Just now got see the original JL 12W3V3 with RM900+ + Sealed box.... I think it may not be imatation leh( got ProICE sticker)...

This post has been edited by loon1031: Oct 4 2006, 10:02 PM

if it's an ORI 1... it is really a g00d price..

btw, don get a cheapo box.. make sure the box is a g00d quality 1 and if ur boot space allow, do make the box bigger a little from the requirement..

I confirm it original loh...because I install my amp there before & know the boss...
I think my Kelisa only can fit the normal box size... because no more space liao...

uuuh.. the normal size tat u said is it 1.25 cuft?

What is cuft? Actually I not so familiar with Subwoofer...

cuft = cubic feet... the enclosure measument unit...

This post has been edited by craziechild: Oct 5 2006, 07:06 PM

How about JL Audio W3v1 cost RM800 + sealed box?
JL Audio W3v1, W3v2 & W3v3 which one is better?

What if people take replica and sell expensive?

i bought my JL from states.. (my cousin send it back 2 me) it cost me around rm700+/- that time(3-4 yrs back).. i don think so it is still worth that amount.. i think the newer version performs better

not sure actually

but bear in mind that there r lots of imitation in m'sia.. so again.. becareful

Now i got offer from difference shop
JL Audio 12W3V1 with sealed box RM800,
JL Audio 12W3V2 with sealed box RM900,
JL Audio 12W3V3 with sealed box RM980,

Still don't know which one will be my choice...!
Because don't the difference mah...

gif up the v1 since it is so old and long time story liao..

ur choice will end up @ v2 and v3.. so u figure it out urself larhh.. btw, how low can this v2 and v4s' freq can go down 2?

Newer version only RM 80 different? Not bad...

12W3v2-D4
Free Air Resonance (Fs): 24.0 Hz
Electrical "Q" (Qes): 0.443
Mechanical "Q" (Qms): 8.483
Total Speaker "Q" (Qts): 0.421
Equivalent Compliance (Vas): 3.65 cu. ft. / 103.4 liters
One-Way, Linear Excursion (Xmax)*: 0.463 in. / 11.8 mm
Reference Efficiency (no): 0.310%
Efficiency (1W/1m)**: 86.9 dB SPL
Effective Piston Area (Sd): 81.5 sq. in. / 0.0526 sq. m.
DC Resistance (Re): 7.35 ohm***
Nominal Impedance (Znom): Dual 4 ohm
Thermal Power Handling (Pt): 300W
Driver Displacement: 0.07 cu. ft. / 1.98 liters
Net Weight: 11.2 lbs. / 5.0 kg


12W3v3-4
Free Air Resonance (Fs): 26.72 Hz
Electrical "Q" (Qes): 0.472
Mechanical "Q" (Qms): 7.572
Total Speaker "Q" (Qts): 0.444
Equivalent Compliance (Vas): 2.844 cu. ft. / 80.54 liters
One-Way, Linear Excursion (Xmax)*: 0.510 in. / 13.0 mm
Reference Efficiency (no): 0.313%
Efficiency (1W/1m)**: 87.15 dB SPL
Effective Piston Area (Sd): 80.600 sq. in. / 0.0520 sq. m.
DC Resistance (Re): 3.563 ohm
Nominal Impedance (Znom): 4 ohm
Thermal Power Handling (Pt): 300W
Driver Displacement: 0.071 cu. ft. / 2.01 liters
Net Weight: 14.50 lbs. / 6.58 kg

Which one better?

12W3v2-D4 more into SPL ?

I don't know how to see the spec...

v3 is better..

haf u tested it urself? btw, the design g00d arhh ? he! he!

How to say better?
Which better consider good?

i don actually quite understand the spec but the hz r measured wif the free air..

i will try 2 check around if there is any other website which is more detail.. but wat i can c tat v3 performs louder here..

correct me if i'm wrong..

Choose the dual voice coil might be better, but depend on people taste. Atleast my PC speaker Altec Lansing ADA885's 8" DVC bass is more solid than other same price range speakers.

v2 go deeper(more vibrate area,more air) while v3 is harder(less vibrate area,less air).......v3 will be more punchy than v2...so it depend on u...if i were u, i will get the v2 for the wiring options and the deep bass.....but if u like harder bass than v2, then u should get v3 since the rated power are 300w for the only 1 voice coil...needless to say it's more powerful for hard punchy bass......(punchy and punchier are compare within this 2 sub only)

as a conclusion from my opinion, v2 is like usa sPL sub which are good in low freq, while v3 is like malaysia spl sub which is good for higher freq...

this is wat i understand from my experience and the spec shown....if wanna flame, then........