this one still using old ecu, can the rpm shoot up to 1.2k rpm....
i missed the good old ecu where i can get 500km 100% city drive...

actually i dont mind the noise anymore. but i can't wind up the window unless i did it manually which is quite hard also

Which is why i prefer to DIY all problems that can be resolved for myself because taking leave to go sc to fix the problem and then the problem recur again is a freaking waste of my leave and time.

my Preve previously has this problem also.
but before i go to service centre, it fix by itself..
now it is ok already.

wind up the window manually and hold the up button for 10 sec(forget how many sec)...it will recalibrate the window auto up&down setting

Did u DIY your engine mount as well.

Yup. Did that. Last time will take 2 weeks b4 it occurs again. N then the interval getting shorter. Now cannot anymore

I did DIY for the following

1) Engine Mount
2) Apply silicone at gaps at the front windshield plastic to prevent windnoise (apparently, proton use cheap stationery double sided tape which is crap and i had to reapply using 3M double sided tape)
3) Apply silicone at plastic garnish at rear left passenger side.(went to SC to change rubber lining once and still got wind noise, later found out it is because of broken connector inside the plastic garnish, thus got wind coming in).

Not confident to ask SC to do the rectification, technician memang tak mahir and best part you will see scratches and dents after they do the rectification. They do not have passion in their work.

Guys, I'm getting very frustrated with the lack if GPS map update for our CFE.

I'm eyeing this: http://www.pioneer.my/ProductDetail/defaul...=1395&CatId=240

My priorities/requirements:

1. Good GPS with regularly updated maps (That means Papago, Garmin, iGo or Galactico maps from malfreemaps.com)
2. External mic for handsfree
3. Responsive UI.

Budget is max RM3k. If can get cheaper, more value for money, all the better.

Any recommendations?

Thanks in advance.

Can't agree more on the bolded part..they even make more difficult now by not doing it own weekend or if u send your car in the afternoon.thats why we need to depend on ourselves to do it or by forums.why did u use for engine mount?silicone as well?
I noticed mine vibrates especially when moving on a slop at low speed..

This post has been edited by hbgoh57: Apr 19 2013, 02:43 PM

Can you show how to do this? wheres the gap? if have picture then good..

Anyone bought this?
http://www.facebook.com/media/set/?set=a.5...17057559&type=3
Need review on this unit lol

hi guys, it is possible to get 5k discount for preve cfe variant?
any good SA can recommend around KL area? thanks

Look for vincent818 in this forum..u can get even more than that

Loan approved
Should can get car after next week~~~

Buy 8mm fuel hose...forgot the length already...make sure enough to do four sides. It will stop vibration but can reduce a bit.

Ah...will try.....

oh ok..so just slot in between the gap between the mount and the body?thanks

You need to buy cable ties to ikat the hose..

The link on first page for List to be checked when receiving your Proton Prevé is missing?