LOL..Good thing going with the bezel. I am still in love with it until now. Pretty sure that it will fit most LL case. To be safe, just check whether you have screw holes or not at the 5.25" slot after you take out the front panel..

Yes, one hole should be correct. According to mine ,(hopefully you understand my explanation ), there should be one rivet and one hole on each side of the 5.25" bay. The cdrom panel will have 2 holes on each side (one to fit the rivet, one for the screw). Therefore, if yours are like that, its likely that it will be usable without any trouble..

Anyway, i still remember asking the ATE guy before about the compatibility and he did told me that its compatible with LL casing for sure..

LOL..I remember my cousin said to me that he say the EX33 as well when he was at LYP 2 weeks ago.

@sniper69, did you try any slimmer type of fan?

I do agree with you on this. My cousin's HR01 push-pull configuration performs better than a single push. His Opteron can go as low as 30c.

Anyway, pity you having so many clashes sniper69..LOL..You will have a hard time trying to find the best setup for those big HSF...

@sniper69,

Very good idea indeed but be prepared to clean your rig quite often due to dust..LOL..

I think coolice did use it for his OC demo at ATE right?Maybe someone can ask him whether its good or not about the LL PSU.

Anyway, went to ATE today to look for the patent side panel fan but ATE is out of stock. Apparently, PC-7 cannot use the BS-02 fan as the rear does not have holes. Only BS-03 is applicable..

The way i put mine on the PC-7 is :

Front - Intake
Rear - Exhaust
Top - Exhaust

Just waiting to get my hands on a Side Fan for Intake and mine will be done but too bad ATE ran out of stock. Anyway, with my following configuration without the side fan, does it seem fine?Cause both my exhaust fan are those crazy Silverstone fan that blows out alot of air while intake is only a Noctua which is half the performance of the Silverstone.

After taking out every piece of hardware and reinstall them back, my 8800 suddenly is idling on 63c instead of the usual 58c i get last time. Would configuring the Top Fan to intake helps?Would it be a problem having too many exhaust and only one intake?Cause AFAIK, i have 3 exhaust (rear, top, PSU) and one intake only..

This post has been edited by akachester: Jul 2 2007, 08:55 AM