a very healthy budget. but u probably should refer to the first page to check out the cherry switch that suit your taste and then the keyboards within your budget range

i go check now..but i hope I can a guidence from those who has a experience and know about graet mkb..thx

what will be your main usage? do you need the numpad, if u dont then go for TKL layout, otherwise go for FULL layout

i guess i'll go for full size

and your usage? gaming? office? do u need LED for maximum bling bling?

yeah..im using for gaming..dota 2 and BF4..my shortlist are either ducky shine 3..hehe..love ducky coz got LED features..but didnt have macro function isnt?

if you want macro function why not consider CM Storm Trigger, Quickfire Pro, Quickfire Ultimate? they do come with macro keys and standard layout so u can change the keycaps when the poison gets to u.

400C is too hot for lead solder
260C is too low for lead solder

You should target 300-350C
400-450C is for lead free solder. You use this when you want to fix/remove switches from stock keyboards. Be sure not to mix your tips.

You can still use 400C for lead solder, but you're gonna kill your components faster if you leave the solder tip contact too long.
Look for the Pb Free logo on the PCB if you are not sure whether your board is Lead free or not.

Are you still wetting the solder with half coverage like you showed during the gathering, or do you wet the pad fully before removing your solder tip? If you assembled keyboards with half-wet pads, those things are going to fail faster because of the lower mechanical reliability.

http://www.circuitrework.com/guides/7-1-3.shtml
Sharp soldering tips are pretty useless for what you want to do. i.e. desoldering LEDs. If you are talking about SMD components, then that is another story. You would want something like this
http://malaysia.rs-online.com/web/p/solder...n-tips/2694045/
Chisel tip , 2.4mm (some call it screwdriver tip)

Generally you want to use the largest surface area contact between your tip and the solder for optimal heat transfer. This means that the solder melts fast and you can suck them out quickly. For desoldering, I use 2.4mm, for soldering I use 1.6mm

For desoldering LEDs, my advice is that you should use the cheaper solder (60/40 type) and add it to the 2 pins until it forms a solder bridge. While heating the solder bridge on one side, pull out the LED on the other, with a tweezer/plier, and then clean the pad. This is the best way I use to remove LEDs. Other methods are just horrible without a powerful desoldering pump, or good desoldering irons like a Hakko 808.

is it good? haha..what do u mean ''when poison gets u'' ? i didnt get it..sry newbie here

they are pretty solid. and im sorry, quick fire pro/ultimate are not standard layout and they do not have macro keys. so that left only CM Storm Trigger or Trigger Z.

what about corsair k70? wht is ur opinion regarding tht kb

what about corsair k70? wht is ur opinion regarding tht kb

dat kibot!! hnnngh... it pretty but i didnt recommend because its over 400 and it doesnt have macro

Signature Plastics DCS profile Dolch Replica.

I think this is not dsa???

maybe r2 or r3 dolch replica keycaps

Dolch GMK for hhkb? worth trading?

Dolch GMK for hhkb? worth trading?

Dolch GMK for hhkb? worth trading?

u no buy viper?