First of all, welcome to the jungle family. Here's some of my opinion, to answer you according to your questions:

1) I believe your car is blue color? If your have that 15" rim, please keep it. The only important thing is, get the correct tyre size, you'll have no problem. U can downgrade to 14, but there's limited choice with the correct offset, small width that can fit our little car. I'm currently using Plotong Wigra 14" rim, sagat tiada, tapi gosok esoba bila buat lock to lock full u-turn.


2) Rekomended tayar saiz, bukak pintu belakang driver side sendiri tengok.

3) Itu belakang, not only bearing so small matter. It's the spindle that hold the bearing kacau. I have experience in 3 months time changed 6 bearings, in the end tayar just tanggal like that when I was driving 100kph++, almost got myself killed.


4) Cylinder brek belakang sudah jam. Common problem for all Shawie, Shaga BLM, FLX. Sebijik RM40 beli kedai sepepat. Harga luar, bih kuang RM80 sebijik, skali upah.

5) Suka hati. I use TESCO Semi, murah lagi sedap. Pilihan yg bijaks

6) Alenmen... seriously I thing tak boley rekomen mia. Selalu saye rekomen orang pi magician aku, lepastu sumthing jahanam aku pulak yg kena sebab I rekomen magician tersebut.

For alignment try MPS Auto in PJS7 Bandar Sunway, this is the place where all the Ferraris, Lambo and sport cars go, mind you, the price for balancing and alignment for my shawie is only RM60, they will align and balance until the boss satisfied, note that might take quite long, as after adjusting car is taken out for test drive until the alignment and balancing is perfect. My favourite place to go now 

For number 3, you can check the record from Proton services center, I believe still free if you are entitle and haven't changed it.
For number 4, bearing cost around RM40-60 but installation cost same with its price or even higher, I changed one as it broke and until now (230K) haven't change again.
For number 5, you can opts for Lexus 5-40 fully sync engine oil as it cost RM100-105

Nah. no3 up until 2011. Proton already stop the replacement program. I sent for checking few month after buy (2009), but didnt replace because lazy leave the car. now regret. already once tercabut. later want to change to gaga type.

no5, use what suitable for your engine. as mine, shell hx7 is not good noisy n very fast dirty. use LM before very good but rm130, pocket  T-T. but now i use HDEO. Petro Canada Duron E. first time cuci engine until 5000km. next interval is 10000km.

3- omg.. 

5- what is LM?

thanks

m.freaconankun may be a chance

Get the spindle fix if you're worry it will be gone.
I'm not sure if mine went for the recall during that time as my sister is the one using the car. I only take care of the maintenance recent years.
LM = LiquiMoly engine oil. Take at look at my siggy

ohh.. okeh... tq..

i really want to change the engine oil by myself. but that day i look under the engine, none of my tools can fit that nut. and i found out my ejos bocor. so replaced the cat con and the muffler. while the car on the big lift, i found out got some oil at the left side engine. suspect gearbox oil. so changed the gearbox oil plus i-sint and service the front wheel piston brake.

next will change tyres or probably downgrde to 14''. i see lots of savvy use 14''. i want to use 14'' with thicker tyre. hopefully 185/60/14 with 14'' 5.5 jj is suitable..

and as i read previous comments, suddenly i remember something.. it is a comments from sifu davidke20.. its something like he explaining some sounds but he typed it.. i remembered how i laughed that night. and i keep reading it over and over again.. omg.. thats funny. i dont how to use the keywords search.. i have to start from v1. like the first time i want to know why my aircond hot and at the same time the speedometer sometime idup sometime kong and sometime dia idup rasa mcm naik kuda. sometime dia kong takde jerking. i took me 6 months to settle it down. somesays this la.. itu laa..

That's me.  Bearing munyik "ngong ngong ngong ngong ngong ngong ngong ngong " bile bawak keatai certain speed. Lagi laju lagi dia ngong. Tapi itu klu bearing rosak la. If not, the spindle will not make noise. By the time you know the spindle kacau, tayar sudah cabut Usually, when your bearing kerap jahanam, that's when the spindle sudah stat haus, that's why the bearing kenot sit still, as a result cipat rosak.

Klu dah jadik amik 14", itu 15" tolong simpan bagi saye. Sile PM saye harga tolak. Tengkiu

Itu 15 manyak syok oo. ori enkei kalau x silap. I jual murah2 b4 now regret. Kasi masuk rota later. haha.

Just scrape off some of my front left rubber. Damn my proride kong ady. Bugima, waste my moneh inject. Anyone wanna sell savvy front left abs. No problem condition plz. Need to ketuk my fender bg kankang besar. Pening kapla pakai 195/50/15. Grrrrr!

its not that ngong ngong... something like mukekekeke,,,muuuueeekekekek.. problem cant start or something about fuel pump.. u can describe the sound exactly how it should be.. it is like u have own the car for 10 years and having all sorts of problems..

ekceli my little bro wants it. the white sport rim. i wonder how thick the tyre can fit in the 15''. 185/60/15 can ha? he plans to install into his myvi..

today i drove from pasir gudang to kulai, lima kali mati oo.. start balik dia wakakakakaka.. xhidup.. after few minute baru idup..
cmne nk check fuel pump?

refer to my siggy

Time benti atau start tu rpm naik tinggi tak?

tak de plak dia naik tgi.. tapi ngah2 speeding fuel pedal trus x respond ..

today i drove from pasir gudang to kulai, lima kali mati oo.. start balik dia wakakakakaka.. xhidup.. after few minute baru idup..
cmne nk check fuel pump?

Try cara sifu davidke20 check fuel pump function ke idok. Yg mukekkekek tu