Welcome Guest ( Log In | Register )

48 Pages « < 22 23 24 25 26 > » Bottom

Outline · [ Standard ] · Linear+

 v9.0 The OFFICIAL 3G/5G Honda City 2011 thread, The new City, where to next?

views
     
Thrust
post May 23 2020, 01:55 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


Just to share with you guys on Honda oil filters.

I have 2 Honda oil filters. I suppose both of them are fake but they are of different gred. The left light blue is of lower grade and the right dark blue is better grade.

The rubber gasket on the left one is shorter whereas the right one is thicker to ensure better seal. IMHO, most of the Honda oil filters sold at our local spare parts shop are imitation filter. These imitation filter have different grade too. If you want to opt for imitation filter, get the dark blue type as they are overall better built. If you insist on using original filter, then you need to buy them at Honda authorized stockist.

Fake Honda filter lower grade (light blue can): RM8-RM12
Fake Honda filter higher grade (dark blue can: ~RM15
Original Honda filter: ~RM29

The internal of both these filters are about the same. I see nothing different in terms of paper filter quality and its anti drain back valve.

Sharing is caring tongue.gif

user posted image

user posted image

This post has been edited by Thrust: May 23 2020, 01:59 PM
Thrust
post May 27 2020, 07:54 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(p_cock01 @ May 27 2020, 05:37 PM)
Anyone has facing aircond prob time que up like drivethru about 5 to 7 minute or like heavy traffic. After that when driving about 5 minutes it cold back. Once change reckon compresor back at early this year
*
Your aircond issue is quite common for all cars. You should let an aircond mechanic to perform the checking. Experience aircond mechanic will instantly know the problem.

The common issues that I can think of are:

i) Aircond condensor fan is not spinning when compressor kicks in.

ii) Low on gas.
Thrust
post May 31 2020, 07:26 AM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(p_cock01 @ May 30 2020, 09:16 PM)
If atf oil below minimum line at  dipstick can i just topup? Just add at dipstick place right?
*
Yes you can top up through the dip stick.

However, atf level shouldn't drop. It is either previously, the mechanic did not top up to a sufficient level or there a leak somewhere. Usually it will leak from the flywheel oil seal.
Thrust
post May 31 2020, 11:23 AM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(babygrand123 @ May 31 2020, 10:35 AM)
The same side spoil again and change it at the same workshop RM300 . NTN Japan so lousy kah and my concern is can last for how long this round? Pray ......
*
Wheel bearing should be able to last for years. In your case, 6 months is a bit too short.

Could it be due to bad installation or other suspension component that are faulty that causes wheel bearing premature failure?
Thrust
post May 31 2020, 05:49 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(cempedaklife @ May 31 2020, 12:03 PM)
Coincidentally, lately during later part of mco, when i drive abit more, still not alot though as i still work from home, im beginning to feel that i can here wuwu sound, or the tyre sound from front more obvious. Not sure if its my front wheel bearing. Have not change it before in almost 9 years. Changed rear about 2-3  years ago. Tyres are all quite new. Maybe max 2 years
*
You will know it is a wheel bearing issue when you jack the car up, shake the wheel at 9 & 3 o clock, and 12 & 6 o clock position. If it moves and there's play, your wheel bearing is bad.

https://www.youtube.com/watch?v=p2nMCRaCspo
Thrust
post Jun 9 2020, 01:33 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(langstrasse @ Jun 9 2020, 12:47 PM)
Hey guys,
I wanted to use a dashcam in my car but found that the cigarette lighter which provides the power is not working.

Has anyone here had the same problem ?
If yes I'd like to know how you guys resolved it.
*
Could be a blown fuse which caused the cigarette lighter / accessories socket port to stop working.

Sometimes, it can also be the USB hub which converts to the acc socket that isn't working.

This post has been edited by Thrust: Jun 9 2020, 01:34 PM
Thrust
post Jun 9 2020, 05:44 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(langstrasse @ Jun 9 2020, 01:51 PM)
Yeah I found these videos on how to replace the fuse, seems simple enough.

Wondering if anyone here has tried it before:

https://www.youtube.com/watch?v=Qfv3KOoZ3lw

https://www.youtube.com/watch?v=I0DDyjFxmso&t=526s
*
Do update us once you've solved your problem. Thanks!
Thrust
post Jun 11 2020, 10:22 AM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(TZ1234 @ Jun 11 2020, 10:06 AM)
Would it be logical to change all 4 bearings in one go? Or it seem wasted on this move? My bearing also make noise after MCO, but not sure from which wheel.
*
No need to replace all 4. Just replace the one with noise. Bring it to a reliable workshop, they will know which wheel bearing is faulty.
Thrust
post Jun 11 2020, 01:45 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(TZ1234 @ Jun 11 2020, 01:28 PM)
Thanks. I just think if the life span is similar. Then it may save the hassle to send to repair again. Experienced from my other old car.
Of course, it's a big buck. 😓
*
Depends on what part. Wheel bearing life span varies a lot. So no point swapping them all at once. On the other hand, parts like spark plugs and coil plugs need to be change in a set. Same goes for tyres, shock absorbers and brake pads and rotors.
Thrust
post Jun 26 2020, 05:55 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


Just noted my engine breather hose collapsed. rclxub.gif

user posted image

user posted image

user posted image

This post has been edited by Thrust: Jun 26 2020, 05:55 PM
Thrust
post Jun 26 2020, 07:07 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(cempedaklife @ Jun 26 2020, 06:44 PM)
Bro which one? I noob lol
*
The one in the circle. If you refer to the previous post, its the one with the beige clamp.

user posted image

This post has been edited by Thrust: Jun 26 2020, 07:08 PM
Thrust
post Jun 29 2020, 12:21 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(90Boyz @ Jun 29 2020, 12:12 PM)
Do you think we can use the carb cleaner the clean the dirty oil at the hose B-1 ?
*
No need to clean hose B-1. That hose isn't covered with oil. It's function is to allow air being sucked into the engine from the air filter box into the breather tube inlet.

I've removed the breather tube (item 5) which is also connected to B-1 and there's no oil stain at all.
Thrust
post Jul 5 2020, 03:22 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(delsoo @ Jul 5 2020, 12:49 PM)
do you know hoe to differentiate the genuine oil filter and the fake one ? there are many part no for the honda oil filter out there  :confused: so confusing
*
I think the original filter will have a orange rubber inside the filter housing. So far I see fakes, all are black in colour.

If you really want original filter, try to get them at Hingan Jalan Pudu.
Thrust
post Jul 6 2020, 11:09 AM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(delsoo @ Jul 6 2020, 09:44 AM)
they gt onlne shop ? any reliable online shop to get genuine honda parts ? there are many types of oil filter ranging from rm7 to rm30 online, dunno which to buy, so confusing  icon_question.gif
*
No online shop bro. Have to go there to buy. You can visit the below authorised stockist nearest to you.

Honda Authorized Stockist

1) Jyunsei Auto Parts Sdn Bhd
27-9, Jalan Perhentian Sentul,
51100 Kuala Lumpur.
Tel: 03-4042 7882
Note: This shop belongs to Viperleed's uncle

2) Kean Tat Auto Parts Sdn Bhd
Shifted <Add will update by Tham>
Tel: 03- 62585066 / 5166

3) Hingan Auto Parts Sdn Bhd
44, Jalan Sungai Besi,
57100 Kuala Lumpur.
Tel: 03-9222 8868

4) Tiong Nam Spareparts Sdn Bhd
63, Jalan Segambut Pusat,
Segambut,
51200 Kuala Lumpur
Tel: 03-6258 2762
Website: http://www.spareparts.com.my/tiongnam/

5) Capital Genuine Parts Sdn Bhd
755, Batu 4 1/2, Jalan Ipoh, KL.
Tel: 03-6252 0093, 03-6252 0679


6) Exceptional Auto Parts Sdn. Bhd
24, Jalan SS14/1,
Subang Jaya 47500
Selangor Darul Ehsan
Tel : 03-5633 1875, 03-5633 2861
Thrust
post Jul 7 2020, 02:43 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(Speedstar1 @ Jul 7 2020, 02:16 PM)
How's the fuel consumption like for you guys these days? Especially city drive? Mine goes as low as 7.5km/ sometimes 😓
*
I drive very conservatively. Averaging about 11.5km\l.

That is purely driving within Klang Valley area (PJ area).
Thrust
post Jul 8 2020, 08:09 AM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(kucingfight @ Jul 8 2020, 12:18 AM)
planning to change my absorber soon (from sachs) to Proride - heavy duty .
when full load + baggage, car is really low and scraps the bumps everywhere
car has nyuk nyuk nyuk sound when going over bumps..not sure where it comes from
car is 7 yrs old

besides the listed items above, how to know if need to change lower arm & stabilizer link?
*
When there's a visual crack on the lower arm and stabilizer link. You can see the cracks.

Normally if lower arm koyak, you can't get the alignment straight.

This post has been edited by Thrust: Jul 8 2020, 08:31 AM
Thrust
post Jul 10 2020, 06:50 AM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(pikafaded @ Jul 10 2020, 12:26 AM)
Hi, just wanted to ask about the tyre pressure for CC6. I heard some people saying that the tyre pressure has to be lowered? I am currently following the pressure guide where 220kPa front 210kPa rear
*
220 / 210 kpa is fine as per the recommendation.

You should listen to the manufacturer instead of some people.
Thrust
post Jul 11 2020, 10:21 AM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


Would like to check with you guys whether any of you suffers slow or minimal coolant loss after a few months period? (say like 100 ml over the course of 3 months)?
Thrust
post Jul 11 2020, 05:21 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


Mine also got minimal coolant loss without visible leaks. I suppose it should be fine gua?


Thrust
post Jul 11 2020, 09:39 PM

Power To The People!!!
*******
Senior Member
3,761 posts

Joined: Oct 2005


QUOTE(cempedaklife @ Jul 11 2020, 09:07 PM)
I dunno bro. But considering outside workshop ada check and pandai pandai add, i think its normal. Lol.

By the way, that day check all my service receipts from official sc all those years ago. Maybe not useful for anyway one.

I just realize SC helped to change fuel filter towards the end of my 3 years. Probably around 50k km then. Didn't realize it and go ahead and change again when mine is around 110k km as per recommendation from here. Could have delayed it. Haha.
*
Talking about fuel filter, i think no harm changing it every 60k.

Mine was changed once at 40k and then subsequently at 100k.

48 Pages « < 22 23 24 25 26 > » Top
 

Change to:
| Lo-Fi Version
0.1219sec    1.04    7 queries    GZIP Disabled
Time is now: 17th December 2025 - 08:42 PM