SF9512DSL : 1 X 3 pin power socket
SF9812DSL : 1 X 3 pin power socket come with replaceable tel module SKPXDSL (cheaper replacement cost)
SF9512DSL MS2+3 : 2 X 3pin & 3 X 2 pin power socket
IT Pack : 4 X 3 pin & 3 X 2 pin power socket and support up to 2000w

SF9512DSL MS2+3 : RM93
IT Pack : RM123

I will provide discount from the price above...

for setup A, u can use MDSC0039 + SP9201DAF
for setup B, u can use STV9511 for power and antenna

anyway, my daily location in glenmarie too...



actually u can use 10A model for 13A equipments... 10A still can support 13A current... usually equipments wont full load 13A all the time... Cal-Lab concerned that high power consumption equipments which may hit higher than 13A+++ and may over load their products, that why they recommended 10A for safe side.. anyway, i can use their 10A model for 1HP air con without doubt...

This post has been edited by gkl83: Jul 21 2010, 11:50 AM

if u means PC equipments and telephone ALL located at the same place...
and dont have wired lan cable networking from other PCs to ur modem router... here the example setup...

RJ11 is just a registered jack type as market standard...

there may have different data type go passing thru RJ11 jack...
example: telephone / fax = analog; broadband = digital

usually RJ11 only used Pin 2 & 3 for voice... but as your information KeyPhone system used Pin 2 & 3 for voice call, but Pin 1 & Pin 4 for data (display the extension status, direct line usage, etc), for this kind of KeyPhone system u may use other model for 99.9% compatibility and 99.9% protection...

It is not about "wire to wire" direct connection... As broadband is a "sensitive" application, any interruption in between will cause the disconnection, that the reasons need to design a specialized model to suit with broadband and able to support higher speed (4mb+ speed)...

assumed RJ11 can cater up to 4mb, then dial up modem (56kbps) should able to support 4mb too since is the same RJ11... why dial up modem cant support the speed & reinvent the wheel? bcos dial up modem only support analog interface, and the telecommunication provider reuse the market standard (RJ11) for broadband (digital interface) as concerned cost efficiency, reduce the lowest cost and bring the best functionality...

FYI, as heard may have "broadband over power cable" in the future, and replace RJ11 due to costly copper wire, so Cal-Lab may come out another model to support such technology too... FYI, Aztech have such product "local network over power cable" and Cal-Lab built another new model for 3 pin power socket interface to support it without interrupting the power and networking speed...

This post has been edited by gkl83: Jul 26 2010, 02:58 PM

Cal-Lab dont have all in one product due to the cost of production and may less demand...
but separate the modules may good as well bcos u just to replace the damaged module only without change whole unit...

for ur case, may look alike like this...
u can give me the detailed information and i will draft out the diagram for u...



Cal-Lab previous have the insurance with AIG... due to the hassle to maintain the agreement, less demand for buyers & efficiency of Cal-Lab, the management decided no tied up with insurance company as they confident that their product can 99.99% against lightning...

as long as your installation done correctly, provided all the required information & followed my recommendation, 99.99% wont be a problem...

sorry for late reply...

1) question:
do u have other wired lan cable to other PCs beside your laptop?
do u have telephone nearby ur laptop & router?

2) question:
have any antenna connection?
any telephone nearby your TV setup?

Thanks.

1) u can use MDSC0039 for power + SP9201DAF use as your ADSL Splitter Filter

2) u can use MDSC0039FC for power + astro protection...




can i have your detail of your PC equipments around?

This post has been edited by gkl83: Aug 18 2010, 05:36 PM

1 pc to 1 modem only?

limited budget?
i just worry the surge may come from other PC if wired even though protected by cal-lab
here the example of the back surge from other source...


i can recommend u if the proper setup but need cost additional RM100 something...

This post has been edited by gkl83: Aug 18 2010, 07:03 PM

here the proper setup...


u can buy SF9512DSL, SF9812DSL, SF9512DSL MS2+3 or IT pack only... but cal-lab cant guarantee ur equipments under 100% safe condition as the surge can come from student's room...


if u means 2 PC (desktop + laptop), monitor, chargers, modem & router ALL located at the same room/place... and no telephone/ADSL splitter filter located in your room... then u can use SF9512DSL, SF9812DSL, SF9512DSL MS2+3 or IT pack

This post has been edited by gkl83: Aug 19 2010, 02:06 PM

very minor effects... any filtration definitely will cause some resistance in between...
Hence, sold Cal-Lab product here for 3 years, none of forumer complain their speed effected bcos of Cal-Lab unless damaged by lightning...


u means u looking for Cal-Lab product which replace power wall socket?

sorry for late reply... here the differences...

NILI-PLC-GBH WPS1+2


NILI-PLC-GBH USO-3



Cal-Lab dont have a master protection for whole house as it wont efficient to against lightning surge...

it all depend on your equipments setup... i cant recommend appropriate setup if u no informed me your complete equipments setup...

the surge can come from other PCs and lead the surge to ur router & PC thru lan cable
hence if u have telephone nearby ur equipments, the statcis built by telephone enough to kill sensitive equipments

anyway, we cant judge the source lightning / surge as it can come from anywhere...


since the port rusted, believe the picture quality will effected too...

u can try to do enquiry with cal-lab show room whether their replacement unit can be provided to replace ur old 9511, believe they allowed too and can be replace with another working unit with RM25 even though u used for 10 years...

their show room at bandar utama and here the phone number for enquiry 03-77268680...

This post has been edited by gkl83: Aug 28 2010, 03:52 PM

Cal-Lab dont have other branches beside Bandar Utama...

the only method to send in for restoration was thur courier toward to Muar...
but recommended to call in to Muar office and explain ur unit's condition before proceed with any actions...

The promotion (50% Discount & free hamper) only valid for bulk purchases up to certain amount...
Hence, this promotion doesn't apply on me as i no working direct under Cal-Lab...

For more inquiry, please call 03-77268680 look for Auntie Lucy / Mr Calvin for more detail information....

Room 1: you means splited into 2 islands within the same room? is it the power drawing from the same power socket? it your TV connected to antenna?
u can use SFTV9622FC for power + antenna + astro + telephone protection. Otherwise u can use MDSC0039FC for power + astro protection if u dont have antenna connected to your TV

Room 2: for free hassle, u can use SF9512ARD as it will protect ur AC adapter and standard 3 UK power socket. Otherwise u can use TJP9633, but the jack size or voltage of AC adapter may vary, required your information about your AC adapter power output before get the TJP9633 for you...

Room 3: have any PC nearby ur modem & router? have any wired lan cable to your router?

Room1:
Can help to draw a top-down vide of your room? need to understand where ur equipments & power socket located

Room 2:
you can use SF9512ARD if u dont mind the size, bulky bit if compare to TJP9633...

Room 3:
if no single wired lan cable, what u need to protect is power + broadband, u can use SF9512DSL or SF9812DSL...

Setup 1: you can use AV Pack for higher range with multisocket which support 2000w. otherwise u can go for MDSC0039FC (1000w) if dont have antenna connection on your LCD TV & no telephone nearby ur TV setup...

Setup 2: you can use IT Pack for higher range with multisocket which support 2000w. otherwise u can go for SF9512DSL (1000w) if dont have PC to PC networking (only 1 PC connect to your modem, dont have other PCs connected to router) & no telephone nearby ur TV setup...

do your have any PCs / telephone nearby ur PS3 setup?
have any PCs connected with ur modem & router?