Yep, looking for the smallest OD that is not koolance fittings(expensive )
Some users feedback that if use BitsPower 1/2-3/4 on the 380i, theres inly like 1mm gap between 2 fittings as the I/O of the block is somewhat near =__=
BP is like 26mm diameter while enzo is like 25mm.

Oh well, will drop Cyntrix a pm then

I havent bought any tubes yet, but i plan to get the PRimochill from APES amd since the D5 pump has default ID 1/2 barb, i'll stick to 1/2 ID.
As for OD, i think 3/4 is the common used ones.
Lets see which size APES has for the tubes, and i'll get the comp fittings accordingly
. . . .
I still havent decide what res to use I hope APES has the Bitspower Tank Z-80

apparently APES do not have z-80. they have z-150 but thats too long.
im also considering Swiftech MCres and xspc D5 tank, but i i like cylinder look more

you have z-80?  relevant to my interest.
hows the turbulence(cyclone) inside it? i think D5-at speed2 should be no problem.

*also am asking niclas if he got good offerings for black koolance fittings

cuz u went shopping at KLAV? 

This route for my WC loop should be fine right?

ResPump --> Rad --> CPU block --> Rad --> GPU block --> Back to ResPump.

I agree. As mine previously was blocks to res,it cause the res to have some condensation.

Damn. Reading up on this thread and now my hands are itchy again. Dying to start my next ITX build. $$ issues suck!

Damn. I really like Asrock's Z87 line of MoBo. I really have to build one.

BTW, a little off topic. Would a single GTX660 do 1440p gaming? Or do I really need an upgrade?

changing to what? 

Wow, and those were for Rebirth project? What a journey!

Powered by single 3 pin?

nice...much better looking than mine 

oh then its no good haha...what I have in mind is to connect all 5fans to the pcb & then connect the pcb straight to fan controller. This will allow me to control all the fans for each radiators plus it will still be able to report the RPM to the fan controller. haha

Careful not to burn your controller during startup.  

What do you mean? Got link to read up on this new pcb? 

Haha, I was saying that to the guy behind you. , I forgot, you guys so crazy to get wicked sick fan controller.

Anyways since everyone is posting pictars of their rig maybe I should post mine too. Well sort of la Like what I did with the res? Had an idea in mind & tried it out, results were quite impressive otherwise res will be quite dark & dull.

I'm using OEM Cooler Master fan controller. Cheap skate right?

You're not using aquacomputer's controller?
OSEM!! I really like that ambient plate! "not focusing on that awesome too rad. "

I wanted to do that but not possible, because of the rubber grommets. No place to drill proper holes for the holder. There is a small section on top but the rad can't raise too high because I have sp120 fans on the radiator & 90deg fitting on top of the res. If rad is not in push pull config then its possible.


Actually yeah, will put led strip & 3mm leds for the waterblock so wont be so dark, just waiting for my led strip to arrive & 3mm leds. Ram on the other hand still deciding to go with which haha