If you plan to change every 10K then you better modify it into timing chain, no need to worry anymore

so inserting that small valve means have to drain all the power steering fluid??....

No need, when the mechanic install it, he pull out the pipe,after insert the orifice valve he just insert the pipe back, that's it.

bro, the power steering fluid will be drained. because the rubber hose is located at the bottom of the tank. but what my mech did was, he used a sucker to suck out the fluids and stored it in a clean container temporarily. then cabut the hose and fix the orifice valve and refitted it back to the tank. then pump back the fluid into the tank.

done my 17km service...its my 4th service..1st time done at 3rd party service center apart from proton sc...total rm200++...change air filter, oil filter, engine oil, tyre rotation, wheel balancing & alignment..& labour cost; but i've been told to change chamber nuts...my rear wheel is +1.50 if not mistaken..per tyre will cost about rm35 rear; front rm25...its the price reasonable??? anyone care to advise? or any cheaper solution? is it recommended to do chamber??

This post has been edited by krk24: Apr 12 2010, 03:39 PM

next time, drive 10km/h less than speed limit all the time

the container is plastic and the hose is made from rubber... how the metal sound can came out from that.... Oh well, later go back home, i'll inspect it closer. My serdang fc still dont have stock for the valve. It is selling like hotcakes in every sc

So after u installed the bootlid, your cabin got quieter?

This post has been edited by heavencloud: Apr 12 2010, 03:46 PM

just done my 1k serice today, total, RM111.25

Look at things positively, you dont need to worry about timing belt if you change it that frequent

hehe...

wats hapening on proton ya? my SA mentioned now they pending / temp stop the production of M , H line Especially Auto......dam..i need to wait for few week again to c wat proton gona announce..dam regrate,disappointed on proton..

This post has been edited by roundedfly: Apr 12 2010, 09:47 PM

is that true? i also booked h-line auto, but my sa didnt tell me abt this. any1 can confirm?

as some of my persona frens also mentioned the same thing..thats why now almost produce on B line or MT only...otherwise i should get my car this week liao = = haiz

what is the root cause? any1 know? hardware problem? software problem?

it's plain damn silly and ignorant. its a laughing stock really. try it and post it back here on the experience gathered from mechs. cuz nobody does it.

---

Added on April 13, 2010, 12:25 amcabin quieter? nolah. just look nicer and when closing the boot lid it sounded more solid than before. that's about it. oh, the boot interior does not heat up that much compared to without the padding. its cooler for my amplifiers fitted in the boot that tends to heat up under the scorching hot sun.

This post has been edited by jasondotcom: Apr 13 2010, 12:25 AM

ok enough.

its his car, so let him do what he wants.

Do u think worth to get those imitation Megazin Pivot? Scared will kong the ECU only



http://forum.lowyat.net/topic/1163927

This post has been edited by muslayer: Apr 13 2010, 10:55 AM

Actually what is the origin country for Pivot....

origin = japan

i scared later install fried the ECU. Anyone one else install this VS and any side effect ?

I think is better to get the original one... its should come with warranty if any damage for our car.... correct me if im wrong...

it just connected to the battery only, anything to do with the ECU?