i80 is a legacy now. If i were you, i will keep it. At least it can become single pc broadband. I think if can transfer ownership, many willing to buy.

I had similar issue like you before.
My speed up & down and i found the reason. It is because the band 3 & band 7 LTE keep switching between.
I disable the band 3, and this issue totally gone for me.

I use mdma, i am using huawei.

You stay at super congested area. B3 is totally unusable. For normal condition, B3 just boost another 5–20m.

There are many factors. Total users at the same time, different network B3/7, signal strength..
Digi is no control the speed, at least for my case.

When there is new network, every telco will reallocate the bandwitdh. Because you have no LTE yet, the 3G network still in old setting. Before LTE, some areas can reach 10-30m with 3G.

Yes, peoples get error message for registering i150 since yesterday. But not sure system error or stop selling the plan already.

Good coverage can have low ping too. Although not as good and stable as unifi, still better than streamyx.
My area ping 11ms with 4 bars signal.

This post has been edited by wc_how: May 1 2017, 12:46 PM

So fast give up?
There may something can tune for better connection.

Did you lock 4G only & single band?
How was the signal?
When was the time facing unstable? All the time or certain period?
Did you try any other devices?

I will advise you try to keep the plan. If that is digi network issue, try to report to digi and ask for a fix.
In the meantime, request to suspend your line. Don't just terminate it yet.

We may not able to register again any unlimited plan after July.

Should be no problem to use the phone. But remind that you will drop to 3G during calls. To use voLTE, you must have hardware and firmware compatible devices.

I use digi infinite for 3 weeks. So far very stable for me. Speed average 25m(15-40m) and ping at 11-45ms. Sorry to say, ping is even better than laneline for my case(streamyx). If i am willing to invest a LTE-A device, probably stable speed at 50m, but i found no reason to buy yet (too expensive & nothing to do with high speed).

For modem, please invest huawei.

using huawei e3372

Yes, MF910 just LTE cat 4 device. So yes 36m is very good speed.
If you want stable 40m+ speed, invest a LTE-A devices.

Did you try to use the Toolbox someone posted few page back?

Not so sure. Never use a CPE device before. Too expensive for me.
And a little doubt on the performance of CPE before.



Probably best digi speed i have even seen.

Stronger signal doesn't mean better.
Most cases B7 weaker than B3 (because higher freq penetration is lower but speed better).
And most cases B7 speed is better than B3 (lower signal, phone usually won't choose this band, they auto choose B3 because higher signal, battery saver...) So B3 is usually more congested than B7.

But for best performance, you need turn off either 1 band, do speedtest at different time. So you may know which band is better for you.

I am using XZ, speedtest best around 80m for digi. Maxis best at 180m with LTE-A.

Malaysia are usually selling B310s-22 model.
This model is cheaper, because it targets china market and 3G cannot use. Only LTE b3&7 work here.

Here

I read few website, it has external antenna.
But i don't see any RJ11 (or it share with RJ45).

*Edited: I saw a model with RJ11, but i could not confirm which model it is.

This post has been edited by wc_how: May 3 2017, 10:04 PM

I think it i right. -22 support RJ11 while -610 is not.