LYN Perodua Axia Club V2, Loving her more each day!
|
|
 Feb 25 2015, 12:34 PM
Return to original view | Post
#41
|
 
Junior Member
417 posts Joined: May 2012 
|
I like Axia's stability at highspeed the most, secondly the FC, single trip to Penang only cost RM38+ for current petrol price,
if you get that divided by 2 person, it is less than RM20, that is cheaper than any bus tickets  (of coz there's the toll to pay  )Btw, I saw one red Axia Adv that day, speeding at least 140km/h or more i think. This post has been edited by mkmobile: Feb 25 2015, 12:36 PM |
|
|
|
|
|
Feb 25 2015, 12:37 PM
Return to original view | Post
#42
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(mrlongshen @ Feb 25 2015, 12:29 PM) how much the air filter ? The air filter is around RM170. wah ! that so good. Do you install voltage stabilizer ? or grounding wire ?  Nope, didn't install any VS , grounding. |
|
|
Feb 25 2015, 03:36 PM
Return to original view | Post
#43
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(theaxia @ Feb 25 2015, 02:22 PM) Things about using bigger pores (high flow) air filter is, there is a risk of sand enter the intake. It may increase throttle response during low rpm, since it able to suck more air, but i think no significant gain in performance when on dyno. Because the computer already adjust how many fuel needed for any air ratio. Unlike aftermarket exhaust, which removes unnecessary restriction to the exhaust gas. More room for air to come out, means more power able to generate for same duration of time. I used to ride a bike before, a suzuki dohc engine. after using open pod type filter, the piston cepat kotor. Since axia using fully sintetic aka expensive oil to run, quite rugi la if u allow more contaminants enter the engine.. i suggest that only change to high flow air filter if you know the risk.  OMG Really ??I don't know about this, but I have searched the Works Engineering / K&N air filter before buying, and all stated that this type of filter is more dust absorbing than normal paper filter. If it really allows more dust / fine dust to the combustion chamber, then it is really not good for the engine. This post has been edited by mkmobile: Feb 25 2015, 04:41 PM |
|
|
Feb 25 2015, 05:31 PM
Return to original view | Post
#44
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(theaxia @ Feb 25 2015, 04:45 PM) less restrictive means less filtration, correct? Thanks for sharing paper filter maybe not provide good flow during low rpm, due to lower vacuum pressure cannot really overcome the paper "walls", but at high rpm, the paper are designed to provide enough airflow for the engine, even if u put most expensive filter also power still the same.. so during your 10000km inspection, will u still pay for the filter change at sc? i am telling this because i scared there are user suka suka change without knowing the risk, orang tukar, dia tukar juga.. well thats their money, but like the aircond hose modification, i can keep it to myself, but i share it here for free so that we all take good care of our car.. nice read regarding filters http://www.agcoauto.com/content/news/p2_articleid/164 According to the service schedule For 10k service, they didn't change the air filter right ? They only change it on 40k. |
|
|
Feb 27 2015, 05:27 PM
Return to original view | Post
#45
|
|
Junior Member
417 posts Joined: May 2012
|
Yeah something wrong with the compressor. It is too cold even at lowest setting
.I always joke and say, they must have installed the wrong compressor for me, installed the Myvi one.  |
|
|
Feb 28 2015, 12:11 AM
Return to original view | Post
#46
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(Sh@rty 5 @ Feb 27 2015, 07:40 PM)  Today's project , foot light led , speaker upgrade & 4 doors sound damping no more "milo tin" feeling when u close the doors and of course eliminating the metal vibration noise from your door especially when high bass  how it looks like inside After sound proofing it, added our speaker adapter & ready for Alpine speaker , simple upgrade , plus sound proofing =perfect  Might be seeing another member esok, for the usual 4 in 1 Oh ya, we do have ready stock for the front UR bar too   Think wanna open the panel to fix it. Total how many screw to unlock ? I only found one screw in the door handle. Thanks. This post has been edited by mkmobile: Feb 28 2015, 12:11 AM |
|
|
|
|
|
Mar 2 2015, 10:51 AM
Return to original view | Post
#47
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(knight_t @ Mar 2 2015, 10:28 AM) i bought Advance version so i can join this club??  46. knight_t - Penang - Advance (AT) - Red how many ppl in this group already? saw in 1st page got 45 axia owners already. QUOTE(FatBoyDrifter @ Mar 2 2015, 10:47 AM) » Click to show Spoiler - click again to hide... « Updated you two to the list : » Click to show Spoiler - click again to hide... « |
|
|
Mar 4 2015, 10:53 AM
Return to original view | Post
#48
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(elm0001 @ Mar 4 2015, 09:29 AM) picking up my Axia G tonight (after waiting for 3 months) but will only start driving on saturday. dont wanna straight pick up and drive to work next day. my first car! can't wait  same here, when I was getting my Axia, I hesitate for long time whether to drive it to work on next day. In then end I just drive it. Can't resist it  |
|
|
Mar 4 2015, 10:07 PM
Return to original view | Post
#49
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(apecx92 @ Mar 4 2015, 07:33 PM) Now i know where is the 'tik tik tik' sound came from the dashboard around the srs airbag slot and i fixed it (of course use big n long foam tape). LoL Mind to share how you fix it ? I notice it is from the clip at the end of the firewall there. I stick a foam tape there but still have sound.P.S on full tank i get about 530km, average 18.6km 1 more question, refer attachment i set to blow at at front only but why it still blow the wind at bottom?? Sorry for my england, donno how to explain. |
|
|
Mar 5 2015, 04:23 PM
Return to original view | Post
#50
|
|
Junior Member
417 posts Joined: May 2012
|
Rattling sound on door maybe caused by the lock, try closed your door, and push it from outside and see whether it makes the noise.
Mine was on the front left, I sent to SC and they change the lockset. now have another rattling sound on rear left, but this time I suspect is something knocking on the plastic panel from inside. |
|
|
Mar 9 2015, 10:26 AM
Return to original view | Post
#51
|
|
Junior Member
417 posts Joined: May 2012
|
Hi all, please refer to the post #2 for the latest owner list :
https://forum.lowyat.net/index.php?showtopi...post&p=72632589 Have updated and fixed the list. |
|
|
Mar 10 2015, 11:35 AM
Return to original view | Post
#52
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(ZidaneGarnet @ Mar 10 2015, 07:12 AM) My gosh today i heard rattling sound from the back but i dont know from where O.O anyone facing this and any solution? Maybe is from the door, is it rattling only when on bumpy roads ? Try knock on the door plastic part by part and see if you can get back the sound. Better still, get someone to drive the car, while u can check and inspect the back while the car is moving. I read someone here say 36 Psi would hurt the absorber, and cause the interior plastic rattles faster (since it is more bumpy), I pump 33 Psi only now for all four tires. FC still more or less the same for me. |
|
|
Mar 10 2015, 01:21 PM
Return to original view | Post
#53
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(pristine @ Mar 10 2015, 11:43 AM) But isn't that like the recommended pressure, 36PSI/250kPa? yes as per the Axia manual and door stickers, it is 36,but if we look at Myvi, which is using the same tyre size, recommended is only 31, because Myvi is heavier ? |
|
|
|
|
|
Mar 12 2015, 02:36 PM
Return to original view | Post
#54
|
|
Junior Member
417 posts Joined: May 2012
|
Going to install HU and reverse camera this weekend.. hopefully everything goes well
 This post has been edited by mkmobile: Mar 12 2015, 02:37 PM |
|
|
Mar 13 2015, 09:47 PM
Return to original view | Post
#55
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(FatBoyDrifter @ Mar 13 2015, 05:37 PM) guys.. mind sharing your highest average fuel consumption. 50% highway & 50% city (and jam) Average about 17.5 km/l Highest record : KL to Penang, no jam, around 21km/l Spec : Auto G |
|
|
Mar 16 2015, 12:03 AM
Return to original view | Post
#56
|
|
Junior Member
417 posts Joined: May 2012
|
Weekend DIY success! Installed touch screen HU and reverse camera.
The DIY journey really is mix of bitter & sweet   Will try post some pic tomorrow morning. Btw, this week fuel report, been driving till blinking on last bar, filled up 25 little. Average FC this week is 18km/l. Very good FC i think, since the week was full with extra city jam and slow drive. This post has been edited by mkmobile: Mar 16 2015, 12:04 AM |
|
|
Mar 16 2015, 12:05 AM
Return to original view | Post
#57
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(awiekupo @ Mar 15 2015, 11:10 PM) How did you guys do the fuel usage per litre? Is it being shown on the meter? Sry noob.. Coz i only see how many km my car has gone.. Press the stick button on the meter, it will switch from menu to menu. You can see there is one is with AVG KM/L something like that. Once you on that screen, press and hold the button to reset the counter.Any screenshot is highly appreciated. Do we need to press special button or anything? Referring to axia advance model.. Reset works on AVG KM/L, Trip, and also Service (10k KM counter) This post has been edited by mkmobile: Mar 16 2015, 10:19 AM |
|
|
Mar 16 2015, 10:23 AM
Return to original view | Post
#58
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(tonyvyp @ Mar 16 2015, 12:41 AM) it doesn't work on ODO, only the trip. Opps sorry edited the mistake. Yeah ODO can't reset.. E Spec doesn't have AVG KM/L btw.. QUOTE(eniltoh @ Mar 16 2015, 08:24 AM) 👍 i can only imagine it will be a whole lot better than stock HU. How many hours of DIY? Mine still no time to continue 😭 The actual installation actually take less than 2 hours, but I was exploring here and there for the car wiring (for next project maybe ), testing and experiments alot.The radio quality is instant upgraded, no more noise for listening to radio station. And with customizable EQ, now only I realize the stock speakers' quality are actually quite good This post has been edited by mkmobile: Mar 16 2015, 10:23 AM |
|
|
Mar 17 2015, 10:24 AM
Return to original view | Post
#59
|
|
Junior Member
417 posts Joined: May 2012
|
Here is my newly installed HU, now even stock speakers are good enough for me
 : Reverse camera in action:  This post has been edited by mkmobile: Mar 17 2015, 10:25 AM |
|
|
Mar 17 2015, 11:55 AM
Return to original view | Post
#60
|
|
Junior Member
417 posts Joined: May 2012
|
QUOTE(xiongzz15 @ Mar 17 2015, 11:50 AM) Got my car 2 weeks ago and realize the radio is really fuzzy and even on my FM Modulator. Anyone got the same problem and managed to fixed it at Service Centre?. Dont really have the budget to change the audio system now Same here, for me there is certain frequency which is really bad. If you use FM modulator, try set the frequency to 101.xx or above, it may get clearer.After I change the HU, all frequency is clear now, so I guess it is the stock HU FM signal processing not that good. |
|
Topic ClosedOptions
|
| Change to: |  0.0485sec
 0.71
 7 queries
 GZIP Disabled
Time is now: 20th December 2025 - 05:53 PM |
Quote