We probably won't down to JB due to time constrain. But if u willing drive 2 hours up North, may be we can catch up near Tangkak or somewhere nearby

I'm eyeing like end of July, or early August. Will have to reconfirm again.

If you go fix outside, get the mudguard fella change a new rubber for your passenger door. Good quality from Plotong(trust me, they got the bestest rubber) rear passenger door should be RM40. If go get rubbish should be RM25. Get the mudguard guy fix it on your behalf, after that let them adjust your door hook so it close tight with little effort.

Rear drum brake suggest to open up the hub and blow away brake dust every service. This will prolong the brake cylinder. Pardon the design of our hub, it's enclosure design, hence dust doesn't get out at all, would be trapped INSIDE the brake hub. Over long period, the dust will start building up on the brake cylinder pump and jammed the shaft. When the shaft is not efficient anymore, after you hit the brake pedal, but the cylinder will gradually release as the drum roll pass. Hence when the brake shoe rejecting over and over again, you'll hear the knocking sound the from brake shoe hitting the hub base.

After clean drum brake, always get your magician to regrease the wheel bearing, can prolong the bearing life meanwhile keep the bearings lubricated. Less friction means better in FC. Be it placebo or not, but I like to keep the car in optimum performance/ecnomy

This post has been edited by davidke20: Jul 8 2013, 11:37 PM

Me too Boring of BM honk jor

Call Allianz EWP division to confirm

Oh

Bank will issue cover note according to loan amount regardless of your spec.

I insured my car as BLM N Line, but if kena accident claim time, my car suddenly converted to H Line (I know BLM only got M line)

This post has been edited by davidke20: Jul 9 2013, 07:36 PM

Engine oil talk

Fubar20 TitanRev

I know you guys have your idea on how motor oil benefit the car. Here's my piece to chip in despite I'm not particular and have very little knowledge on engine oil. I've been driving several years, changing engine oil almost every 3 month, sometimes twice when I hit 3000 miles too soon. Due to cost of motor oil start increasing, I found I'm paying more and more on the vehicle maintenance, so I start to dig more info from magician. Helping to overhaul engine benefit the most in terms of technical knowledge and understand how motor oil affect engine performance.

Rule of thumb, buy engine oil with API stamp. Here's a link, please download and print a copy put inside your car. The next time when you wanna purchase motor oil, make sure you read the ratings whether its SN/SJ/SM/SL.

http://www.api.org/certifications/engineoi...2010_120210.pdf

With API ratings, you'll get an idea how these engine oil comply to your power unit. Your motor vehicle rely on the chemical inside the motor oil to survive friction. The viscosity only meant very little, but the API rating worth the most. Hence, when you use cap ayam motor oil, despite they put down 10w60, that does not mean the molecule can stand your car's 10.1:1 compressrion ratio with 400'c extreme heat during the ignition. Be it 10w100, it doesn't make any difference when the oil being channeled into the combustion chamber.

However, don't take my word as a whole. The viscosity does yield it's importance. For instance 10w40 multi-visco simply means 10 comes suffixed with W, meaning WINTER(not weight/watt as claim by others) for cold start viscosity. The 40 after W is hot viscosity. The front winter denote has lower figure, meaning the liquid has lower "beku" point. Sorry ran out of vocabulary. The hot visco higher denote a higher boiling point. You don't want oil to boil, just like your mommy cooking in the kitchen.

I've seen many horrible incident's while helping customer to do engine overhauling. Unsurprisingly, most of them having problem with their motor, they tend to miss their oil change quite often, sometimes up to few years did not change oil at all. Before dismantle an engine for overhaul, as I loosen the oil sum nut, I'll be extremely careful to not let oil spill on my hand. These burnt oil can irritate my skin and cause allergy. However, most of the time after the sum nut being pull off, there aren't any oil drip out. Even if there is, very little and very thick. Got once we unable to drain anything out from the sum, because those oil already turned grease. Can imagine how not to jammed the pistons?





Thinner hot viscosity oil does not mean you have less chance building up sludge, infact it's the opposite. Otften I ask magician why not fully synthetic as those expansive oil usually added cleaning agent, can last up to 6000 miles. The answer is simple, recycle the same oil in the engine can only make those oil turn into sludge. Debris and dirt to have more opportunity to form a bigger object between molecule, hence sludge start to build.



I used to worship 76 racing motor oil 10w40 for NASCAR, until my car start to emit white smoke and finally ended up with a full overhaul. Again, I did the overhaul by myself with assistance of magician to find that not much sludge built up, but the piston ring has been fully grounded off. Lesson learned as magician explain, usually racing motor oil does meant for racing. Those oil wouldn't last more than few thousand miles as it degrade faster than normal oil from the market. The dangerous part is, motor oil should form a film of coating on engine parts, but the degraded oil does not. It will be fully drained to the sump. Believe it or not, your engine life were shorten each time you crank start it, not when you taking it to the redline(provided the redline figure is properly balanced on your crankcase).

From the above little knowledge I gained from magician, I've been practicing frequent oil change. For your information, VTEC oil is rated SAE10w30 have no problem running at 8krpm.

RM850 oni, ranjiao chibjing locked down ECU

Front kenot do, you'll need thick spring mounting bush

Rear, RM120 oni. If you interested, name a price and take mine coz I no longer go site anymore

Rear axle is fixed, dun hab alignment. The time you figured rear side eat tayar, you'll be hailut.com.my liao.

Don't be surprise, catcon alone costs RM1.6k, and the ECU is only like 1/2 the price nia At this point you prolly know why in the hell despite the Campor engine guding, yet it response worsen than a datsun 120y

Already third time hailut.com.my!!!!

This post has been edited by davidke20: Jul 9 2013, 10:29 PM

Come tail me

Either quickly overtake me. If cannot, don't tailgate me or try to give me pressure

Luckily lar, got Teoh Brothers to fix it at fraction of cost

I was asking if you dare to tail me You wouldn't know how it turned out

restoran plis

Hmm.... That's our next destination

Finding Ricer Wanabe Southern Getaway





Also not forgetting C2KBAS2005




Reason for the trip: Save postage cost, safety for goods purchased, good food in Melacca
Optimum participants/vehicle : 4
Maximum participants/vehicle: 5
Toll & Petrol: Add up and average basis
Food expanses: Americano - self eat self pay. If on sharing dish, please be considerate and fork out your share.
Drinks: Strictly americano to avoid future argument. Later say I bought you Starbucks you now buy me teh tarik not fair then hailut
Car: The stocker the better, don't want bling bling later on the way back KL kena tahan
Speed: Strictly according road limit
Formation: If more than 5 cars, appointed marshal car will be leading infront/back. No 1 shall overtake marshals. In the event of break down, marshal to stay behind with breakdown car.

Participant list:

1. Vinz lee
2. davidke20
3. Mahihi
4. r3apers
5. Garybenjamin
6. kenjilew
7. V12kompressor
8. jsnkok

Postage update for Ular Oren Bulk Effort #3 wave
Improve Campor IAFM throttle lag


Ground cable made of 300amps copper core welding cable

More detail and video in spoiler


Oustation participants

1. drfeelgood PAID EM810999858MY
   
2. zeone PAID EM810999844MY
   
3. motherker PAID EM810997137MY

EM810997137MY - 09 Jul 2013 20:35:30 Consignment dispatch out from origin station
EM810999844MY - 09 Jul 2013 22:16:28 Consignment dispatch out from Transit Office PPL KUALA LUMPUR
EM810999858MY - 09 Jul 2013 21:40:58 Consignment dispatch out from Transit Office PPL KUALA LUMPUR

Installation guide emailed.

This post has been edited by davidke20: Jul 10 2013, 07:18 AM

Tak check email ke, Navin?

Someone's ignition coil bolt over tightened, wrecked 2 spanner wrench & 1 spocket also unable to unscrew that bolt. That someone now ended up with 3/4 of the performance So, the someone before leave very unsatisfied saying he wanna go find his exhaust friend to open up that bolt, die die also wanna have all the performance by today wor. So, later you guys www.slowlywaithimgoattendbirthdayttlar.com.my