1GB performance ram won't do squat if your games requires more than 1GB. I'd take slower but larger memory modules any time.

For heavy applications such as gaming, larger ram makes more difference.

Safe to say that, in this situation... quantity wins.

even in AMD systems? so far i heard in AMD systems, the clock speed is important. is this true? if thats the case which one would bring more benefit to an AMD system? tight timings or high mem freqs?

Some bench with superpi

There's no point if you have 1GB of superfast memory with supertight timings if your applications uses more than 1GB of ram; causing your hard disk to swap disk.

You will encounter better experience with more ram in this case. It all depends on how much ram you're using in your daily applications and games.

wow, nice clocks there..

cant wait to power up my uccc on this neo2....
gosh, where should i get good psu in jB?

Super PI 8M @ 280 MHz 3-4-4-8 1T

nice, up to 280MHz

thanks... now trying to stabilize it at 290 MHz.

apacer 512MB ddr400 with UCCC attached found at viewnet lyp today..
i didnt bring enough cash to grab 2 stick.. sigh

4 more stick left..

Check the PCB before you snap them.

yeah...lucky like me...my apacer using bp pcb on chip dt-d43.

look for other chips for 1GB kits.. there are better ones for 1GB..

just grab two stick today to try out..
its a BP pcb..
as babyelf said, not much can it do tho.. 260Mhz @ 3-4-4-8-1T @ 2.8Vdimm(2.9V will be the same result)..
coz of the single sided maybe..
neway the corsair VS 1gb stick with UCCC+BP pcb also got there at LYP..

This post has been edited by newbieockids: Feb 14 2006, 07:50 PM

OT:

any other nforce3 user here with uccc pc4000, but cant push it beyond ddr520??
for some reason, im stuck at ddr510.. test with a venice also same..
but i can tighten to 3-4-3-8 @ 2.6v
i need a solid proof, if its nforce3 limitation, coz getting a nf4 board means i need new GC too

nforce3 with bt-d43.... masuk book ke?

if it's nforce3 limitation, then i'm in the same boat as u.... pengsan la nak upgrade mobo n gc

using venice?
tried sideeffect's 1.c std, tccd, ballistix, no go..
borrowed e6 venice also a no go..
but at least u r on 2.5-3-3-x , while im looser at 3-4-4-x @__@
2T wont help either..
and i dont think switching to nf3 ultra-D is a wise idea

-------------

any secrets to burn-in low voltage rams?

This post has been edited by e-jump: Feb 15 2006, 07:59 PM

mine's a winnie, but since u've said u borrowed an E6 Venice also no go, then i just assume that i wont have better luck other than changing both mobo and proc..... and also the video card. AArrrkkkk..... well at least i can run my ram at 240Mhz @ 2.5-3-3-8

at last this apacer UCCC perform a little bit better..


2.5-3-3-7-1T maxed out at DDR 500..
superPI 1M successfull at DDR 490..


3-4-3-7-1T maxed out at DDR 570..
superPI 1M successfull at DDR 560..