Now de car ad in Kilang...Will take it back this afternoon or evening...
Most probably evening ba~

Now de car ad in Kilang...Will take it back this afternoon or evening...
Most probably evening ba~

My left rear door also hard to close when i got the car, power windows kaput 2 times on that door. Suspect because of closing the door too hard. After adjust the latch then no problem.

My problem is de door pasang senget a bit bit...
Can see it clearly tat de passanger door does not match with de front door,
de passanger door is pasang slightly higher a bit than de driver's door...huh~
forget to take picture...

U go COSE?

Take pictures lah. At least, other new owner can be aware.

This post has been edited by Fubar20: Jan 28 2014, 11:58 AM

i got the opposite, always upshift around 2-2.2k, then drop to 1.6-1.8k like that. mayb i press pedal too soft.
weird but sometime i wanna try acceleration, it will always upshift at 4k rpm, nvr exceed that. i tot it will at least go to 5k rpm like that.

all my door super easy to close, especially front left, some more i need to pull/resists it from falling close hard, that is the best 1 after so many cars i have sit.
but left rear after close will have gap, from behind it looks like not closing properly, but in fact it was closed. everyone sit my car sure tell me your door not closing properly. since it was also easy to close, i just ignore it...

Paisei la...I jz realize that i forget to take picture after i leave de service center...

Yes, my front also easy to close.
When i adjust my rear left door latch, i need to choose either easy to close but have gap or no gap but hard to close. After many trial and error i choose between of them. If gap to wide scare rear passenger hear outside and wind noise.

sad, why rear left cannot make it easy to close and tight like front left? but my rear right ok also wor...

Purple Persona 2009 Reporting in! just put subwoofer and 2 channel amp and installed JVC headunit , Now my steering control cant be used!!!!!!!!!!!

this car service isit reasonable??
i felt like i kena water fish...
starting just want repair bearing,then boss said absober mouting all rosak...
then terpaksa repair lor,cny need balik kampung.....
front wheel bearing 2unit =rm190
pump in & out bearing 2unit =rm50..
front absober 2unit =rm350
absorber mouting 2unit=rm170..
to replace front wheel bearing &absober=rm130(not sure wat is this,forget to ask)..
alighment rm35..
balancing rm24..
total rm960.34........

My Persona “Blackmobile” finally back again to my home...Hmmm...
De passenger door "recover” ad,
"Boom", de whole car like having a minor earthquake when "smashing" the door...

This post has been edited by FreakyRookie: Jan 28 2014, 05:01 PM

Front absorber RM350? Slightly on the high side, cause you should be able to get it at around RM130 ~ RM150 per piece from spare parts shops. Balancing is front wheels only or all the wheels? The shop I go to charges me RM5 per wheel for balancing. Alignment on the other hand costs RM25.

Black? Send it for detailing and it'll look very good

drillzzzz please!!

When re-charge battery via USB port, no response
How to solve?

That HU's USB port is not meant to charge phone.

haha..same as my situation for 1st time use

Vroom!!!