Guys. So its time to change my engine oil. Before this im using m7. Usa and also japan. Thinking of using royal purple, anyone penah try? Okay x? Thank u.

Owh and idea how much is the cost to repair the drive shaft?

Anyone interested to buy my sprintex supercharger setup?

Planning to retired and change car

PM to discuss

Guy I need help.. One day I went one u open car park park car before entering the tiang went down hit my spoiler while half way down I sped hit the bum break my splitter. So I claim from one Utama for the problems.. Lately I feel my car feeling bumpy at 0 -15 km/h. Why ? What happen? It's like moving on a rocky surface.. But on a smooth cement condo parking.. Check tyres are alright no stones on over or less air pressure. Do I need to do wheel balancing ? When I leave my hand steering go straight so means not alignment. Just the bumpy like a flat tired feel. Help:((

Absorber?

Not sure.. While I hard break it steer to the left... The bumpy feeling makes me phobia of stepping the pedal down.. Afraid it will break something.. Not sure the brake caliper or what... Need to bring to SC soon.. Might be rubbing something.. Cos on smooth cement road it still not moving smooth.

This post has been edited by hydeist6055: Oct 9 2014, 12:50 PM

If SC kenot setel this problem, send to nestum

yeay..
manage to DIY changed rear muffler.
from stock CPS to Matola muffler (2nd hand only... heheh)




changed front speaker to carrozzeria speaker.
i thought stock speakers are 5" .. turns out actually 6". so use back the stock speaker holders.

Youu guys so pro lo diy haha.. How you remover the door panel ? The inside plastic part ?

@nestum????

door panel easily removed.
undo the inner door handle's screw. pull it up to remove.
then u will see 2 screws hole. undo the 2 screw inside (this screw hold the panel to door frame).
remove the door lock knob by turning it counter clock.

pull the panel from below then along the sides.. it is secured by multiple white 'clip' to door frame.

Yeah his shop in Jalan Ipoh~

Fuh naisss..

use jack to change rear muffler?

use stock jack and jack stand.
just jack left side, put jack stand. spray some wd40 at exhaust bolt undo the bolt.

the exhaust rubber hanger easily remove by spraying wd40.
easy job coz the muffler part only hang on rear muffler.

oic...

..lol.. See words seems easy.... Once do hilang missing nats hehe.. I can't do this type will get worst... Too SYg my car.. Just hopefully can fix the bumpy part. You guys notice the dashboard compartment beside got like the hydraulic pump to open close ? Yours loose? And making those shit sound those like tuk tuk sound

This post has been edited by hydeist6055: Oct 12 2014, 06:22 PM

very easy actually..

u sure the glove-box hydraulic making sound?

Ya bro.... It's definitely from the hydraulic pump dash board area.. Know how to fix it? Try used tape tape certain part still cant.. Keep making noise. (((

try remove the entire glove-box 1st. test if got sound. then try install back the glove-box without the hydraulic.