Hello...

I know that this project shall be considered done already..but I don't think any future modification will harm anyone right? So I would like to post some update for this project..tangan gatal already takde keje..

I tear both side panels to replace it with the transparent black color acrylic sheet..See the glue residue after I remove the panel..



Also do some paint job left from last build..





This is what left from my prodigy build..so I use them..



The end result..





HEHEHE..

The original coolant that was used on this build was Armaggeddon Water Cooling Coolant ARCTIC FUEL 1000 (ACID YELLOW)..but I add some Mayhems deep red dye to make it red..but it turn out hideous
So I plan to change it to UV Green by EKWB..I also change my CCFL setup from white to UV..

The UV CCFL..longer than current CCFL..



The white CCFL



I remove the PSU and will drain the loop..but...no drain valve.. ..huhu see the coolant's color..



After the coolant is drained..I clean all the tube but the plasticizer is too hard to peel off..just look at the reservoir..sorry forgot to take pictures on the tube..



So I decide not to reuse the tube and replace the loop using the acrylic tube..since I have extra fitting from the prodigy build..

Sorry no picture of installation....but look also add a drain valve by koolance under the reservoir..



The end results....











DONE...