Welcome Guest ( Log In | Register )

8 Pages « < 4 5 6 7 8 >Bottom

Outline · [ Standard ] · Linear+

 LYN Proton Wira Club (LYN-PWC) V-XXIX, All Species of Wira is welcum

views
     
arza04
post Jul 6 2015, 06:28 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(O.CModderz @ Jul 6 2015, 04:50 PM)
Hi all!

My wira is a 1.5A I think and there were no problems upon purchase for the first few months (second handed) and every now and then, the engine tends to make loud screeching or whining noise like ngiiiiiii* and its very sharp when I start it up. The sound only dies down after the rpm went over 3k. Is there any solution to this problem?

Thank you!
*
Check all the beltings and its bearing
arza04
post Jul 21 2015, 03:22 AM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(maxgenesis @ Jul 20 2015, 09:32 PM)
anyone the model of the radiator fan motor? where to buy or where to fix?
it come out sound and my water temp go high 1 bar.....

btw.. long time no come back d.....
*
I just replace mine last month
I diy myself, pretty easy..(4bolts, 3 screw, if im not mistaken)

Go spare part shop and tell your car model and what engine
I bought new fan motor cost me rm85
arza04
post Jul 22 2015, 07:24 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(secondrate @ Jul 22 2015, 12:08 PM)
How much to change front and rear absorber? What brand recommended? Just want budget and comfort. Wira SE 2005.
*
standard wira 1.6 absorber
arza04
post Jul 24 2015, 08:25 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(arsengal @ Jul 24 2015, 07:33 PM)
Here bro in this album http://imgur.com/a/NB7Z2

As you can see, the sensor(is it?) plugged to the coil in the first picture is wet and covered with oil. Last picture shows clearly the coil itself
*
Last time i kena because the engine oil cap seal hardened. Change new solve problem biggrin.gif

Cam cover gasket also can cause that leak
arza04
post Aug 18 2015, 12:25 AM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(yang90 @ Aug 17 2015, 09:07 PM)
Hi all sifu,

My wira 1.5 carb when start engine time , sometimes got sound tik tok tik tok when turning key and engine was unable start. But after try few times, it OK and engine started. Besides, sometimes I need turn the key quite long time to start the engine until vroom sound.  Please help.
*
my guess is the starter starts to weak hmm.gif
arza04
post Aug 27 2015, 10:25 AM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
Rear disc 1.5 small like rm500-550

Rear disc 1.8 bigger like 650++

Haven't include cost of repair, skim, pads and installation sad.gif


arza04
post Aug 27 2015, 01:12 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(*************** @ Aug 27 2015, 12:47 PM)
Hey, ayam would rike to know watz the different between all wira linez in the 1st post?
*
engine displacement, number of gears(auto), SE, 1.6 and above slightly different suspension
arza04
post Oct 6 2015, 11:17 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(wira_laju @ Oct 5 2015, 06:18 PM)
i think want a find comfy seat for my car.
but dont want cap ayam recaro or ect.RM600 can get good seat?
*
I interested with the rx8 seats, current market price around 500-ish. Saw few ads on mudah.my but the problem is i dont know shop to mod the railing to fit in wira
arza04
post Oct 29 2015, 10:06 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(jcst83 @ Oct 29 2015, 03:21 PM)
hi all sifu,

my wira car signal recently start to gila already, sometimes ok sometimes not.
whenever want to go workshop, the car signal sure ok already... after go out and drive, not working d. both left and right.
want to ask that any of u all facing the same issue for the signal?.

Anyway, i just went to car accessories shop there just now and they said my double signal switch cause my signal problem..... and the switch itself already RM61.5 include GST.. is the price legit kah? coz im abit worry also la later not the double signal switch problem, i cannot return d. now seems ok la... dono later will happen back or not...
*
RM61.5 is very expensive for hazard signal switch. At lelong.com.my only less than rm30
arza04
post Nov 10 2015, 07:03 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(Yohan @ Nov 6 2015, 02:32 PM)
Hi guys newb here. Have been lurking for awhile tho.
I got my Wira SE 1.6 in Dec 2014. N just only started getting into modding it. I got a short ram intake installed recently. D mech added a pipe to d front bumper  of the car. (refer to pic) so does this make it a cold air intake? I'm not sure whether the pipe has any effect. Hope some of the sifus here can enlightened me biggrin.gif.
*
I done that once, I have a bluetooth obd device connected to my phone to check the temp before and after oped pod filter
The air temp using stock box is cooler.

For open pod, on idle the intake air temp goes up to 65 Celsius rclxub.gif
at 80km/h drive the intake temp is 45c and above

Stock box, the idle temp is 43+-, 80km/h speed 39-41+-

so you have short warm air intake setup tongue.gif

Benefits of open pod : looks good, nice intake sound rclxms.gif
arza04
post Nov 11 2015, 01:55 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(Yohan @ Nov 11 2015, 11:43 AM)
Wah so high ah? U also had the cool air duct pulled from the bumper? I duno whether the pipe got effect of not lol. Btw how much u install? I got my setup (filter+cool air pipe) for rm250.
*
cheap fake filter - rm30
intake ram - rm70
cool air pipe - rm30
labor - sweats

now im using back stock airbox with aftermarket drop in filter. I might cut short the air duct put the at the fog lamp area just for the looks tho tongue.gif

This post has been edited by arza04: Nov 11 2015, 01:56 PM
arza04
post Nov 24 2015, 03:09 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(Yohan @ Nov 23 2015, 08:36 PM)
I need some advice sifus. My ride is proton WiSe 1.5l. I wud like to improve its performance. So far I've done intake mod (open pod). What's your suggestion for exhaust mods? I'm looking for more power. I dont mind loud or not tongue.gif. And shud i upgrade my extractor? Coz WiSe is using 4-2-1 dy right? Pls reply soon. Thanks!
*
Dont change the exreactor..se stock extractor is the best

I changed mine last year and totally regrets sad.gif
Worse is i already sell my stock se extractor
arza04
post Nov 27 2015, 06:20 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(shinjite @ Nov 27 2015, 11:46 AM)
What extractor did you change it to?
*
421 stainless steel from kweng84
Can feel the low rpm torque gone, but mid slightly improve. I dont like that @.@ have to rev higher now
arza04
post Nov 27 2015, 06:45 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(shinjite @ Nov 27 2015, 06:34 PM)
I personally haven't tried kweng84's extractor before. Mine was powerzone and hotbits.
*
Powerzone is good stuff man thumbup.gif

arza04
post Dec 22 2015, 08:02 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(wongwarren @ Dec 19 2015, 01:23 AM)
Does anyone still have the original owner's manual and service booklet?
*
I still have. wira 1.5

QUOTE(rc0clx @ Dec 22 2015, 01:43 PM)
How do I change the parking light bulb, passenger side?

Don't know how to open up the headlamp. Pictures are welcome.

Tqvm
*
Twist
Attached Image


arza04
post Jan 15 2016, 10:29 AM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(^pomen_GTR^ @ Jan 15 2016, 08:44 AM)
oi...that save fuel already lah...
my satria 1.6 auto rm50 hardly get 300km in town driving weh
*
Yea lah. Rm 50 = 25L+- can get 350km is really fuel saving. 14km/L is like near viva auto fc

My rm50 can only get 250-260. Stuck in traffic. 1.5 manual
arza04
post Jan 17 2016, 08:27 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(tingkat7 @ Jan 17 2016, 03:38 AM)
Change my aircond belting. The nyet nyet sound gone.

Does anybody installed suprima steering to wira?

Can the steering control works I.e volume botton etc?

Want to install exora 2din player to wira
*
Suprima steering can fit. But the horn must be mod because wira dont use clockspring. Volume button if want to use need to mod the wiring
arza04
post Jan 17 2016, 09:57 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(tingkat7 @ Jan 17 2016, 09:25 PM)
Already install the suprima steering after found out it can be fit to wira. Did a small mod to use the horn.

Still didnt find any post online that the steering control succesfully modified.
*
Got guide to do the mod?

Last time i use waja steering my mod never lasts sad.gif so now using uk spec iswara steering
arza04
post Jan 28 2016, 02:09 PM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
QUOTE(arepeace92 @ Jan 28 2016, 01:21 PM)
Hi Guys,

last few days i turn on my audio very loud, after few minutes, the radio kaput (cant switch on) together with clock..

can assist me on this issue?

izzit fius or something else?

dono how to check sweat.gif
*
Possibly its the fuse. The fusebox located near the gas pedal, check there. The cover got the fuse diagram
arza04
post Feb 4 2016, 01:42 AM

Casual
***
Junior Member
303 posts

Joined: Nov 2013
The first time i diy my oil change i also fill until point C. After 2 days driving i feel sluggish. Check the car manual it only needs 3.3 litre of oil. Lol. And the full level is actually at point B haha. Crawl under the car and slightly loosen the drain plug to release some oil.

The oil dipstick is confusing

This post has been edited by arza04: Feb 4 2016, 01:43 AM

8 Pages « < 4 5 6 7 8 >Top
 

Change to:
| Lo-Fi Version
0.0644sec    1.02    7 queries    GZIP Disabled
Time is now: 18th December 2025 - 02:37 PM