anybody here got the online version manual for cfe head unit?
mind to share.

For Proton, no online version. But have got for Vauxhall Antara, which uses the same Bosch Multimedia Compact as Preve CFE. Just that it is rebadged as Opel Touch & Connect.

http://www.vauxhall.co.uk/content/dam/Vaux...3_low%20res.pdf

to be very sincere with you,i rarely take out my car when rush hour. the mentioned figure was about 80% highway and 20% city with moderate traffic and occasional start stop traffic.. i even done half tank from jalan duta shell to gurun caltex but had to fuel up because going in to thailand. that is why my fuelly figures are very low.

Im just almost oppositte your position. 80% city and 20% highway as mostly using it for working although distance to my office is just a mere 15 min drive without jam but if jam will take out 30-45 min if i was lucky. even highway i was in jam too even tried to travel back kampung at night also face jam pack or slow driving around 60km/h - 80 km/h...

that might explain high fuel consumption.. for me, its totally alright compared to my dad's old wira and his land cruiser.

just an update guys,

arranged an appointment at Seksyen 13 PJ service centre today and went for it
told them that the problem with the loud turbo spoofing and lack of power
after foreman took a test drive with the technician, they also agree on it
after checking the hose of the turbo and connections to confirm no leaks or cracks, the problem still persists
then took out the air filter hose (which makes the turbo sounds much sexier) but problem still there
foreman suggested to reset the ecu/tcu for the car & gear box
and problem solved

issue is due to in January, i changed my car battery due to swollen at the side due to the hot engine bay
while changing the battery, the car engine is running to charge the alternator (which is a BIG NO according to the Seksyen 13 foreman and the correct way is to change is the engine is turned off)
with the engine running, some how caused the CVT pulley system was far apart hence the engine would need longer time to shrink for lower gears hence turbo was over spoofing and lack of power
once the reset is done, the CVT pulley system is at its optimum position and all is back to normal

its a learning process and i hope if next time other owners face similar situation, it wont be a panic

cheers!!

This post has been edited by kmhork87: Apr 9 2014, 12:10 PM

Sama bro !!! Gear dia mcm pelik siket...tak smooth !!

Wow Good learning bro!! Glad to know everything is good now.
Anyway i just did my 1000 yesterday and just use Semi Synthetic 800.
Asked the foreman if need to do any ECU reset for optimum performance, the answer is no need to do so.
Somehow i read in forum, we have people who had their car reset during their 1k service which helps FC and Performance.
Anyway i asked if the next service i can buy my own EO, the SA say no... not sure if that is the case in all other service center.... thanks.

my experience is that some service centre allow customer to bring their own engine oil.
but to my opinion, Petronas semi synthetic engine oil feels sluggish after 3.5k of mileage

the reset of ECU after 1k was the first few batches of preve last time when the car felt sluggish..now all new cars comes with the latest software update thats why dont need

have you done anything about it?

im thinking to go to SC and ask them there but my odo is still 400km

IMO, new gearbox will be tighter. If it's hard to change gear. Release the clutch and press clutch fully again then only change the gear. For my car (Persona), I changed the gearbox oil as early as 4xxx KM. Since it's still new, flush out all the debris. Hopefully this helps

wow. thanks a lot bro.
been looking for this for quite sometime.

nice to know ur car is working well now. gd experience.. can you share which SC allow customer to bring their own oil? i not into petronas oil..

where do u stay bro? maybe we can look at each other car to see any different..my milage just over 1k..done 1k servis days ago at mutiara dsara sC..m not complaint about it since i thought it was normal for manual..

I also feeling the gear is less move when it's moving slowly.. a bit of jerking...

Any idea what this small part does and where it belongs to?

I got it in my cup holder after sending the car for car wash.

Underneath the front passenger seat. It is use to hold the weight sensor's electrical cable in place.

how long after you all send to 1k service? got time limit?

huhuhu no one answer me. but i found out is 1 month time. thanks@

This post has been edited by rachel_xxx: Apr 10 2014, 07:37 AM

Anyone can help to take a photo how it should be installed?

Many many thanks.

Small loop holds the cable to be neat. Big loop clips to the metal bar under the seat