Look cun yo ... lol
But, I think the gold change to red more nice. Dunno la, I just imagine only...

It would have looked too menacing (black + red)

does anyone know where to get spare PolyCaps parts for HGUC..
I lost a part after it dropped on the floor...
Cleaned my room and still couldnt find it.

very sad now

This post has been edited by notfree25: Feb 15 2014, 07:12 PM

You can buy polycaps at many stores. Try check out at Gamersarena.

Thanks i checked the online site but no luck.. maybe need go to the store..

I still dont understand how it can just disappear

This post has been edited by notfree25: Feb 15 2014, 07:22 PM

Or you can just call them and ask first

Hmmm... ya o~
Actually black gold also not bad , look luxury hehe

I'll be going there next month to get a HG sengoku or RG strike freedom anyway.

Maybe it will reappear before then...

Hey everyone,

Just got a Nu ver. ka and I'm now thinking of spray painting the inner frame to a silver metallic color. I've read somewhere that gun metal works well with inner frame coloring but have not seen the color in person. Any thoughts or suggestions on this? Thanks~

Perilly's color

yes the drying will be slow, it tends to get a little runny and the ratio is also abit hard to get right. Its more suited for hand painting then ab, but so long as u get that milky consistency u can spray it out of ab no problem. Again while worked its not recommended, just think of it as cheapo alternatives or last resort in case u suddenly run out of thinner midway through ur painting.

When you guys assemble RG SF, the chrome part and the inner frame that you guys respray, all also being masking taped when applying matte top coat?

turn A fans. your wish is granted

anime accuracy test.. verdict : not bad

anime accuracy test.. verdict : not bad

this one is star build or build?

body frame is pretty much the same.. only difference between star build and build are the armaments, backpack, and that lower leg armor piece to accomodate the extended part with pink clear piece

mustache is a bit off... mybe it's just prototype

just wanna ask some expert which tools are u guys using i newbie here but i love gunpla n mecha i got 5 mg 2rg n 2 valvrave model all with nub n spurt making the gunpla looks not so nice how to cut it nice and making it nice need help.may noe which cutter using ?

im a cheapskate so i use normal boxcutter knife, these days i dun even bother sanding anymore. I just cut the remaining nub with the blade, careful though, abit hard to control as you might dig in too much with the blade and accidently chip off too much from the nub