If you wan DIY, perhaps can get it around Pudu or Pandan Indah ~

Yes Sech 60

Depends, if the shop willing to give you summon warranty then is good =)

Where did you get this reading? This analysis more applicable to commercial/residential windows.
Most of the car windows fall on 1st category.

This post has been edited by lonely143: Mar 10 2014, 10:14 PM

Wont, the VLT is around 65-55%

1. How is the quality in short & long term?
The quality is for short term only
2. How does it reflect on window? Is it dark or easy to see-thru?
It will not so dark, but still able to see-thru
3. Is it JPJ compliant if I apply LLUmar silver for all windows?
Based on the specification, it only comply if the film is install at side and rear.

Definitely will affect the workmanship

VKool + Solar Gard 4Mil
This combination only give you average performance.
If you have budget, upgrade it to full VKool Safety film.

Umm I dont understand what you mean. By the way, you can consult your SA

1. Is there any tint you'd recommend but comply with JPJ requirement?
- This is very hard, the JPJ rules is >70% VLT for FWS, >50% all side and BWS

2. Is dark tint better than silver tint based on my requirement to block the view from outside?
- No, reflective tint with VLT 50% might be able to achieve your requirement but honestly ppl still can see you thru
but at least you can create some mirror effect on certain angle. If you want those totally block ppl view from outside, you need at least
20-30% VLT film with high reflectance but that does not comply with regulations

3. Do you have any brand you'd recommend?
- You can try out VKool + Solar Gard Safety Series

4. And my car is considered not a new car, will there be any difficulties in tinting?!
- This not an issue as we will remove and clean your windows before put up brand new tint.

Ummm sounds fishy here.

There are 2 consequences I think

1. They try to cheat you !
2. Perhaps the Ceramic 50 4Mil is out of stock, thats why they put 2 layer.

Another question, did they give product warranty and summon warranty?

There is no summon warranty, is verbally promise because JPJ never approved any tint

Not recommended, it will cause blur vision.
Remember the glass is laminated.

Follow the simple step to identify reflective film.

1. It always dark, silver or stainless steel color.
2. Take a look at the film, if you can see your face. Congratulation you have found it !

When you send it to tinting, they will do it for you ah ~~

Yea agree ~ 3M house brand la ~

Its not about brand. The purpose of the video is to highlight the consumer about the dye film.

Do you mind to tell us what car using Huper vs car that using Winguard?

Based on spec from both product, Huper Sech 60 performance is on par with Winguard Royale
but the Ceramic 50 4mil heat performance is lower than it. I guess that why you feel the heat.

What model is that? The original glass already so dark... In my opinion, if you want to pass the JPJ test next time.. Your front film VLT have to be 85% and side 70%

Your case is common. This good case studies too.