isnt the Command Per Clock at the bottom pretty damn obvious?

then what rig is this?

after the test,i set the ram timing in bios to 2-3-3-6,but it can't boot,it even report bios failed,it only boot after i reset bios and ram timing 2.5-3-3-6...

if tight timin isn't possible, go figure bro... i'm pretty sure ya c0 can handle higher fsb...

no no no...no oc liao 3.0ghz enuf for me liao

juz abit of oc, no harm one, btw, intel oc is not as complicated as a64 wat...

wait i fix my WC 1st

CMX512-3200C2PRO XMS3202 v4.3 0549109-3 = Samsung -5 TCCX

this one is mine...got back from RMA last month (year)...that was my second rma for the same stuff...it's a twinx...first rma, got tccd...second time got this one...previous can do 285@2.5448...this one can do 305@s.5448@2.90v...didnt try higher...but i guess, it wont exceed 310...now running it at 300...

Ohh. perhaps that explains why the TCCD never make its way to my door.

Oh, btw you guess? c'mon slap a lil' bit of vdimm to it. Oh, but you must remember to get some sort of active cooling if you did raise the vdimm, otherwise there goes another RMA.

hehehe...luckily didnt send it to you bro, if not you'll be cracking your helmet why the modules cannot push any higher ...only realize it when i ran single stick memtest...anyway, thanks for the kesudian...
hehehe...havent try 3.0v yet...maybe later on...

running memtest...standard test not just #5 or #7 or #8...all tests...wanna have a confirmed stability test...as of this morning, pass 7 tests...still running it when i left for work...running at DDR620@3.00v...and yes, i have 2 x 80mm fans running on top of those sticks.one stick is located under my xp120 wing with delta tri-blade pushing down the air...3.1v is kinda scary for me...dun wan to rma again since this baby is a good stuff...will post the memtest screenie later...ciao

try lower the voltage.
even 2.8v is a scary figure for me now.

haha...that one is for testing...running 24/7 at 300@2.80v...btw, corsair warranty is up to 2.90v, izzit?

the reason for not using 3.0v, is not that RMA will be reject but the RMA can't promise to get the same chip again everytime.

u r certainly rite bro...u never know what u gonna get once u rma'ed...

wah.. clock to 300@mhz.. how u all do it? my 1 max is only 250.. T_T

how do u do this .. can u teach me... step by step .. .. pls

Ask tungtung, i sell 1 pair to him lastime...
but i think is because overvolt, the ram screw up, can't do 300 now...

done with the memtest at DDR620@2.5448...dis wan wif 3.0v...


hope can push higher...sorry for the blur image, no DC la...only camera-phone

This post has been edited by remysix: Jan 9 2006, 08:35 PM

it's not xms3200pro rev1.3, right?