Thats actually fuel sipping onto carburetor and you will find its hard to start again immediately... not sure what the cause but I got the experience. It will start normaly after awhile

Naturally shorter than other brands la... haiyo dont mean its really short short short veli short those kind ...

I just floored on a slope at 5th gear... Got 2 sounds actually...
One sounds does sounded like knocking. Do you mean the tin can might not be that "kosong"? Cause it doesn't sound like "kong kong kong" but rather very thick walled and small tin can with lots of marbles...
Another sound is basically whole car shaking+jerking+dashboard+steering+4 wheels going to torn apart sound... Even the battery light also flickering dy if I dun downshift immediately

See all these poison everyday in this thread hand very fast itchy one

Second that...

Perhaps really short circuit? or the relay?
VS might help... I had seen satria neo meter flickering like mad until someone gave him a VS.
Problem solved without changing the meter...
Better wait for sifu to reply or just go to a trusted wireman to check up your headlights wiring...

Ok... So it's not my distributor timing advance thingy... Will see la...


Whats this port for? The two pins shows zero resistance towards each other but it is not ground itself and not 12V supply also...

How to access power window switch? Can't pull out although loosen screws on cup holder and leg there...

This post has been edited by cyanboy: Dec 8 2011, 12:25 AM

hey. i currently using ron97 on my 1.5 carbo engine.

do i need to tweet the engine it if i wanted to switch? my friend told me carburetor no need to retard the engine, only those with injection without auto timing must tweet.

any advice?

I guess Osram Night Breaker Plus should be sufficient . for Iswara/Saga its H4

EDIT : .. Can get it for 90bucks... and its better than previous version of Night Breaker ( without the Plus )

---

Added on December 8, 2011, 1:31 am[quote=cyanboy,Dec 8 2011, 12:23 AM]

I just floored on a slope at 5th gear... Got 2 sounds actually...
One sounds does sounded like knocking. Do you mean the tin can might not be that "kosong"? Cause it doesn't sound like "kong kong kong" but rather very thick walled and small tin can with lots of marbles...
Another sound is basically whole car shaking+jerking+dashboard+steering+4 wheels going to torn apart sound... Even the battery light also flickering dy if I dun downshift immediately
See all these poison everyday in this thread hand very fast itchy one
Second that...
Perhaps really short circuit? or the relay?
VS might help... I had seen satria neo meter flickering like mad until someone gave him a VS.
Problem solved without changing the meter...

- Thanx.. ll check out whether really short circuit or not.. planned to plonk in Osram Nightbreaker Plus .. heard it is now better than the previous version without the 'Plus' .. major improvement on lifespan and its road legal


Better wait for sifu to reply or just go to a trusted wireman to check up your headlights wiring...
Ok... So it's not my distributor timing advance thingy... Will see la...


- Yep bro... not distributor.. its the carburetor.. and what i personally encounter is... wen i change air filter... n engine oil change to castrol magnatec semi .... it stopped edy...

This post has been edited by hammerclaw69: Dec 8 2011, 01:35 AM

Yes the tin can with lots of marbles sound. Thats the engine pinging. So if you retard the timing, then pinging won't happen so easily but you lose a lot of power.

Have no idea what the other sound is, sound serious if everything seems to be falling apart and batt light flickering...

This post has been edited by poolcarpet: Dec 8 2011, 06:16 AM

which other brand can last how long?

Duno haha... im using night breaker plus too.. i think i post b4 the brightness of the bulb..

http://forum.lowyat.net/index.php?showtopi...post&p=42531629

Around Rm 90-100 only... behind the bulb box also got diagram shows that thier lifespan is indeed lesser than other brands but as long can last me at least 1 year thats fine for me... See the brightness for urself then judge.. u wan buy or not lor.

This post has been edited by Peekab0o: Dec 8 2011, 01:54 PM

How old is your saga? Happened to my High beam before and Happened to my aircond switch recently. Changed my air cond switch twice and both switches melt due to the heat ,
Went to the aircond shop, he said the wire old or sumthing so short circuit. He did some wiring and its fine now, as for the high beam prob, the mechanic just added a cable to skip a plug which seems to be causing the short, The plug melted too

Check under the steering wheel for any signs of short circuit. Normally one plug there will melt

Wow bro why use ron97? so expensive

Anyone interested for straight flow muffler? Trompet style. Letting go cheap at RM40 only.

Mine LMST 6 years edy bro... was using Phillips bulb ( not sure wic version ) bright white one... it last me 5 years wo ... but d headlamp plastic get damn hot ... so d 5th year end its kaput... n oni d right hand side low beam...

Den i change to some german brand HOD bulb.. was better than the phillip in terms of d white light and never blind oncoming traffic.... used that about 6 - 8 months nw d same right hand side low beam kaput....

some says , it is related to relay.. n not sure which relay cuz i didn add any relay for headlight ...

n coincidently.. my reverse light for rear left lamp kaput also... so.. not sure whether ada short circuit ke or related to relay....

duwan 2 kena poison by foreman lar... any seefus can confim what could be the cause?

EDIT : N bro.. i guess you're talking about fuse... if fuse blow.. the entire headlight will kaput wo.. ini juz left low beam.. haiz.. din wash car.. din kena rain.. duno hw lar.. m not using any voltage stabilizer, no power amp .... was juz using led strip connected to small lamp kat headlight ... n that oso remove edy wen i change the headlight ( taiwan made )

This post has been edited by hammerclaw69: Dec 8 2011, 08:18 PM

I think 6 years your cables should be okay. Im not talking bout the fuse lol , for my car the whole cable heated up and melted the connections of the headlight to the switch on the steering wheel. For my car, the cables were old and heats up due to resistance. For your car , now im not sure anymore

heated up and melted? dayumn... thats reli bad and if im not wrong you have to re-do d whole wiring for your car right?
yeah me too nt sure watz d cause


n another thing is my rear absorber worn out too soon... using kayaba... standard oil wan... about 6 months d... nw keras edy...

is it advisable to change spring afta 6 years? cuz im thinking that , if the spring went too soft.. the absorber can worn out faster... wen use my fingers 2 press d spring it .. its juz goes too easy compare 2 new stock spring...


now thinking twice whether wana change d spring + absorber or just the absorber... any advise seefus?

My 12 yr old iswara still using ori spring! Springs hardly go bad unless you overload very often. If it's easy to press down, it's a sign absorber koyak, not spring. If spring koyak, i believe the car will sag down, i.e. lowered as the spring can no longer support the weight.

So go get yourself a pair of ori kayaba gas or apm performax rear absorber i think rm130 or so per pair and just change the absorbers first. Labor prob rm30 to 50? I'm guessing, cause i changed all 4 plus lower arm and labor was rm100. Probably cost you less than rm200 for this.

Falling apart means dashboard all use clips only lo... Batt light flickering means sudah mau mati engine...

Whats your phillips or HOD bulb Watt rating? If you use like 110/120W bulb with stock wiring confirm connector habis, headlamp habis fast and reflector also habis fast... I read this somewhere...
Cause kedai abang say if I wan use their promo less than RM10 H4 110W bulb need pull another wiring to settle...

Today went SC for 30k service... Manyak mahal... But for the sake of the service book stamp, okla...
Complained about the air con pretensioner bearing... They say no prob, add lubricant then jalan... Now still got eeeh-eeeh sound at high rpm

Check your bulb socket carefully, LMST are prone to melting the headlamp socket.....

yalor. now must change already. if not pocket fast empty. so do i need to retard the engine or not?

Will my signal be seen with NB+? It looks so bright

http://paultan.org/2011/12/10/proton-mobil...lmst-and-gen-2/

this is free installlation ar?