ahpaul82 - one member from seremban did...improve quite a bit...he just change muffler...still maintain the stupid catcon in his cps...

Ultima - one seremban persona members already did installed full exhaust system...mind u this s-flow for gen2 only...for persona the box a bit longer...to use gen2 everco s-flow have to modify the piping a bit...performance wise better use gen2 s-flow then a persona s-flow...

i think bottom of my car muffler has one small tiny hole,
therefore i wish to change it ..
you make me gatal to change leh...

just change woh.. won't regret wan.. :poizon: :poizon:

did u change ur header? i mean remove the catcon n replace with 4-2-1?

if not better change that oso or after a year ur s-flow will make another hole in it

anyone here using 195/55/r15 yokohama c drive or falken zeix 912 ???

what is the price around sunway/pj area ?

vexus - im using gy duraplus, sori...

shazmn - so means using gen2 s-flow better? modifying piping means they hav to weld it a bit?

This post has been edited by Ultima: Jan 26 2010, 09:52 PM

hehe,
in consideration liao

but i love this one :


I'm still using stock header.

let me try to capture a photo and show you the hole tomorrow...

ultima - yes welding a bit...if do full exhaust at our place consider everything done la...u wanna test drive the persona i'm talking about?

ahpaul - the holde usually caused by corrosion from the exhaust waste being changed into water and some gas cant remember but i do remember there are water droplets among the deposits...it is done by the catalytic converter to ensure no pollution etc etc...the pros of it is less polluted environment but the cons of it is most of the time it corrodes ur muffler and ur midbox till some extent the fiber could fall of from either ur midbox or ur muffler and u get loud noise from it...another cons of it is the gas flow is restricted and engine breathing not smooth thus ur car underpowered...

try maxxis victra....160-170 only per piece....

where/which location is this price referred?

i asked at Pj taman megah Maxxis shop quoted me like 200+++ per tyre. 195/55/15

hock li kapar klang next to kedai papan...but that one special order oni...

if want i can kawtim oder from them...170

Yes, i understand your concern.

here is the tiny hole:


i don't think it will cause bad impact for the time being right?

This post has been edited by ahpaul82: Jan 27 2010, 10:49 PM

exhaust got hole means a hole in ur pocket due to FC increse

cant use selotape to close the hole ka?

i think with a simple welding can close that hole

so small hole also will increase FC?

ya, planning to visit exhaust shop soon,
see whether they can cover the hole or not first.

my colleague going to give me this one have a try first :
3M™ Aluminum Foil Tape 425

ekceli if got hole in front section(between header n bullet area) confirm fc increase...if muffler i think not much difference kot haha..just weld a bit enuff

patch here bocor there. Very soon only. Change the header bah...

want to ask everybody, is it normal its soooooooooooo hard to turn the ignition on?

to turn the key la... mine so difficulttt

turn the key or to start the engine?

nope... mine starts very smoothly. the only problem i got during engine startup is finding the keyhole at night...