond-shaped format.

2) Get all your libraries and ArduinoIDE and Tasmota updated to the latest version.

3) I didn't have to solder any of my Sonoffs, but a word of caution, I have only Tasmota-ized Sonoff Basic, TH16, POW, T1 (2 gang & 3 gang), Sonoff 4Ch and Sonoff 4ChPro. So that is my only experience.

4) The toughest of them all was the 4ChPro, because I have to hold another jumper cable from the GND slot to the 2nd pin on the IC. But it can be done.

Anything can just ask. I only followed DrZzs videos, and the Tasmota wiki page. All is there, just that it's technical on the wiki whereas DrZzs is more visual. I'm a visually inclined person.

Home Assitant? are u refering to Google Home Assistant?