haha.. at klang, kampung jawa.. =) they remove all gum, repaint the roof beam, use new gum.. but they dint remove the windscreen.. they juz cut the whole roof off and left the front part about 2cm-5cm wide, then hammer in and place the new roof on it.. they actually only nit 2 days to finish it.. but i ask them to do slowly as i juz came back from melaka juznw.. haha.. so i left the my car with them be4 i go to melaka.. and i told them not to paint my car 1st.. 2mr morning i'll go check with them.. if i satisfy with the weilding.., then they will start painting.. estimate 14/10/11 11am can get my car

GAB absorber got a lots of fake products worr.. n i donno read from which blog be4, they mentioned tat GAB are sucks! some went to enous and replace their for 2-3 times d but still got problem.. so i think i wont choose GAB
any others nice comfort brand? i still got my 1.6 spring with me.. i juz nit absorber! i nit extreme comfort type..!!

---

Added on October 13, 2011, 2:19 amand the front lining they free for me.. but the side lining they use back my original 1, only change clips if broken~ so far my lining very nice also.. =) the car dealer change for me when i got my car few years back..

This post has been edited by AhKoo: Oct 13 2011, 02:19 AM

Oh..I see..post some photos here for tomorrow visit
Photos tell everything..

They got "guarantee" that the cancer wont coming back to you?

I also wanted to change the roof..but I have no car to use..Don't want to apply leave for car anymore

but i donno how to upload here.. i try upload at my fb.. u go c ok?=) u try borrow from ur parents or gf ba.. no choice.. change roof minimum 2 days!
http://www.mudah.my/Monroe+Absorbers+Honda...+6-11361439.htm

http://www.mudah.my/New+Set+Absorber+Origi...ton-9756792.htm

http://www.mudah.my/Absorber+Sachs+Proton+...+6-11285145.htm

which 1 nice? n do u knw gas type or oil type better?

GF no car..my dad need to use car..

Ok..then I'll wait for your photos

You dont use Whatsapp meh? I msg you no reply

Yo! All sifus, for Wira 1.5 Auto (1995 Model):

1) What engine can be install in this car ya? Thinking to mod my engine
2) Usually can just mod the engine? Or there are also other parts need to be modify in order to fit the engine?
3) Roughly how much is the cost to do the mod.

Thanks in advance.

too bad, haha//maybe u can rent a car? =p
ok, no problem.. photo will be uploaded 2nite!
i uninstall whatsapp d.. got a bit problem
normal sms me ba..

1) 4G91, 4G92, 4G93 (SOHC, DOHC, Turbo)
2) if you buy halfcut, just transplant everything inside. if buy engine kosong, then you might need other thing such as the ECU, fuel pump, intake manifold, etc.
3) anywhere from 2k to more than 10k.

Get 4g93t. No problem. Good running engine. Transplant into mine 3yrs ago. Till now no problem.

cik cik dan bang bang, hopefully i'm not invisible ><"

*cabut*

what did you ask about ar?

what is that??

Confusing

i am asking about absorber mar..
which brand are u using now?

I'm using APM Performax. Not bad, quite stable when cornering. But after 8-9 months already not good, now if I got bring people, the car lowered too much, and always kena road bump.. and cornering now very wobbly..

i think ur problem can be solved by adding "Coil Spring Buffer"
confusing, donno wat brand should go to. worry later too soft then jialat.. but i wan comfort

I got a Coil Spring Buffer about 3 inch...use only less then a week....PM me if u wan...hehe.......

I am using IMP Comfort absorber whole set for my sedan Wira. Red chilli colour look so ganas. It is a gas and hydraulic type. For my rear, i pair it with Waja coil spring and using original coil spring buffer. So far handling very nice and comfort.

I have been using sachs for 3yrs at least. No problem till now

Sifus, can recommend me a reliable tachometer for my wira 1.3GLI(M) around rm 100 to rm 150...

How often u see games with the Wira in it?