Qled 55inci where buy cheap?

That connector at the back is some sort of service connector not for audio.

Get an Optical to Analog 3.5mm output connector Converter.

But be careful, not sure if they downmix the full channels to stereo or they just output the L/R channels only, which means no center channel (voice) if original source is 5.1.
---------------------

Come to think of it you can always select the PCM option at the Tv to downmix first for you before output to the converter.

This post has been edited by Ngto: Aug 25 2017, 02:15 PM

The 3.5mm connector at the back is meant for service engineers. On the quantum dot displays for 2016 and 2017 that port is used for autocal via Calman. I hope to try it out in the 65KS9000 soon.

I read if you go into the service menu by using the convential remote (combo keypress) you can enable 2 extra profile mode for calibration and saving the settings, Cal1 and Cal2.

I hv not verified if that available in Asian firmware.

cheapest is seng heng and best denki. i bought at seng heng RM7,999.

Probably hard to get now. Anyone know where can buy ks7000?

I don't think the back of ks7000 is glued. How are they going to repair or change the panels if the back is glued.You must have been reading a lot of those foreign nonsense comments. Those people sure can make absurd assumptions, lol.

Actually I would think the back uses Clips that hold the back cover in place. It's when the clips are of low quality and break or wrong size (loose) that cause the back to detach from the main body.

This post has been edited by Ngto: Aug 28 2017, 10:32 AM

Actually it is a combination of 3M like double sided and some clips.

Source :- Saw ppl seperating panel before from stock TV.

You can get cheaper in Samsung Flagship - SenHeng Stores in SS2. (Samsung SIS Store)
Not all Senheng are Samsung SIS store. So far I only know SS2 is the SIS store.

RM7299 with 10% rebates. Price shown without discount yet. After discount is around RM6XXX something.
Above rate only applicable in Samsung SIS store - Senheng SS2.

This post has been edited by ukiya: Aug 28 2017, 12:42 PM

Double sided tape and glue big diff

Haha LULZ sorry XD

My KS7000 start to be a bit loose at the top left side. Can feel there is a small gap. Pray hard it wont separate more haha.

I can push it in but it wont stay "clicked" in.

It havent reach the point it have a gaping hole yet so no light is entering.

Samsung MY is aware of these issue. If ur still in warranty, give them a call. They will come and fix it for u. FOC.

Just take a pic when it gets more serious and email to them.

I added a little calendar before my 2 years is over so I'll probably give them a call by then (or when it get worse haha)

It's not that bad yet, just a small bump that I can push in and it pop back out

jeez.why u tell me this? i just throw 8k.

thank you boss

just called to confirm. its 7899. the 10% rebates is for next purchase. pheww

oops ... I m tot u r d one who going to buy. Sorry.

Yup 10% rebates for next purchase.

Saw Samsung 49" MU6300 and also 49" MU6303. Can't really differentiate what is the difference of these two. Anyone notice it this new 49" MU6303 which cheaper in price?