They use the leftovers from BLM? hmmm...

Majority people now all look at your house and cars...lucky my wife not..I 1st dated her using a C20 van...

But my brother in law also bump into many problems with his wedding. Mostly from his wife side. The mother in law....very picky and keep giving him a hard time. Sigh.....Not that I talk bad about him, he also don't plan his own wedding properly all last minute and all need my mother in law to do all the stuff.....he and his wife langsung don't know what they do...I also advice him wedding need to plan early and guide him what need to do and given him suggestion but he like no feel one. He never try to learn every step himself because he always rely on my mother in law and she also didn't let him be independent.

Because my wife and I our wedding A to Z we plan ourselves so my mother in law was less stressful and feel more happy...old people so don't want to give them too much pressure but my brother in law is totally terbalik.....My wife also say he not ready and mature to get married at all...after married my mother in law has to take care of his wife also because the wife also abang adik with my brother in law mia attitude. I se my mother in law these few days also didn't sleep and fall sick jor....sigh...I want to maki my brother in law also cannot after sure muka hitam one...

I know some friends like these, both husband and wife also not mature enough to get married, much less have kids. Very susah ppl around them, help also bukan, dun help also bukan, especially when it comes to the kids. Tau main saje, dunno the meaning of sacrifice or compromise even for their own offspring.



This post has been edited by dares: Sep 18 2013, 07:26 PM

tq bro. sikit lagi soalan..bagus tekan ke tak bagus tekan sat ni.
contoh naik highway.. tekan?
dalam bandar .. tekan?

millage at 500KM

aq bace ni hingus rase macam mau keluar...pui

Go read your car owner's manual, in the car transmission specification there, look for the gear ratio of your gearbox.

If ur is old gearbox, the ratio should be as below:

1st 3.333
2nd 1.954
3rd 1.285
4th 0.926
5th 0.755
Final 4.705

After that open your driver side door, look at the bottom of B-pillar (center pillar), there is a silver plate that printed with vehicle load and some other information, if you find a word 'MFA30A', confirm this is achi pokai gearbox from old BLM/FL.

Anyway, curious to know your manual SV speedometer is BLM/FL type or FLX one???



This post has been edited by coolkwc: Sep 18 2013, 10:05 PM

when is your turn ?

BlM meter, seat also blm. Tmr I go and check manual

This post has been edited by adriangan: Sep 18 2013, 11:09 PM

also post here the gearbox code from B pillar (driver side door)
picture will be best

Achipokai GB 9k++

Getrag GB 4k++

Faitit bai SV liao

David, this remedy works for manual gearbox. How about cvt gearbox? Can use this method?

Also do you know any places in Klang valley has this 'safe place' to do this stunt?

Vampire, it does not matter mt or at or cvt because the engine is using the same fuel injector.

For BLM/FL Automatic, use your L gear and hit on the 1st gear pull until 7krpm. Repeat the procedure on 2/3 gear.

For CVT, sadly your car is already running on it's pace. You can't possibly pull it because your gearbox will auto adjust it's driven pulley. Trying to pull a CVT, you're risking to disband the CVT belt or scratch the pulley. Bear in mind the transmission aint cheap. I strongly suggest to send your car to do ultrasonic vibration cleaning. Don't ask me where, cause even my Dengkil magician doesn't have this kinda service. The last time I clean my injectors, he uses SINGER oil, plonk battery power to injector and let injector blast SINGER oil nia The only time I did vibration cleaning was in Ipork with my previous magician on my Plotong Wigra 4G92




Sadly, the only safe place with adequate UP HILL(so I can fully utilize my pull time), I can only choose MEX Seri Kembangan bound. But it's still not safe, because other car would think I try to race them, manatau I sampai redline ady let go of my gas pedal Other than that, if I'm in Northern KL, I'll use Jalan Kuching Utara to sprint.

This post has been edited by davidke20: Sep 19 2013, 02:03 AM

for auto 1st gear is ok. second gear if at 2k rpm pedal to metal it will shift to 1st gear wor. same as 3rd gear.
how?

Ya wor hor. I ran out of idea then. Magician only told me to do that to manual cars. So, if there's no other way, ma use the vibrator lor

lhwj

i everyday drive makcik style.

U need to up to 3k only can wot and it wont downshift.

FL auto hamsap king has spoken.