the parts to make the Sword Strike shoulder armour fit nicely are provided in MG Strike RM

these 2 rings provided


the part circled in red


This post has been edited by General_Nic: Aug 31 2013, 02:14 AM

If used that ring, it cannot fit at all. Need to do some trimming to the sword shoulder pack.

using GaoGao's? i assume that is due to bootleg molding, if B brand should be fine

just trim without mercy that plastic... hahahaha

It's TT, if B, should have no prob. And rm version also a bit taller inm (from review).

Just trimmed a bit only... Now fitted nicely. I also glued some parts from the bootleg because they kept falling off when posing.

TT = GaoGao

I thought TT= hongli

TT Hongli is full name

Oic, later will do panel lining and touch up. Not planning to put decal, at least for now.

daban titus

This post has been edited by mooncake81: Aug 31 2013, 04:47 PM

Spam some more noobies work before putting it inside display cabinet.


This post has been edited by sphiroth: Aug 31 2013, 07:06 PM

May i ask what you used for panel lining?

Gundam marker for panel lining (extra fine). Used gray colored marker for white parts, and black for the rest.

woo..very quiet today.
well, for assemble the wing pack dragoon system, pls loosen the hole as posible bcos it was tight & become more tight after u snap fit the black peices. It was very hard to pull out once u snap it.



testing with purple color, but look soft & less contrast.

you repaint the whole inner frame already ? white + purple?? LOL

no....i just paint the shoe only. the inner frame still in gold color.

Finally, some pg sf. Nice.

well, u can get it also with affordable price.

BUt not playaful & it huge, good for display.

^ Hopefully can get mine this week.

Cancelled my po because no place to display, changed to perfect strike project.