QUOTE(alpha33 @ Dec 18 2013, 09:14 PM)
aku use crowbar jer...
takyah susah susah pakai screw.
QUOTE(Azuma-kun @ Dec 18 2013, 09:34 PM)
Aku cabut pintu terus. Tak yah pening2 pikir nak bukak door trim. No pintu, no door trim
ni orang...
QUOTE(Kanuki @ Dec 18 2013, 10:18 PM)
Today... I tried to remove the gear boot but couldn't take it out
completely. I got stuck at the hand break leather cover. Luckily
I still managed to get enough space to put my hand inside
and tried to tighten up the connector a little bit. Too bad that
I didn't have enough clear space to reseat the connector properly.
I couldn't remove the pillar trim because of I didn't have the
proper screw driver to loosen up the bottom trim.
So for the SRS Error LED is gone for after I've done that.
Let monitor for it for a week. If the problem come back
then I think I will need to try to remove the gear boot
completely and reseat the connector properly.
Once again... Thank you so much for your help. Really much
appreciated. I wouldn't be able to do it without your help.
One more thing to add,
the cigarette socket,
you need to slot in your hand inside the center console unplug two cables that connected to it,
quite challenging if you are first time.
Actually you can test your seatbelt pre-tensioner function or not mah,
buckle up and drive with decent speed, then sudden brake,
(make sure no car behind you)
with no let go your brake pedal your seatbelt should "tighten" up instantaneously and avoid your body jerking forward.
This post has been edited by ahpaul82: Dec 18 2013, 11:03 PM