all Cal-lab come with UK plug only.
You may change to desired plugs but the lightning protection efficiency may vary if compare to the tested standard setup.


Fiber inputs from TM? Is the analog telephone side by side with TM equipment?
any physical LAN cables from router to other PCs?

for home alarm system, u can use SD-4C for power and LAN protection.
however RJ11 tel cable and each sensor cables may required to protect along too as those can lead the surges into your system

Fridge you may use NILI9920F

About the auto gate, best if you can advise the voltage spec of motor and push button.
I can proposed the right BOM as different auto gate system have different spec and design
http://site.callab2u.com/Clients/callab2u/...%20-%20pro1.bmp

i dont have physical shop and none of cal-lab reseller are authorized to restore cal-lab unit.
Best if you could email to callabhq@gmail.com for the restoration request. At the same time you may purchase new units from Cal-Lab while they returning your restored SP9201DAF to minimize the delivery cost on single trip.

standard power socket only up to 13amp / 2000watt.
Cal-Lab 10amp can support up to 1.5hp air con.
if you have requirement for 3500watt, your PC setup is almost about total 3.0hp air con total consumption. you sure for that?


nope, Cal-Lab dont have ELCB or MCB unit. it simply a "middle man" between the wall power socket and your equipment.
TRM series have universal socket but usually come with 1x universal + 2x UK.

there have a DIY version which the cal-lab module allowed the open-ended cable to connect into.
but this required some experiences on basic power cabling to install it.

for 6 power sockets. You need both combination as below
TRM-NIF-3 BU+PE
TRM-EP-UK2+US1

you astro operating with satelite dish? or via internet?

Hi y4ng,

Cal-Lab units are mixed with UK and international socket.
You can get a single socket with multiple extension cord but no recommended without electrical experiences.

u may use TRM-NIF-3 but special build request required if expecting for 3x international socket.
some charges may apply for this.

possible to use this models but it mainly designed for homeplug purposes.

SC0039 cable about 10cm long.
MDSC0039 cable about 1meter long.

check the model no from label beside the units.

If your Unifi modem connected with fiber optic cable.
Astro dish via satelite cable to your decoder.
You may use MDSC0039FC

1) SC0039
2) MDSC0039 (if fiber optic inputs and no LAN cable (To PC) connected on router)
3) NILI9920F + X number of MDBNC (iif camera with BNC connector)
4) NILI9920F
5) SC0039

Hi, sorry for late reply due unavailability during weekend and holiday.
You may use TRM-NIF-BU with 2 units of SLAN8CG for this requirements

Location A: if the Unifi no connected to other PCs via wired LAN cable. Whole setup you can use TRM-NIF-3 for power protection only.

Location B: Whole setup involved with power source only, you can use TRM-NIF-3. As the vacuum cleaner, I recommended to use separated power source instead due to high power requirement, you can use SC0039 for bypass the existing power cord.

you can use SC0039 for WiFi repeater if it no connected with any physical wire
the Unifi connect via copper RJ11 connector?