Wahh beraninya run High FSB

hehehe.....

high fsb low multi.... aiming for this combination nowadays....

dah lama tak kacau my AMD.

repairing my P4. so bz with that....

lifetime waranty..but if when the ram die, want to claim bak oso susah.... i only got 1pc of tis ram.

if i up the voltage to like 2.8v or 2.9v, without ram sink can the ram overheat?

btw...i am using all stock cooling...so if i hav to up the fsb higher, i'll need more vcore and the cpu will be proly more hot.

the rams are okay at 2.9 volts
those that need cooling are those running above this voltage like 3.0-3.2
2.9 is okay for daily operations
my ram has been running 2.9volts for ages and without problem.

ok...i believe wut u said.
will try it later at 2.9v! lets see if it can up to 400mhz without any weird problem....

GOOD LUCK BRo. TELL us the results....

erm...

i think 2.8 and 2.9v would be ok.. no prob...

i have been running mine at 2.9v and no heatsink or ramsink or spreader.... works just fine....

Good Morning Fellow Abit Users,


I just changed one of my Kingmax DDR 400 with a DT-D43 DDR 400

it seems that my Memory Frequency dropped from 420 to 410 ...

is it because of the different timings both rams have ??

what chip is ur kingmax using?
do u still using the same timing as b4?

i tried to set the voltage to 2.8v or 2.9v and oc my ram to ddr400 but could not POST.

What chips are on the RAM? (i mean what does the black chips say?)

it is a kingston's chip there. not hynix or anything else...

Couldn't remember what chips...

but

the timings are still the same as before..

well,

still collecting money to get another Dt-D43, My TCCC are on their way. shud arrive tomorrow.

MY upgraded AXP is up and running.

INSTALLED new COOLERMASTER 450 ACLX and WATERCOOLING KIT and 9550V+

maybe wud do some tweaking today or tomorrow...

You go for the xpert, dude. good choice.

hehe...

thanks...

erm.. here is the pics of the old rig..

BeFORE ....

Hahahah... same casing as mine...... but, well.... i've modded mine. throw away the shutter, potong the lower part n added JMC 12cm fan for hdd cooling, paint flat black for the interior, cut the back honeycomb blowhole, enlarge the sidepanel to 12cm fan....

COOL...

i still love the shutter though...

sidepanel mod will come soon..

well here is the old and new.




After.

wow! cooooooooool!!!

i have a question though.

shud i remove the rear 120mm Fan or the 2 x 80mm Fan ??

i think the 120mm is restricting air flow, shud i remove it , or replace with a better CFM fan ?

or shud i remove the 2 x 80mm Fan ? and let the 12cm does it work on its own.

i think u muz check and see if the 80mm fans are faster or the 120mm faster. if the 80mm are faster, then try remove the 120mm. if the 120mm is faster, then no need to remove anything.

For Sure the 80mm fan is faster, than the 120mm,

before the 120mm was unplugged, the amount of air flowing thru the rad was GOOD.

but when the 120mm was plugged, the amount of air flowing was kind a bad compared to when it was not plugged in.

maybe i shud remove it or, get another 120mm which is better. and remove the 80mm fan.