..

wipe with slightly cloths with little soap, then wipe several rounds with slightly wet cloths after that.

that should do the job.

Alright, i will give it a try.

Thank you for the suggestion

now it works properly d, need to disassemble the whole thing just to install hdd caddy

hi, any generous member with mxm slot gpu willing to help me flash my vbios? please help. thanks.

What happened ?

i bought a dell gpu to use in my clevo. nid to flash the new gpu vbios and my laptop doesnt have built in intel hd. so cant flasht it. nid to borrow some1 laptop with mxm slot to flash it.

You want to flash Clevo vbios in to Dell GPU? what GPU you have? and what is your system? I have laptop to flash for you, besides, I also have the eeprom programmer to do flash work.

quadro k3000m. my laptop is clevo p150hm

What a coincidence I just upgraded a Sager NP8150 / Clevo P150HM from HD6990m to GTX680m.

GTX680m is Dell version.



May I know why you want to flash the vbios?

From my search, K3000m only have Nvidia own generic vBIos and HP vbios.

What problem you facing right now? Laptop can't boot up or it can boot up but black screen?

This post has been edited by e_mc_square: Dec 19 2015, 04:33 PM

Thermal paste suggestion for M17xR4?, My CPU struggles a lot! especially in dota 2. 80C or 90C makes it lag. I have used prolimatek pk 3, it's just okayyy.

You sure? PK3 work very well for me. PK3 is another choice for me other than IC Diamond and GC Extreme. I think you might just put too much of the Thermal Paste? Thermal paste will become worst if you apply too much.

Im thinking about coollaboratory liquid pro
What do you suggest?

pk3 should be about the same as gc-extreme, but it's just like ok for me also. gc-extreme imo is more efficient. however i didn't dip the tube into hot water when i apply pk3 so i might be wrong. i do that to gc-extreme. it has better results in my laptops and desktops, for cpu and gpu (all uses dot method).

i have tried liquid ultra. the results are better than gc-extreme, but the thing about metal pastes is that when it dries, it's hardened making it very hard to remove. you need sand papers to polish your heat sink to make it good again.

imo it's better to use gc-extreme. it's much easier to maintain. also, the difference is just about 1 to 2c. (room temperature)

How often you repaste? once a year?
I never put pk 3 in hot water before applying lol.

True with the sand paper thing for liquid pro or ultra but I feel the texture of 3840QM isnt plain all metal it has a rubber on top feel to it too hmmm.

tim actually doesn't need to be replaced often. they're very lasting. we have no choice because for laptops when we clean the cooling system we need to remove the contacts of heatsinks from the dies physically.

i only do tim replacement when cpu/gpu temperatures under load is above 85c. it's been a year+. they're still below that threshold. (about 80c max for cpu, and about 75c for gpus)

uh? rubber on the die? i don't think so, because rubber is insulator.

where to get gelid gc extreme from?

i got it from storm88.

Artic MX 4 for 25rm for 4 grams or gelid GC extreme 3.5 grams for 39rm. Which one better?

This post has been edited by mansooriqbal: Dec 28 2015, 11:30 AM

Just get what you think worth it then.

Yeah I saw some stats. Quiet close these two hmmm.