good job. TIP - Don't take photos facing direct sunlight/light source.

Anyways, amazing Gunpla Mancave here :


This post has been edited by carpathia: Aug 31 2020, 12:02 AM

Entry grade kits are here! The EG RX78 is so damn similar to the HGUC Revive

sudah lama tak masuk sini.
recently just finish this short anime and bought a mecha of it.

How much ? nice ?

around rm95, small yet detail.


This post has been edited by limfreelance: Sep 1 2020, 05:17 PM

Not bad wor.... might get it if only my backlog not so big.

anyways, genuine question for you guys -
have you guys continued to buy gunpla like normal or have reduced due to the covid 19 impact on the economy ? i think the market is going to get worse next few months so im also pulling back

If you guys need any advice on gunpla and plamodel building, you can try talking to Chee Lam AKA Oldman - very friendly and helpful chap lives in KL. Usually you will see him in GBWC doing demos

hi guys, planning to get my first PG. Which would you recommend as a first PG? I've built numerous MGs in the past e.g unicorn ver ka and Red Astray. Currently deciding between the PG Perfect Strike or MKII. Happy to hear your opinions!

PG Strike. Affordable PG around Rm500.. Decent quality.
Or go for PG Exia(non lighting version) around Rm650-700.

I suggest hold on the purchase as the PG RX-78-2 Gundam was announced last January but no official release yet.

This post has been edited by nazrul90: Sep 3 2020, 07:59 PM

Perfect Strike. Definitely one of the best PG out there. Still eying this one. I got the old PG Strike and PG Strike Rouge. Will purchase it when i feel want to fix another strike. if only they release the new part version.

+1

saw few places and got their prices..

RM850 is what i get the cheapest so far. forgot where though

Why not PG Exia ?

Hi asking for advise from sifus.

Currently doing hand-painting, any reviews or opinions about Moshen or Skull Color paints? Is it better or comparable to Vallejo paints?

All incoming new kits !

get a AirBrush (AB) compressor at shopee (KKMoon). it cheap. 25 PSI is quite strong.
color Paint have 3 categories base: acrylic base, enamel base, lacquer base. so, when u need leveling thinner for mixture, u need to get the same base.
recommend get Mr color (lacquer base).

Finish 1/35 GSC OBSOLETE - MODEROID Exoframe. everything look good, except need to add detail for the inner cockpit.
if u like Maschinen Krieger, u must get this kit.

Who is this gunpla fan in KL la....mah hai.....

well for that fix figuration expansive mark up price sure want to check all detail. but then again bandai quality assurance not on my side, my snow white wing zero figure got lot nub mark and some minor paint chip, other accessories no problem.