i get i get the rough idea thanks but wat you mean custom cable ? do i have to unsleeve it to make it custom out from the "OUT" box?

I dont really like acrylic casing myself. But if you wanna save the hassle, perhaps you just need to arrange your cable to make it neat is more than enough. Line them an area which don't block the airflow and tie them up nicely will do.

Actually having this kinda casing is fun actually...if Doom has one god knows where all the wires and management will go...
His pc is allwayz clean.
You can alwayz paint the behind mobo side panel if you want to hide the cables and wires

Custom cables mean u buy the wires, pins, molex connector, heat shrink and sleeve, build the cables according to the type of connector and length for exact routing distance from the hardware to the box ..

so the custom cable would connect to the PSU from inside of the box ...

Here is list of my case...


Lian Li PC-A05


Lian Li V1000


Lian Li G-7


Lian Li PC-A10


GT-7 (Lian Li 007-OEM)

clean or not up to you guys to judge .. for me there's never close to clean

I used to have same case like urs. But now my lil bro using it

Here the reference site

What i just do is, I put some of the cables beneath my MOBO..oh yeah u can see the spoiler to view the mess at that side of the case. And to hide that spoiler, I use to add some kind of 'poster' at that site (or else u can tint that side as well)


Cheers! I really miss my case

Waaaaaaa Doom I luv your case,GT-7 (Lian Li 007-OEM) and Lian Li PC-A10 if compared to mine hhaha

Well managed again doom...

superb management .... that rollers u have is nice, i saw it on other thread. If just the rollers , they cost rm 75

Here are some comparison with my previous attempts and my latest attempt with the cable management without cutting any part of the casing. My rig also went through a few changes, from changing Asus 945 mobo to GigabyteP35 , and the FreezerPro swap back with Intel Stock cooler.


1st attempt



2nd attempt



3rd attempt

Not bad ... if only u don't need to front audio port that would reduces cables passing by mobo ...

thanks Doom....i got to learn alot from u guys also. Very good reference and comparison resources. The front audio port is quite essential for me cos i will use my headphones from time to time.
Notice that i use the Lian Li 3.5inch diskette drive cage to fit my old IDE harddisk at the CDROM drive bay?? hehehe....

hmmm .. .I thought it was an optical drive on first sight ....

hahha ..good job ...

ic ic .. probably sleeving those cables becomes black would reduces inconsistent looks of the cables. ..

kengkhim, pretty nice at far look. Do you have a closer image? Wanna check it out.

This post has been edited by stevenangelus: Aug 14 2007, 11:23 AM

very shame this is my 1st attempt to manipulate the cable actually inside quite messy. Any sifu can teach me this small small gal.

Looks decent. If you can hide the cables to the other side of your case, that would be better.

I think it's a very good job to think about the case that used ..

CM series is poor in cable management as there's no place to route or hide the cables much ...

unless cutting the case for cables opening is done .. else it's hard to go any further from current setup ..

difficult to hide cos the hardisk power cable not able to get through the other side, and the sata cable for both hardisk and cd-rom difficult to bend it.

Well, maybe. Mine also something like that. Hehe... Will post my RIG image later when I have the time.

ALL SO NICE!!! I DUNNO HOW TO CABLE. coz im too newb