I wan to knw where shud I stick the rubber seal
to prevent air noise..
tqvm
> LYN Proton Saga/Iswara Drivers' Forum! V24, Still running strong as seen on the road
|
|
Jul 10 2011, 12:57 AM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,055 posts Joined: Feb 2009 From: Selangor/Johor |
anyone can show me the pic of our car's door?
I wan to knw where shud I stick the rubber seal to prevent air noise.. tqvm |
|
|
|
|
|
Jul 10 2011, 01:01 AM
|
![]() ![]()
Junior Member
178 posts Joined: May 2009 From: in thes lulz |
|
|
|
Jul 10 2011, 07:37 AM
|
![]() ![]() ![]() ![]()
Senior Member
548 posts Joined: Sep 2005 From: Mars |
i had the same problem (aeroback).. if yours is aeroback, try this:
1. Open the boot and remove the clips holding the interior plastic garnish in place 2. Visually check and make sure no water inside 3. Open the boot to the highest position and confirm no water leaking 4. Install back the plastic interior and close the boot 5. Now take a hose and wet the reverse light 6. If your reverse light now starts to look like aquarium, that's where the water leak is. 7. Get ready 2/3 pails, open the boot to the highest position and start collecting the water that's leaking out from the corner/sides of the plastic interior. 8. Remove the plastic, and look for signs of water around reverse light. I had to remove the entire plastic rear garnish and then the reverse light (extremely difficult, exercise caution as those are plastic parts and can break easily). Then I sealed the reverse light fitting with RTV silicone (that's the only thing I had with me). You can probably go buy the rubber/foam gasket from spare parts shop and slowly replace that but I took the easy/lazy way out. Mine's not leaking so far, tested and I don't have aquarium reverse light now. QUOTE(GMS FearLess @ Jul 10 2011, 12:41 AM) |
|
|
Jul 10 2011, 09:58 AM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
2,144 posts Joined: Jan 2003 From: Kuching, Sarawak |
Hi guys, my Iswara generates a jet plane whining sound when i push the throttle higher. This only happen when aircon is on.
The aircon also not that cool anymore. According to some forum, the compressor might be dying. So, any sifu here that ever experience this problem b4? Is it really my compressor going to kong soon? This post has been edited by Berserker: Jul 10 2011, 09:59 AM |
|
|
Jul 10 2011, 01:49 PM
|
![]()
Junior Member
5 posts Joined: Dec 2009 |
QUOTE(evolution120 @ Jul 9 2011, 01:43 PM) Sorry but please baca properly =)In 1990, the line-up was revised with the introduction of 12-valve Megavalve engines, which increased power ratings to 75 bhp (56 kW) (from the original 70.5 bhp (53 kW) in the former 8-valve (Magma) version[6]) for the 1.3-litre engine, and 90 bhp (67 kW) for the 1.5-litre engine. The info given is for your 12v engine . Not 8v . See that i already highlighted it out . Increased power ratings from the FORMER << IT Means BEFORE . But i duno how accurate that info is . Just probably for reference . This post has been edited by Peekab0o: Jul 10 2011, 01:49 PM |
|
|
Jul 10 2011, 02:25 PM
|
![]() ![]() ![]() ![]()
Senior Member
548 posts Joined: Sep 2005 From: Mars |
Nothing beats the spec in orig manual, i have it still. here goes:
1.3l engine model 4G13 1.5l engine model 4G15 Max output (DIN) 4G13 62kW @ 6000r/min Max output (DIN) 4G15 67kW @ 6000r/min Max torque (DIN) 4G13 109Nm @ 4000r/min Max torque (DIN) 4G15 126Nm @ 4000r/min Hope this helps. QUOTE(Peekab0o @ Jul 10 2011, 01:49 PM) Sorry but please baca properly =) In 1990, the line-up was revised with the introduction of 12-valve Megavalve engines, which increased power ratings to 75 bhp (56 kW) (from the original 70.5 bhp (53 kW) in the former 8-valve (Magma) version[6]) for the 1.3-litre engine, and 90 bhp (67 kW) for the 1.5-litre engine. The info given is for your 12v engine . Not 8v . See that i already highlighted it out . Increased power ratings from the FORMER << IT Means BEFORE . But i duno how accurate that info is . Just probably for reference . |
|
|
|
|
|
Jul 10 2011, 03:00 PM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,055 posts Joined: Feb 2009 From: Selangor/Johor |
oh i see..
I think mine is 4G13.. yesterday try finish whole tank.. full tank can go for 440KM.. Shell RON 95.. |
|
|
Jul 10 2011, 03:25 PM
|
![]()
Junior Member
27 posts Joined: May 2009 From: Penang |
|
|
|
Jul 10 2011, 03:52 PM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
3,128 posts Joined: Sep 2006 From: Earth |
|
|
|
Jul 10 2011, 03:58 PM
|
![]() ![]()
Junior Member
113 posts Joined: Nov 2008 |
|
|
|
Jul 10 2011, 04:16 PM
|
![]()
Junior Member
27 posts Joined: May 2009 From: Penang |
|
|
|
Jul 10 2011, 07:05 PM
|
![]()
Junior Member
30 posts Joined: Jul 2010 |
what is those kw and torque mean?
|
|
|
Jul 10 2011, 07:22 PM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,055 posts Joined: Feb 2009 From: Selangor/Johor |
|
|
|
|
|
|
Jul 10 2011, 08:03 PM
|
![]() ![]() ![]()
Junior Member
432 posts Joined: Dec 2010 |
Today there was an accident near my office.
Suzuki Swift kena pawn by Proton Saga LMST. The Swift terbalik 3 times over and the driver covered in blood. Saga warrior rulez! |
|
|
Jul 10 2011, 08:16 PM
|
![]() ![]()
Junior Member
178 posts Joined: May 2009 From: in thes lulz |
QUOTE(DSV4600 @ Jul 10 2011, 08:03 PM) Today there was an accident near my office. wah.....that saga lmst belong our group member...what coincidence......Suzuki Swift kena pawn by Proton Saga LMST. The Swift terbalik 3 times over and the driver covered in blood. Saga warrior rulez! from facebook...the owner itself QUOTE Guys...im fine...thanks for the concern... The Swift terbalik 3 times in front and in the side of me....and i need to fork out RM150-200 to repair This post has been edited by GMS FearLess: Jul 10 2011, 11:06 PM |
|
|
Jul 10 2011, 09:44 PM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
2,499 posts Joined: Apr 2005 From: Tyneside |
QUOTE(GMS FearLess @ Jul 10 2011, 08:16 PM) wah.....that saga lmst belong our group member...what coincidence......Zeno Valentino is the owner Bro, you got PM...from facebook...the owner itself That's what actually will happen if your ego is too big and dont want to lose against Pariah Malaysian car... Hope that the Swift driver is ok though... We never race and he is the one tried to drive aggressively and reluctant to let me overtook him in the first place.. That part of the road actually 'ate' alot of cars already...at least one or two cars in a month...my ex office just in front of the corner... |
|
|
Jul 10 2011, 09:48 PM
|
![]() ![]() ![]() ![]()
Senior Member
548 posts Joined: Sep 2005 From: Mars |
quote from:
http://auto.howstuffworks.com/auto-parts/t...rsus-torque.htm "In other words, torque lets you do the work, but horsepower lets you do the work quickly." the power values above = horsepower. the higher the torque and horsepower, the more powerful the car engine is. go find out how much power/torque a bugatti veyron has QUOTE(piecereborn @ Jul 10 2011, 07:05 PM) |
|
|
Jul 11 2011, 12:54 AM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
2,499 posts Joined: Apr 2005 From: Tyneside |
Besides Dr Cermin, any other shop that can replace side window at reasonable price?
|
|
|
Jul 11 2011, 01:53 AM
|
![]() ![]()
Junior Member
178 posts Joined: May 2009 From: in thes lulz |
|
|
|
Jul 11 2011, 05:28 PM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,055 posts Joined: Feb 2009 From: Selangor/Johor |
anyone use Sachs Absorber b4?
any review here? |
|
Topic ClosedOptions
|
| Change to: | 0.0189sec
1.12
6 queries
GZIP Disabled
Time is now: 24th December 2025 - 09:00 PM |